Interaction of choline salts with artificial biological membranes: DSC studies elucidating cellular interactions.

To better understand the relationship between the relative cytotoxicity of diluted ionic liquids and their specific interaction with biological membranes, the thermotropic behavior of model lipid membrane systems formulated in a series of choline based organic salts was investigated. Unilamellar vesicles prepared from dipalmitoylphosphatidylcholine were exposed to a series of choline phosphate salts at a concentration of 10mM at pH7.40, and the gel to liquid-crystalline state transition was examined using differential scanning calorimetry. The choline salts that were observed to have a low relative toxicity in previous studies induced minimal changes in the lipid phase transition behavior of these model membranes. In contrast, the salts choline bis(2,4,4-trimethylpentyl)phosphinate and choline bis(2-ethylhexyl)phosphate, both of which were observed to have high relative toxicity, caused distinct disruptions in the lipid phase transition behavior, consistent with penetration of the salts into the acyl chains of the phospholipids. choline bis(2,4,4-trimethylpentyl)phosphinate reduced the Tm and enthalpy of the main transition of dipalmitoylphosphatidylcholine while choline bis(2-ethylhexyl)phosphate induced the equilibration of alternate phases.

Probing the specific ion effects of biocompatible hydrated choline ionic liquids on lactate oxidase biofunctionality in sensor applications.

This paper presents an extended study on the ion effects of a series of biocompatible hydrated choline based ionic liquids (ILs) on lactate oxidase (LOx), an important enzyme in biosensing technology for the in vitro detection of lactic acid. Secondary structural analysis revealed changes in the protein conformation in hydrated ILs, while thermal unfolding/aggregation dynamics showed different profiles in the presence or absence of ILs. Moreover, LOx thermally denaturised at 90 °C showed residual activity in the presence of chloride and dihydrogen phosphate anions. Kinetic and lifetime studies were also performed, providing a better understanding of the ion effects of ILs on the biocatalytic activity of the enzyme.

A Survey of Catalytic Materials for Ammonia Electrooxidation to Nitrite and Nitrate.

Studies of the ammonia oxidation reaction (AOR) for the synthesis of nitrite and nitrate (NO2/3 - ) have been limited to a small number of catalytic materials, majorly Pt based. As the demand for nitrate-based products such as fertilisers continues to grow, exploration of alternative catalysts is needed. Herein, 19 metals immobilised as particles on carbon fibre electrodes were tested for their catalytic activity for the ammonia electrooxidation to NO2/3 - under alkaline conditions (0.1 m KOH). Nickel-based electrodes showed the highest overall NO2/3 - yield with a rate of 5.0±1.0 nmol s-1 cm-2 , to which nitrate contributed 62±8 %. Cu was the only catalyst that enabled formation of nitrate, at a rate of 1.0±0.4 nmol s-1 cm-2 , with undetectable amounts of nitrite produced. Previously unexplored in this context, Fe and Ag also showed promise and provided new insights into the mechanisms of the process. Ag-based electrodes showed strong indications of activity towards NH3 oxidation in electrochemical measurements but produced relatively low NO2/3 - yields, suggesting the formation of alternate oxidation products. NO2/3 - production over Fe-based electrodes required the presence of dissolved O2 and was more efficient than with Ni on longer timescales. These results highlight the complexity of the AOR mechanism and provide a broad set of catalytic activity and nitrate versus nitrite yield data, which might guide future development of a practical process for the distributed sustainable production of nitrates and nitrites at low and medium scales.

Ionic liquids in biomass processing.

Ionic liquids have been studied for their special solvent properties in a wide range of processes, including reactions involving carbohydrates such as cellulose and glucose. Biomass is a widely available and renewable resource that is likely to become an economically viable source of starting materials for chemical and fuel production, especially with the price of petroleum set to increase as supplies are diminished. Biopolymers such as cellulose, hemicellulose and lignin may be converted to useful products, either by direct functionalisation of the polymers or depolymerisation to monomers, followed by microbial or chemical conversion to useful chemicals. Major barriers to the effective conversion of biomass currently include the high crystallinity of cellulose, high reactivity of carbohydrates and lignin, insolubility of cellulose in conventional solvents, as well as heterogeneity in the native lignocellulosic materials and in lignin itself. This combination of factors often results in highly heterogeneous depolymerisation products, which make efficient separation difficult. Thus the extraction, depolymerisation and conversion of biopolymers will require novel reaction systems in order to be both economically attractive and environmentally benign. The solubility of biopolymers in ionic liquids is a major advantage of their use, allowing homogeneous reaction conditions, and this has stimulated a growing research effort in this field. This review examines current research involving the use of ionic liquids in biomass reactions, with perspectives on how it relates to green chemistry, economic viability, and conventional biomass processes.

Self polymerising ionic liquid gel.

A novel self-polymerised ionic liquid (IL) gel was prepared at room temperature (RT), without light or heat or addition of initiator, using a new IL, choline formate (CF), and 2-hydroxyethyl methacrylate (HEMA).

Biocompatible ionic liquid-biopolymer electrolyte-enabled thin and compact magnesium-air batteries.

With the surge of interest in miniaturized implanted medical devices (IMDs), implantable power sources with small dimensions and biocompatibility are in high demand. Implanted battery/supercapacitor devices are commonly packaged within a case that occupies a large volume, making miniaturization difficult. In this study, we demonstrate a polymer electrolyte-enabled biocompatible magnesium-air battery device with a total thickness of approximately 300 µm. It consists of a biocompatible polypyrrole-para(toluene sulfonic acid) cathode and a bioresorbable magnesium alloy anode. The biocompatible electrolyte used is made of choline nitrate (ionic liquid) embedded in a biopolymer, chitosan. This polymer electrolyte is mechanically robust and offers a high ionic conductivity of 8.9 × 10(-3) S cm(-1). The assembled battery delivers a maximum volumetric power density of 3.9 W L(-1), which is sufficient to drive some types of IMDs, such as cardiac pacemakers or biomonitoring systems. This miniaturized, biocompatible magnesium-air battery may pave the way to a future generation of implantable power sources.

Dual active ionic liquids and organic salts for inhibition of microbially influenced corrosion.

We describe a series of novel compounds designed to combat the bacterial growth that leads to microbially induced corrosion on steel in the marine environment. A synergistic effect of the ionic components in these dual active organic salts is demonstrated.

Enhanced membrane transport of pharmaceutically active protic ionic liquids.

We show that pharmaceutically active protic ionic liquids can be designed to rapidly transport through model membranes as neutral hydrogen bonded clusters.

Potentiostatic control of ionic liquid surface film formation on ZE41 magnesium alloy.

The generation of potentially corrosion-resistant films on light metal alloys of magnesium have been investigated. Magnesium alloy, ZE41 [Mg-Zn-Rare Earth (RE)-Zr, nominal composition approximately 4 wt % Zn, approximately 1.7 wt % RE (Ce), approximately 0.6 wt % Zr, remaining balance, Mg], was exposed under potentiostatic control to the ionic liquid trihexyl(tetradecyl)phosphonium diphenylphosphate, denoted [P(6,6,6,14)][DPP]. During exposure to this IL, a bias potential, shifted from open circuit, was applied to the ZE41 surface. Electrochemical impedance spectroscopy (EIS) and chronoamperometry (CA) were used to monitor the evolution of film formation on the metal surface during exposure. The EIS data indicate that, of the four bias potentials examined, applying a potential of -200 mV versus OCP during the exposure period resulted in surface films of greatest resistance. Both EIS measurements and scanning electron microscopy (SEM) imaging indicate that these surfaces are substantially different to those formed without potential bias. Time of flight-secondary ion mass spectrometry (ToF-SIMS) elemental mapping of the films was utilized to ascertain the distribution of the ionic liquid cationic and anionic species relative to the microstructural surface features of ZE41 and indicated a more uniform distribution compared with the surface following exposure in the absence of a bias potential. Immersion of the treated ZE41 specimens in a chloride contaminated salt solution clearly indicated that the ionic liquid generated surface films offered significant protection against pitting corrosion, although the intermetallics were still insufficiently protected by the IL and hence favored intergranular corrosion processes.

Biocompatible ionic liquids: a new approach for stabilizing proteins in liquid formulation.

Ionic liquids (ILs) have shown excellent promise as both solutes and solvents for stabilizing proteins at room temperature. Because many modern drugs are protein-based, these stabilizing characteristics have great potential to provide advances in the field of liquid formulation of therapeutic proteins. However, before these developments can be translated into clinical solutions it is essential to establish data related to the biocompatibility of these ILs. The current work investigates the cytotoxicity of several ILs that were rationally synthesized from natural biomolecules and compounds that have already been approved as excipients for drug formulations. The effect of choline dihydrogen phosphate (choline dhp), choline saccharinate, and 1-butyl 3-methyl imidazolium lactate (bmim lactate) on the metabolic activity of a mouse macrophage cell line (J774) was assessed using the reduction in resazurin as an indicator of activity and, by extension, viability. Two formulations of lysozyme (10 mg/ml and 100 mg/ml) in 80 wt % choline dhp (aq) were prepared and the proteins were evaluated for structural stability immediately following formulation and again at 1 month. Equivalent formulations in 0.1 M Na acetate aqueous buffer were evaluated as controls. A differential scanning microcalorimeter (DSC) was used to evaluate the structural stability on the basis of the unfolding temperature and the enthalpy of unfolding, and a micrococcus lysodiekticus activity test was used to evaluate functional activity. All compounds were found to be relatively benign, with toxicity increasing in the order choline dhp

Ionic liquids in electrochemical devices and processes: managing interfacial electrochemistry.

Many ionic liquids offer a range of properties that make them attractive to the field of electrochemistry; indeed it was electrochemical research and applications that ushered in the modern era of interest in ionic liquids. In parallel with this, a variety of electrochemical devices including solar cells, high energy density batteries, fuel cells, and supercapacitors have become of intense interest as part of various proposed solutions to improve sustainability of energy supply in our societies. Much of our work over the last ten years has been motivated by such applications. Here we summarize the role of ionic liquids in these devices and the insights that the research provides for the broader field of interest of these fascinating liquids.

Unexpected improvement in stability and utility of cytochrome c by solution in biocompatible ionic liquids.

Proteins generally are only stable in vitro for short periods of time. This results in challenges during isolation and purification of recombinant proteins and reduces the shelf life of protein-based pharmaceuticals. Here we show that certain novel, biocompatible ionic liquids provide a stabilizing solvent for proteins, for example, cytochrome c, such that structure and activity are maintained even after 6 months of storage at room temperature. Normally, this protein would be rendered inactive after only 1 week in buffered aqueous solution. The effect of the ionic liquid solvent appears to be related to protection against hydrolysis.

The zwitterion effect in high-conductivity polyelectrolyte materials.

The future of lithium metal batteries as a widespread, safe and reliable form of high-energy-density rechargeable battery depends on a significant advancement in the electrolyte material used in these devices. Molecular solvent-based electrolytes have been superceded by polymer electrolytes in some prototype devices, primarily in a drive to overcome leakage and flammability problems, but these often exhibit low ionic conductivity and prohibitively poor lithium-ion transport. To overcome this, it is necessary to encourage dissociation of the lithium ion from the anionic polymer backbone, ideally without the introduction of competing, mobile ionic species. Here we demonstrate the effect of zwitterionic compounds, where the cationic and anionic charges are immobilized on the same molecule, as extremely effective lithium ion 'dissociation enhancers'. The zwitterion produces electrolyte materials with conductivities up to seven times larger than the pure polyelectrolyte gels, a phenomenon that appears to be common to a number of different copolymer and solvent systems.