Dynamic bioprocessing and microfluidic transport control with smart magnetic nanoparticles in laminar-flow devices.

In the absence of applied forces, the transport of molecules and particulate reagents across laminar flowstreams in microfluidic devices is dominated by the diffusivities of the transported species. While the differential diffusional properties between smaller and larger diagnostic targets and reagents have been exploited for bioseparation and assay applications, there are limitations to methods that depend on these intrinsic size differences. Here a new strategy is described for exploiting the sharply reversible change in size and magnetophoretic mobility of "smart" magnetic nanoparticles (mNPs) to perform bioseparation and target isolation under continuous flow processing conditions. The isolated 5 nm mNPs do not exhibit significant magnetophoretic velocities, but do exhibit high magnetophoretic velocities when aggregated by the action of a pH-responsive polymer coating. A simple external magnet is used to magnetophorese the aggregated mNPs that have captured a diagnostic target from a lower pH laminar flowstream (pH 7.3) to a second higher pH flowstream (pH 8.4) that induces rapid mNP disaggregation. In this second dis-aggregated state and flowstream, the mNPs continue to flow past the magnet rather than being immobilized at the channel surface near the magnet. This stimuli-responsive reagent system has been shown to transfer 81% of a model protein target from an input flowstream to a second flowstream in a continuous flow H-filter device.

Conditioning saliva for use in a microfluidic biosensor.

This report details an approach to saliva conditioning for compatibility of raw patient samples with microfluidic immunoassay components, principally biosensor surfaces susceptible to fouling. Stimulated whole human saliva spiked with a small molecule analyte (phenytoin, 252 Da) was first depleted of cells, debris and high molecular weight glycoproteins (mucins) using membrane filtration. This process significantly reduced but did not eliminate fouling of biosensor surfaces exposed to the sample. An H-filter, which separates solutes from mixed samples based on their diffusion in laminar flow, was used to extract the analyte from the remaining large molecular weight species in the filtered saliva sample. Patient samples treated in this way retained 23% of the analyte with 97% and 92% reduction in glycoproteins and proteins, respectively, and resulted in 3.6 times less surface fouling than either untreated or filtered saliva alone. These sample conditioning steps will enable the use of fouling-sensitive detection techniques in future studies using clinical saliva samples.