Molecularly imprinted hybrid adsorbents for adenine and adenosine-5'-triphosphate.

Submicrometer-sized silica gel particles were coated with a polyanion and a polycation bearing thymine chromophores. The polymer-coated particles were found to selectively adsorb adenine and adenosine-5'-triphosphate (ATP), as compared to other nucleobases and nucleotides, respectively. The adsorption was enhanced by the irradiation of the particles in the presence of adenine which resulted in the molecular imprinting of adenine. ATP adsorption was strongly pH-dependent.

Flower micelle of amphiphilic random copolymers in aqueous media.

The structure of the flower micelle formed by an amphiphilic random copolymer, sodium (2-acrylamido)-2-methylpropanesulfonate and N-dodecylmethacrylamide p(AMPS/C12), in 0.05 M aqueous NaCl was investigated by fully atomistic molecular dynamics simulation as well as by light scattering, and the results were compared with the flower micelle model of the minimum loop size, recently proposed by Kawata et al. [Macromolecules 2007, 40, 1174-1180]. After a sufficiently long simulation time, simulated p(AMPS/C12) chain with the degree of polymerization of 200 and C12 content of 50 mol % formed a unicore micelle, of which radius of gyration was much smaller than the AMPS homopolymer with the same degree of polymerization. The simulated micellar structure was analyzed in terms of density distribution functions for dodecyl groups, the main chain, and sulfonate groups as functions of the radial distance r from the center of mass of dodecyl groups. Only dodecyl groups exist at r less, similar 1.5 nm, and the main chain and sulfonate groups distribute in the range of r between 1.5 and 3.5 nm, but there were dodecyl groups coexisting with the main chain and sulfonate groups beyond r = 1.5 nm. All these structural features, as well as hydrodynamic radius data for p(AMPS/C12) with C12 contents higher than ca. 20 mol % obtained by light scattering, agreed with the predictions of the flower micelle model of the minimum loop size.

Preparation and characterization of a pH-responsive nanogel based on a photo-cross-linked micelle formed from block copolymers with controlled structure.

Poly(ethylene glycol)-b-poly(2-(diethylamino)ethyl methacrylate-co-2-cinnamoyloxyethyl acrylate) (PEG-b-P(DEAEMA/CEA)) was prepared by reversible addition-fragmentation chain transfer (RAFT)-controlled radical polymerization. As solution pH is increased from an acidic pH, the hydrodynamic radius (R(h)) increases abruptly near pH 7, indicative of the micelle formation at pH > 7. The micelle formation at pH > 7 was supported by (1)H NMR and light scattering data. Upon irradiation of light, polymer chains in the core of the polymer micelle are cross-linked as a result of the photodimerization of the cinnamoyl groups, yielding a nanogel. The nanogel was characterized by gel-permeation chromatography (GPC), light scattering, small-angle X-ray scattering (SAXS), transmission electron microscopy (TEM), and fluorescence techniques. The nanogel displayed an ability to solubilize N-phenyl-1-naphthylamine (PNA) and 1-pyrenemethanol (hydrophobic guest molecules) into the hydrophobic core at pH > 7. It was confirmed with PNA that the solubilization of a guest molecule occurred at polymer concentrations (C(p)) lower than the critical micelle concentration (cmc) for PEG-b-P(DEAEMA/CEA) because the nanogel retains its micellar structure at C(p) < cmc. 1-Pyrenemethanol is strongly captured by the nanogel at pH 10, whereas it is easily released from the nanogel when pH is reduced to 3. This indicates that the hydrophobicity of the core of the nanogel can be modulated by a change in the degree of protonation of the DEAEMA units in the core, and thus the capture of a guest molecule and its release can be controlled by a change in solution pH.

Salt effect on the heat-induced association behavior of gold nanoparticles coated with poly(N-isopropylacrylamide) prepared via reversible addition-fragmentation chain transfer (RAFT) radical polymerization.

Poly(N-isopropylacrylamide) (PNIPAM) with a narrow molecular weight distribution was prepared by reversible addition-fragmentation chain transfer (RAFT) radical polymerization. A dithioester group at the chain end of PNIPAM thus prepared was cleaved by treating with 2-ethanolamine to provide thiol-terminated PNIPAM with which gold nanoparticles were coated via reactions of the terminal thiol with gold. The thermoresponsive nature of the maximum wavelength of the surface plasmon band and hydrodynamic radius (Rh) for the PNIPAM-coated gold nanoparticles were found to be sensitively affected by added salt. In pure water, Rh for the PNIPAM-coated gold nanoparticles at 40 degrees C (>lower critical solution temperature (LCST)) was smaller than that at 25 degrees C (

Synthesis of well-defined amphiphilic block copolymers having phospholipid polymer sequences as a novel biocompatible polymer micelle reagent.

To realize safer and effective drug administration, novel well-defined and biocompatible amphiphilic block copolymers containing phospholipid polymer sequences were synthesized. At first, the homopolymer of 2-methacryloyloxyethylphosphorylcholine (MPC) was synthesized in water by reversible addition-fragmentation chain transfer (RAFT) controlled radical polymerization. The "living" polymerization was confirmed by the fact that the number-average molecular weight increased linearly with monomer conversion while the molecular weight distribution remained narrow independent of the conversion. The poly(MPC) thus prepared is end-capped with a dithioester moiety. Using the dithioester-capped poly(MPC) as a macro chain transfer agent, AB diblock copolymers of MPC and n-butyl methacrylate (BMA) were synthesized. Associative properties of the amphiphilic block copolymer (pMPC(m)-BMA(n)) with varying poly(BMA) block lengths were investigated using NMR, fluorescence probe, static light scattering (SLS), and quasi-elastic light scattering (QELS) techniques. Proton NMR data in D2O indicated highly restricted motions of the n-butyl moieties, arising from hydrophobic associations of poly(BMA) blocks. Fluorescence spectra of N-phenyl-1-naphthylamine indicated that the probes were solubilized in the polymer micelles in water. The formation of polymer micelles comprising a core with poly(BMA) blocks and shell with hydrophilic poly(MPC) blocks was suggested by SLS and QELS data. The size and mass of the micelle increased with increasing poly(BMA) block length. With an expectation of a pharmaceutical application of pMPC(m)-BMA(n), solubilization of a poorly water-soluble anticancer agent, paclitaxel (PTX), was investigated. PTX dissolved well in aqueous solutions of pMPC(m)-BMA(n) as compared with pure water, implying that PTX is incorporated into the hydrophobic core of the polymer micelle. Since excellent biocompatible poly(MPC) sequences form an outer shell of the micelle, pMPC(m)-BMA(n) may find application as a promising reagent to make a good formulation with a hydrophobic drug.