A decellularized porcine pulmonary valved conduit embedded with gelatin.

To prepare a tissue-engineered pulmonary valved conduit (PVC) with good tensile strength and biocompatibility. Sixty adult porcine PVCs were used to determine the optimal decellularization time. Five juvenile porcine decellularized PVCs and five juvenile porcine crosslinked PVCs were subsequently prepared according to the optimized decellularization and crosslinking methods. All PVCs were implanted into juvenile sheep for 8 months and then were harvested for staining. With a low concentration of detergent (0.25% Triton X-100+0.25% sodium deoxycholate), the decellularization effect on porcine PVCs was complete by 24 hours, and there was minimal damage to the matrix. Gelatin embedding and 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide (EDC) crosslinking improved the biomechanical properties of decellularized PVCs and reduced their immunogenicity. After implantation, the diameter and thickness of the PVCs in the decellularized and crosslinked groups increased significantly. In both groups, the conduits were unobstructed, with soft and smooth inner walls and without thrombosis, ulceration or neoplasia. The valves slightly degenerated with mild to moderate regurgitation. CD31-positive endothelial cells were visible on the inner surface of the conduits and valves. Scattered smooth muscle actin-positive cells were found in the middle layer of the conduit. The percentage of CD4- and CD68-positive cells and the calcium content were highest in decellularized porcine PVCs and lowest in ovine PVCs. The percentage of the matrix that was laminin-positive in decellularized and crosslinked porcine PVCs was lower than it was in ovine PVCs. Gelatin-embedded and EDC-crosslinked porcine PVCs can be "hosted" in sheep, with good biocompatibility, growth potential, and reduced calcification.

The Effects of Hydrophobicity and Textural Properties on Hexamethyldisiloxane Adsorption in Reduced Graphene Oxide Aerogels.

To expand the applications of graphene-based materials to biogas purification, a series of reduced graphene oxide aerogels (rGOAs) were prepared from industrial grade graphene oxide using a simple hydrothermal method. The influences of the hydrothermal preparation temperature on the textural properties, hydrophobicity and physisorption behavior of the rGOAs were investigated using a range of physical and spectroscopic techniques. The results showed that the rGOAs had a macro-porous three-dimensional network structure. Raising the hydrothermal treatment temperature reduced the number of oxygen-containing groups, whereas the specific surface area (SBET), micropore volume (Vmicro) and water contact angle values of the rGOAs all increased. The dynamic adsorption properties of the rGOAs towards hexamethyldisiloxane (L2) increased with increasing hydrothermal treatment temperature and the breakthrough adsorption capacity showed a significant linear association with SBET, Vmicro and contact angle. There was a significant negative association between the breakthrough time and inlet concentration of L2, and the relationship could be reliably predicted with a simple empirical formula. L2 adsorption also increased with decreasing bed temperature. Saturated rGOAs were readily regenerated by a brief heat-treatment at 100 °C. This study has demonstrated the potential of novel rGOA for applications using adsorbents to remove siloxanes from biogas.

Survival, complications and functional outcomes of cemented megaprostheses for high-grade osteosarcoma around the knee.

PURPOSE: We initiated a retrospective study on the long-term survival of cemented endoprostheses for bone tumours around the knee to answer the following questions: (1) What was the survival of these patients? (2) What was the overall survival of cemented prostheses around the knee? (3) What types of failures were observed in these reconstructions? (4) Did the survival and complications vary according to the site of the implant? (5) What was the functional result after cemented prosthesis replacement around the knee? METHODS: From January 2006 to December 2013, 108 consecutive patients with an average age of 25 years, who had mature bone development as evidenced by imaging examinations, underwent 108 cemented endoprosthetic knee replacements for osteosarcoma resection. All patients received neoadjuvant chemotherapy using a multi-drug protocol consisting of high dose methotrexate (HDMTX), doxorubicin (ADM), cisplatin (DDP) and high dose ifosfamide (HDIFO). When extensor mechanism reconstruction was required, we ran nonabsorbable sutures through designated holes in the tibial component to fix detached hamstrings and the remaining ligaments in an imbricated fashion as well as reinforced the reconstruction with a medial gastrocnemius flap. Seventy-two (72/108, 66.7%) lesions were located in the distal femur and 36 (36/108, 33.3%) lesions at the proximal tibias. Nineteen patients were staged as IIA and 89 as IIB according to the Enneking staging system. The average follow-up was 53.3 months (range 12-125 months), with a minimum oncological follow-up of one year. Survival, prosthetic failure, complications and functional outcomes were recorded and reassessed at every visit after the primary operation. RESULTS: At the final follow-up, the oncologic results showed that 33 patients died from metastases, and local recurrence occurred in ten patients. The estimated overall five-year and eight-year survival rates were 71% (95% CI: 62.4-79.65%) and 67.2% (95% CI: 58-76.4%), respectively. In this study, a total of 51 complications occurred in 45 patients, and at the end of follow-up, 59 patients had prostheses in situ. The estimated overall five-year and eight-year implant survival rates were 77.7% (95% CI: 67.9-87.5%) and 54.5% (95% CI: 31.4-77.6%), respectively, when patients who died with their original prostheses were censored. In total, 21 (21/108, 19.4%) implants failed, five due to infections (5/21), eight due to aseptic loosening (8/21), four due to local recurrence (4/21), three due to structural failure (3/21) and one due to soft tissue failure (1/21). The average Musculoskeletal Tumor Society Score (MSTS) at the most recent follow-up was 22.9 (9-30) points on a 30-point scale, which indicated an excellent or good functional outcome. Analysis of the results based on implant site revealed a slight difference of the estimated five-year prosthesis survival between implants located in the distal femur and those located in the proximal tibia [86.1% (95% CI: 75.5-97%) versus 66.9% (95% CI: 49.8-83.9%); P = 0.09]. However, the functional outcomes and complication rates of prostheses located in the distal femur were both better than those located in the proximal tibia. CONCLUSIONS: With effective management strategies for complications, cemented endoprosthetic reconstruction of the proximal tibia and distal femur using an extensor mechanism reconstruction technique provides a reliable method of reconstruction following tumour resection around the knee. Level of Evidence Level IV, therapeutic study.

In vitro and in vivo evaluation of osteogenesis and antibacterial activity of MgGa alloys.

MgGa alloys are considered highly potential biodegradable materials, owing to its good mechanical properties and appropriate corrosion resistance. However, it is still far from application due to the lack of biological evaluation. In the present study, biocompatibility, osteogenesis and antibacterial activity of extruded Mg-xGa (x = 1 and 5 wt%) alloys were investigated by in vitro cell culture experiments and in vivo implantation. The cell adhesion and proliferation of osteoblast precursor cells (MC3T3-E1) showed the excellent cytocompatibility of Mg-1Ga and poor cytocompatibility of Mg-5Ga. The osteogenic activity was evaluated and revealed that Ga3+ in the Mg-1Ga extract had the ability to enhance osteogenic differentiation through the facilitation of its early stages. In vivo studies in a rat femoral condyle model revealed that both Mg-1Ga and Mg-5Ga significantly promoted new bone formation without causing any adverse effects. Mg-5Ga exhibited a much higher corrosion rate in vivo than Mg-1Ga. Its osteogenic activity was better due to the rapid release of Mg2+ and Ga3+, but this caused premature structural integrity loss. Mg-1Ga and Mg-5Ga released Ga3+ to inhibit E. coli and S. aureus, with antibacterial rate increasing with Ga content. Our studies demonstrate that Mg-Ga alloys have the potential to be used as osteogenic and antibacterial implant materials. STATEMENT OF SIGNIFICANCE: This study evaluates the biocompatibility, osteogenesis, and antibacterial activity of Mg-Ga alloys, which are promising biodegradable materials for medical applications. The study finds that Mg-1Ga exhibits excellent cytocompatibility and promotes osteogenic differentiation, facilitating the early stages of osteoblast precursor cell development. In vivo studies in a rat femoral condyle model reveal that Mg-1Ga and Mg-5Ga significantly promote new bone formation without causing any adverse effects. The antibacterial activity of both alloys is evaluated against E. coli and S. aureus, with the inhibition rate increasing with Ga content. These findings suggest that Mg-Ga alloys have the potential to serve as osteogenic and antibacterial implant materials, providing significant insights into the development of novel biomedical implants.

Novel portable photoelectrochemical sensor based on CdS/Au/TiO2 nanotube arrays for sensitive, non-invasive, and instantaneous uric acid detection in saliva.

Uric acid (UA) monitoring is the most effective method for diagnosis and treatment of gout, hyperuricemia, hypertension, and other diseases. However, challenges remain regarding detection efficiency and rapid on-site detection. Here, we first synthesized a CdS/Au/TiO2-NTAs Z-scheme heterojunction material using a titanium dioxide nanotube array (TiO2-NTAs) as the substrate and modified with gold nanoparticles (Au) and cadmium sulfide particles (CdS). This material achieves bandgap alignment to generate a large number of electron-hole pairs under illumination. Then, using CdS/Au/TiO2-NTAs as the working electrode and molecularly imprinted polymers (MIP) as the recognition unit, we constructed a portable photoelectrochemical (PEC) sensor for non-invasive instant detection of UA concentration in human saliva, which has unique advantages in the field of high-sensitivity PEC instant detection. The portable MIP-PEC sensor achieves a linear range of 0.01-50 µM and a detection limit as low as 5.07 nM (S/N = 3). At the same time, the portable MIP-PEC sensor exhibits excellent sensitivity, specificity as well as stability, and shows no statistically significant difference compared to traditional high-performance liquid chromatography (HPLC) in practical sample detection. Compared to traditional PEC modes, this work demonstrates a novel and universal method for high-sensitivity instant detection in the field of PEC.

High-Performance Graphene Flexible Sensors for Pulse Monitoring and Human-Machine Interaction.

Flexible sensors are of great interest due to their potential applications in human physiological signal monitoring, wearable devices, and healthcare. However, sensor devices employed for cardiovascular testing are normally bulky and expensive, which hamper wearability and point-of-care use. Herein, we report a simple method for preparing multifunctional flexible sensors using hydrazine hydrate (N2H4·H2O) as the reducing agent, graphene as the active material, and polyethylene (PE) tape as the encapsulation material. The flexible sensor produced with this method has a low detection limit of 100 mg, a fast response and recovery time of 40 and 20 ms, and shows no performance degradation even after up to 30,000 motion cycles. The sensors we have developed are capable of monitoring the pulse with relative accuracy, which presents an opportunity to replace bulky devices and normalize cardiovascular testing in the future. In order to further broaden the application field, the sensor is installed as a sensor array to recognize objects of different weights and shapes, showing that the sensor has excellent application potential in wearable artificial intelligence.

Sensitive and selective determining ascorbic acid and activity of alkaline phosphatase based on electrochemiluminescence of dual-stabilizers-capped CdSe quantum dots in carbon nanotube-nafion composite.

Sensitive and selective determining bio-related molecule and enzyme play an important role in designing novel procedure for biological sensing and clinical diagnosis. Herein, we found that dual-stabilizers-capped CdSe quantum dots (QDs) in composite film of multi-walled carbon nanotubes (CNTs) and Nafion, displaying eye-visible monochromatic electrochemiluminescence (ECL) with fwhm of 37nm, which offers promising ECL signal for detecting ascorbic acid (AA) as well as the activity of alkaline phosphatase (ALP) in biological samples. It was also shown that the dual-stabilizers-capped CdSe QDs can preserve their highly passivated surface states with prolonged lifetime of excited states in Nafion mixtures, and facilitate electron-transfer ability of Nafion film along with CNTs. Compared with the QDs/GCE, the ECL intensity is enhanced 1.8 times and triggering potential shifted to lower energy by 0.12V on the CdSe-CNTs-Nafion/GCE. The ECL quenching degree increases with increasing concentration of AA in the range of 0.01-30nM with a limit of detection (LOD) of 5pM. The activity of ALP was determined indirectly according to the concentration of AA, generated in the hydrolysis reaction of l-ascorbic acid 2-phosphate sesquimagnesium (AA-P) in the presence of ALP as a catalyst, with an LOD of 1µU/L. The proposed strategy is favorable for developing simple ECL sensor or device with high sensitivity, spectral resolution and less electrochemical interference.

Genome Sequence of the Edible Cultivated Mushroom Lentinula edodes (Shiitake) Reveals Insights into Lignocellulose Degradation.

Lentinula edodes, one of the most popular, edible mushroom species with a high content of proteins and polysaccharides as well as unique aroma, is widely cultivated in many Asian countries, especially in China, Japan and Korea. As a white rot fungus with lignocellulose degradation ability, L. edodes has the potential for application in the utilization of agriculture straw resources. Here, we report its 41.8-Mb genome, encoding 14,889 predicted genes. Through a phylogenetic analysis with model species of fungi, the evolutionary divergence time of L. edodes and Gymnopus luxurians was estimated to be 39 MYA. The carbohydrate-active enzyme genes in L. edodes were compared with those of the other 25 fungal species, and 101 lignocellulolytic enzymes were identified in L. edodes, similar to other white rot fungi. Transcriptome analysis showed that the expression of genes encoding two cellulases and 16 transcription factor was up-regulated when mycelia were cultivated for 120 minutes in cellulose medium versus glucose medium. Our results will foster a better understanding of the molecular mechanism of lignocellulose degradation and provide the basis for partial replacement of wood sawdust with agricultural wastes in L. edodes cultivation.