Water and salt recovery from shale gas produced water by vacuum membrane distillation followed by crystallization.

A vacuum membrane distillation (VMD) followed by crystallization (VMD-C) was developed for the recovery of water and salts from shale gas produced water (SGPW). Before VMD, the pretreatment of SGPW with Fenton oxidation-flocculation is applied, with the chemical oxygen demand (COD) concentration reduction of 75% and the total removal of the total suspended solids (TSS), Ca2+, and Mg2+ in SGPW. The pretreatment of SGPW mitigated the membrane fouling in the VMD and effectively prevented the reduction of membrane flux over time. The average flux of the PTFE membrane reached 12.1 kg m-2 h-1 during the separation of the pretreated SGPW at a feed flux of 40 L h-1 and a feed temperature of 40 °C. The rejection rate of the membrane to TDS in SGPW was over 99%. Fresh water with a conductivity of below 20 µs cm-1 was produced by VMD-C. The salts concentrated upstream of the membrane were recovered by a stirring crystallization process. The VMD-C system resulted in a 61% cost savings compared to conventional SGPW treatment.

Bioethanol production in vacuum membrane distillation bioreactor by permeate fractional condensation and mechanical vapor compression with polytetrafluoroethylene (PTFE) membrane.

A vacuum membrane distillation bioreactor (VMDBR) by permeate fractional condensation and mechanical vapor compression with PTFE membrane was developed for bioethanol production. Cell concentration of 11.5 g/L, glucose consumption rate of 5.2 g/L/h and ethanol productivity of 2.3 g/L/h could be obtained with fermentation continues lasting for 140 h. Membrane flux of over 10 kg/m2/h could be obtained for model solution separation. Higher temperature and flow rate could promote membrane separation. Membrane flux could be reduced to about 2000 g/m2/h with fermentation proceeding owing to the deposited cell on membrane surface. The membrane separation performance could be resumed by water rinse. High ethanol concentration of 421 g/L could be obtained by permeate fractional condensation with the process separation factor increased to 19.2. Energy of only 14 MJ/kg was required in VMDBR and the energy consumption would be reduced further if the compressed vapor could be used to heat the feed.