Thermochemical behavior of tris(2-butoxyethyl) phosphate (TBEP) during co-pyrolysis with biomass.

Co-pyrolysis of plastic waste and wood biomass to recover valuable chemicals is a cost-effective waste-recycling technology. However, widely used organophosphate ester additives in plastic, such as tris(2-butoxyethyl) phosphate (TBEP), can form diverse phosphorus (P)-containing species. These P-containing compounds can pose new environmental challenges when the biochar is reused. In this study, a mixture of TBEP and lignin was used to simulate the feedstock of plastic waste and wood biomass, and the thermochemical behavior of TBEP in slow pyrolysis (20 K min(-1)) and fast pyrolysis at 400-600 °C was investigated. The results show that low temperature in fast pyrolysis favors the enrichment of P in char. Up to 76.6% of initial P in the feedstock is retained in the char resulting from 400 °C, while only 51% is retained in the char from 600 °C. Slow pyrolysis favors the formation of stable P species regardless of the temperature; only 7% of the P retained in the char is extractable from char from slow pyrolysis, while 20-40% of P can be extracted from char resulting from fast pyrolysis. The addition of CaCl2 and MgCl2 can significantly increase the fraction of P retained in the char by the formation of Ca, Mg-P compounds. Online TG-FTIR-MS analysis suggests that TBEP undergoes decomposition through different temperature-dependent pathways. The P-containing radicals react with the aromatic rings produced by the pyrolysis of lignin to form Ar-P species, which is an important factor influencing the distribution and stabilization of P in char.

Preparation of novel poly(hydroxyethyl methacrylate-co-glycidyl methacrylate)-grafted core-shell magnetic chitosan microspheres and immobilization of lactase.

Poly(hydroxyethyl methacrylate-co-glycidyl methacrylate)-grafted magnetic chitosan microspheres (HG-MCM) were prepared using reversed-phase suspension polymerization method. The HG-MCM presented a core-shell structure and regular spherical shape with poly(hydroxyethyl methacrylate-co-glycidyl methacrylate) grafted onto the chitosan layer coating the Fe3O4 cores. The average diameter of the magnetic microspheres was 10.67 µm, within a narrow size distribution of 6.6-17.4 µm. The saturation magnetization and retentivity of the magnetic microspheres were 7.0033 emu/g and 0.6273 emu/g, respectively. The application of HG-MCM in immobilization of lactase showed that the immobilized enzyme presented higher storage, pH and thermal stability compared to the free enzyme. This indicates that HG-MCM have potential applications in bio-macromolecule immobilization.

Expanding the Phenotypic and Genetic Spectrum of Neuromuscular Diseases Caused by DYNC1H1 Mutations.

Objectives: Spinal muscular atrophy with lower extremity predominance 1 (SMALED1) and Charcot-Marie-Tooth diseasetype 2O (CMT2O) are two kinds of hereditary neuromuscular diseases caused by DYNC1H1 mutations. In this study, we reported two patients with SMALED1 caused by DYNC1H1 mutations. The genotype-phenotype correlations were further analyzed by systematically reviewing previous relevant publications. Materials and Methods: Two patients' with SMALED1 and their parents' clinical data were collected, and detailed clinical examinations were performed. WES was then applied, which was confirmed by Sanger sequencing. PubMed, Web of Science, CNKI, and Wanfang Data were searched, and all publications that met the inclusion criteria were carefully screened. Any individual patient without a detailed description of clinical phenotypes was excluded. Results: The two patients manifested delayed motor milestones and muscle wasting of both lower extremities. The diagnosis was further confirmed as SMALED1. Genetic testing revealed heterozygous DYNC1H1 mutations c.1792C>T and c.790C>G; the latter is a novel dominant mutation. Genotype-phenotype analysis of DYNC1H1 variants and neuromuscular diseases revealed that mutations in the DYN1 region of DYNC1H1 protein were associated with a more severe phenotype, more complicated symptoms, and more CNS involvement than the DHC_N1 region. Conclusion: Our study potentially expanded the knowledge of the phenotypic and genetic spectrum of neuromuscular diseases caused by DYNC1H1 mutations. The genotype-phenotype correlation may reflect the pathogenesis underlying the dyneinopathy caused by DYNC1H1 mutations.

Fabrication of surface charge pH-sensitive multi-bumpy small magnetic bead with ultrahigh magnetic content and its ultrahigh loading capacity and salt-free rapid isolation for DNA.

Gene transfection vector polyethyleneimine (PEI) was used as a cross-linking agent to crosslink the surface epoxidized magnetic nanoparticles and aggregate them to form a small magnetic bead (MB) with multiple nanoscale bumps on its surface (i.e. the multi-bumpy small magnetic bead, mbsMB). As there is a very low content of non-magnetic components (the cross-linking agent) in the magnetic bead, the mbsMB has an ultrahigh magnetic content of 81.95 % and a smaller particle size of 1.4 µm when compared with the usual medical MB. Such a small MB also has a strong magnetic force allowing it to reach the rapid separating ability of the commonly used larger medical MB which has 8 times its volume. The mbsMB has an obvious pH sensitivity of positive and negative surface charges and the salt-free isolation of DNA has been achieved based on the electrostatic interactions between mbsMB and DNA. This avoids the desalting of the isolated DNA as well as the effects of high salt concentration on its long chain helix structure. Whether in an acidic absorbing medium, an alkalinous desorbing one or a near neutral particle-storing one, the mbsMB will have obvious surface electrostatic charges. There is also its good suspension stability in an aqueous medium which provides a good condition for isolating of DNA suitable for efficiently adsorbing and desorbing. The as-prepared MB has a unique surface structure and some excellent properties, all suitable for adsorbing DNA. In addition, a large amount of commonly used gene transfection vector PEI can be cross-linked and bonded on the surface of mbsMB, whilst still having an excellent DNA-loading ability. In summary, the mbsMB has an ultrahigh capacity of 629.49 mg/g for DNA load.

cRGD target liposome delivery system promoted immunogenic cell death through enhanced anticancer potency of a thymidine conjugate under UVA activation as a cancer vaccine.

Conventional chemotherapeutic and photodynamic therapy have recently been shown to also elicit immune response against cancer through the immunogenic cell death mechanism, which can be potentially translated into effective cancer vaccines. However, there are few studies on the potential of nanodelivery system to promote the immunogenic cell death as a cancer vaccine. We reported here that cRGD target liposome delivery system was capable to promote the immunogenic cell death through enhanced potency of a thymidine conjugate post UVA activation as a cancer vaccine. Liposomes and cRGD target liposomes were found to significantly increase the cellular accumulation of the thymidine conjugate and subsequently translated into enhanced cytotoxic potency after UVA activation. More importantly, cRGD target liposomes of the thymidine conjugate markedly promoted the early detection of immunogenic cell death markers including ATP, HMGB1 and calreticulin. Subsequent in vivo vaccination-challenge study confirmed effective tumor growth inhibition by the cRGD liposomal thymidine conjugate and UVA treated cancer cells as the cancer vaccine. In addition, liposomes and cRGD target liposomes alone did not shown any induction of the immunogenic cell death markers, revealing the adjuvant nature of the nanodelivery system.

Safety and Efficacy of a Mouth-Rinse with Granulocyte Colony Stimulating Factor in Patients with Chemotherapy-Induced Oral Mucositis.

OBJECTIVE: To assess the safety and effectiveness of a mouth-rinse with G-CSF (JiSaiXin, produced by NCPC Biotechnology Co., Ltd) in treating patients with chemotherapy-induced oral mucositis (CIM). METHOD: A consecutive cohort of patients with advanced cancers and CIM were treated with mouth-rinse G-CSF. All chemotherapy for patients with advanced cancers was adopted from regimens suggested by NCCN guidelines. The mouth-rinse with G-CSF at a dose of 150-300ug plus 100ml-500ml normal saline was started from the time of oral mucositis was confirmed and continuously used for at least 7 days as one course. After at least two courses of treatment, safety and efficacy were evaluated. RESULTS: There were 7 female and 7 male patients with advanced cancer and CIM recruited into this study, including 5 with colorectal, 2 with lung, 1 patient with gastric, 1 with cervical and 1 with pancreatic cancer, as well as 2 patients with diffuse large B cell lymphomas, 1 with nasopharyngeal and 1 with gastric cancer. The median age was 57 (41-79) years. Grade 1 to 2 myelosuppression was observed in 3/14 patients, and Grade 4 myelosuppression in 1/14. Adverse effects on the gastrointestinal tract were documented in 5/14 patients, and were Grade 1 to Grade 3. No treatment related death was documented. Regarding CIM, the median response time to mouth rinse of G-CSF was 2 (1-5) days, and all patients with CIM demonstrated a positive response. CONCLUSIONS: Mouth-rinse with G-CSF proved to be safe and effective in treating patients with advanced cancers and CIM. However, further randomized controlled studies should be conducted to clarify the effectiveness of this treatment with other lesions.

[Study of the clinical and laboratory features of hand-foot-mouth disease].

OBJECTIVE: To study the clinical and laboratory features of the mild and severe hand-foot-mouth diseases (HFMD) in Shenzhen in 2008. METHODS: 145 cases were observed in East-Lake Hospital and Shenzhen Children's Hospital. Of the 145 cases, 124 mild cases and 21 severe cases were involved.All the clinical data and laboratory findings were collected and summarized. After collection of the acute and convalescent consecutive stools and peripheral bloods from the patients with HFMDI, EV71 genes were amplified from these samples by RT-PCR. Enterovirus 71 were cultured and isolated using Vero cell line and R&D cell line. RESULTS: The WBC counts and blood glucose levels of the severe cases were significantly elevated, but the ages of the severe ones significantly decreased compared with those of the mild cases (P < 0.05). EV71 genes could be detected by RT-PCR with 35% positive rate in mild cases and 67% in severe cases. The EV71 gene detection rate of the severe cases was significantly increased in contrast to that of the mild ones. The EV71 were isolated and cultured from the stools of 9 patients, one specimens from the dead's stool. Two severe cases died of neurogenic pulmonary edema and brain-stem encephalitis. CONCLUSIONS: EV71 mainly contributes to HFMD and is responsible for death of some severe cases. High fever, less rash, elevated white blood cell counts and blood glucose concentrations as well as age less than 4 years old should be used for prediction of severe cases.