Contributions of Crystalline and Noncrystalline Cellulose Can Occur in the Same Spectral Regions: Evidence Based on Raman and IR and Its Implication for Crystallinity Measurements.

Aggregated states of celluloses remain poorly understood, and therefore, the topic requires careful investigation. In this study, Raman, IR, and X-ray diffraction (XRDs) were used to study cotton microcrystalline cellulose (MCC) and MCC that has been ball-milled to various degrees. Raman and IR spectroscopy methods indicated that when these ball-milled samples were wet with water, most underwent conformational changes at the molecular level. Although formation of cellulose II was observed in longer duration ball-milled samples, the changes primarily gave rise to increased contributions in spectral and diffraction regions typically associated with the contributions of crystalline cellulose I. Moreover, when the wet samples were air-dried at 25 °C, the newly formed cellulose I-like structures partly reverted to the previous form present in the initial dry state. These findings explained for the previously reported XRD and NMR observations, where the addition of water resulted in increased crystallinities of cellulose samples. The implications of these findings to cellulose crystallinity measurements and other situations are discussed.

Tricin, a flavonoid monomer in monocot lignification.

Tricin was recently discovered in lignin preparations from wheat (Triticum aestivum) straw and subsequently in all monocot samples examined. To provide proof that tricin is involved in lignification and establish the mechanism by which it incorporates into the lignin polymer, the 4'-O-ß-coupling products of tricin with the monolignols (p-coumaryl, coniferyl, and sinapyl alcohols) were synthesized along with the trimer that would result from its 4'-O-ß-coupling with sinapyl alcohol and then coniferyl alcohol. Tricin was also found to cross couple with monolignols to form tricin-(4'-O-ß)-linked dimers in biomimetic oxidations using peroxidase/hydrogen peroxide or silver (I) oxide. Nuclear magnetic resonance characterization of gel permeation chromatography-fractionated acetylated maize (Zea mays) lignin revealed that the tricin moieties are found in even the highest molecular weight fractions, ether linked to lignin units, demonstrating that tricin is indeed incorporated into the lignin polymer. These findings suggest that tricin is fully compatible with lignification reactions, is an authentic lignin monomer, and, because it can only start a lignin chain, functions as a nucleation site for lignification in monocots. This initiation role helps resolve a long-standing dilemma that monocot lignin chains do not appear to be initiated by monolignol homodehydrodimerization as they are in dicots that have similar syringyl-guaiacyl compositions. The term flavonolignin is recommended for the racemic oligomers and polymers of monolignols that start from tricin (or incorporate other flavonoids) in the cell wall, in analogy with the existing term flavonolignan that is used for the low-molecular mass compounds composed of flavonoid and lignan moieties.

Estimation of Syringyl Units in Wood Lignins by FT-Raman Spectroscopy.

Syringyl (S) lignin content and the syringyl-to-guaiacyl (S/G) lignin ratio are important characteristics of wood and lignocellulosic biomass. Although numerous methods are available for estimating S lignin units and the S/G ratio, in this work, a new method based on Raman spectroscopy that uses the 370 cm-1 Raman band-area intensity (370-area) was developed. The reliability of the Raman approach for determining S content was first tested by the quantitative analysis of three syringyl lignin models by sampling them, separately, in dioxane and in Avicel. Good linear correlations between the 370 cm-1 intensity and model concentrations were obtained. Next, the percent syringyl (%S) lignin units in various woods were measured by correlating the 370 cm-1 Raman intensity data with values of S units in lignin determined by three regularly used methods, namely, thioacidolysis, DFRC, and 2D-HSQC NMR. The former two methods take into account only the monomers cleaved from ß-O-4-linked lignin units, whereas the NMR method reports S content on the whole cell wall lignin. When the 370-area intensities and %S values from the regularly used methods were correlated, good linear correlations were obtained ( R2 = 0.767, 0.731, and 0.804, respectively, for the three methods). The correlation with the highest R2, i.e., with the 2D NMR method, is proposed for estimating S units in wood lignins by Raman spectroscopy as, in principle, both represent the whole cell wall lignin and not just the portion of lignin that gets cleaved to release monomers. The Raman analysis method is quick, uses minimal harmful chemicals, is carried out nondestructively, and is insensitive to the wet or dry state of the sample. The only limitations are that the sample of wood contains at least 30% S and not be significantly fluorescent, although the latter can be mitigated in some cases.

Estimation of cellulose crystallinity of lignocelluloses using near-IR FT-Raman spectroscopy and comparison of the Raman and Segal-WAXS methods.

Of the recently developed univariate and multivariate near-IR FT-Raman methods for estimating cellulose crystallinity, the former method was applied to a variety of lignocelluloses: softwoods, hardwoods, wood pulps, and agricultural residues/fibers. The effect of autofluorescence on the crystallinity estimation was minimized by solvent extraction or chemical treatment or both. Additionally, when the roles of lignin and hemicellulose in the Raman crystallinity assessment were investigated, it was found that syringyl lignin containing lignocelluloses generated somewhat higher crystallinity, whereas the presence of hemicellulose reduced the crystallinity. Overall, when autofluorescence was minimized and corrections made for hemicellulose and syringyl lignin contributions, the univariate Raman method performed well and estimated cellulose crystallinity accurately. Moreover, when the Raman and Segal-WAXS methods were compared, we observed that in the absence of significant fluorescence, the Raman method was influenced mostly by hemicellulose and syringyl lignin, whereas the Segal-WAXS was affected by various types of lignin and hemicellulose. It was concluded that the near-IR FT-Raman method with corrections for influences of syringyl lignin and hemicellulose can be used to correctly estimate cellulose crystallinity.

New insights into the ligninolytic capability of a wood decay ascomycete.

Wood-grown cultures of Daldinia concentrica oxidized a permethylated beta-(14)C-labeled synthetic lignin to (14)CO(2) and also cleaved a permethylated alpha-(13)C-labeled synthetic lignin to give C(alpha)-C(beta) cleavage products that were detected by (13)C nuclear magnetic resonance spectrometry. Therefore, this ascomycete resembles white-rot basidiomycetes in attacking the recalcitrant nonphenolic structures that predominate in lignin.

Effects of coumarate 3-hydroxylase down-regulation on lignin structure.

Down-regulation of the gene encoding 4-coumarate 3-hydroxylase (C3H) in alfalfa massively but predictably increased the proportion of p-hydroxyphenyl (P) units relative to the normally dominant guaiacyl (G) and syringyl (S) units. Stem levels of up to approximately 65% P (from wild-type levels of approximately 1%) resulting from down-regulation of C3H were measured by traditional degradative analyses as well as two-dimensional 13C-1H correlative NMR methods. Such levels put these transgenics well beyond the P:G:S compositional bounds of normal plants; p-hydroxyphenyl levels are reported to reach a maximum of 30% in gymnosperm severe compression wood zones but are limited to a few percent in dicots. NMR also revealed structural differences in the interunit linkage distribution that characterizes a lignin polymer. Lower levels of key beta-aryl ether units were relatively augmented by higher levels of phenylcoumarans and resinols. The C3H-deficient alfalfa lignins were devoid of beta-1 coupling products, highlighting the significant differences in the reaction course for p-coumaryl alcohol versus the two normally dominant monolignols, coniferyl and sinapyl alcohols. A larger range of dibenzodioxocin structures was evident in conjunction with an approximate doubling of their proportion. The nature of each of the structural units was revealed by long range 13C-1H correlation experiments. For example, although beta-ethers resulted from the coupling of all three monolignols with the growing polymer, phenylcoumarans were formed almost solely from coupling reactions involving p-coumaryl alcohol; they resulted from both coniferyl and sinapyl alcohol in the wild-type plants. Such structural differences form a basis for explaining differences in digestibility and pulping performance of C3H-deficient plants.

NMR analysis of lignins in CAD-deficient plants. Part 1. Incorporation of hydroxycinnamaldehydes and hydroxybenzaldehydes into lignins.

Peroxidase/H2O2-mediated radical coupling of 4-hydroxycinnamaldehydes produces 8-O-4-, 8-5-, and 8-8-coupled dehydrodimers as has been documented earlier, as well as the 5-5-coupled dehydrodimer. The 8-5-dehydrodimer is however produced kinetically in its cyclic phenylcoumaran form at neutral pH. Synthetic polymers produced from mixtures of hydroxycinnamaldehydes and normal monolignols provide the next level of complexity. Spectral data from dimers, oligomers, and synthetic polymers have allowed a more substantive assignment of aldehyde components in lignins isolated from a CAD-deficient pine mutant and an antisense-CAD-downregulated transgenic tobacco. CAD-deficient pine lignin shows enhanced levels of the typical benzaldehyde and cinnamaldehyde end-groups, along with evidence for two types of 8-O-4-coupled coniferaldehyde units. The CAD-downregulated tobacco also has higher levels of hydroxycinnamaldehyde and hydroxybenzaldehyde (mainly syringaldehyde) incorporation, but the analogous two types of 8-O-4-coupled products are the dominant features. 8-8-Coupled units are also clearly evident. There is clear evidence for coupling of hydroxycinnamaldehydes to each other and then incorporation into the lignin, as well as for the incorporation of hydroxycinnamaldehyde monomers into the growing lignin polymer. Coniferaldehyde and sinapaldehyde (as well as vanillin and syringaldehyde) co-polymerize with the traditional monolignols into lignins and do so at enhanced levels when CAD-deficiency has an impact on the normal monolignol production. The implication is that, particularly in angiosperms, the aldehydes behave like the traditional monolignols and should probably be regarded as authentic lignin monomers in normal and CAD-deficient plants.