Waste plastic resource recovery from landfilled refuse: A novel waterless cleaning method and its cost-benefit analysis.

The efficient classification and resource conversion of landfilled refuse can simultaneously realize the secondary pollution prevention and land replacement. This work aimed to investigate the waste plastic resource recovery from landfilled refuse via a novel waterless cleaning method. Composition analysis showed that the content of waste plastic from landfilled refuse had differences between different regions, and the specific weight content range was between 15-40%. Moreover, when the landfill time was less than 7 years, the high calorific value (>35 MJ/kg) and mechanical property (declining range <3%) of waste plastic were basically the same as those of the original waste plastic, indicating a high resource attribute. However, due to the high degree of pollution, it was difficult to directly make high-value utilization. Furthermore, a waterless device was designed for waste plastic cleaning, and 94% cleaning rate was obtained with the optimal conditions of the sand medium particle size of 4-14 mesh, stirring speed of 50 r/min, and the operation time of 45 min. The actual on-site pilot test was carried out under the best conditions, and the results showed that the cleaning rate of waste plastic could reach 90%. On the basis, cost-benefit analysis of different waste plastic recycling methods was carried out. Compared with the other four methods, direct extrusion molding after multi-effect cleaning had lower resource consumption (cost of 88.64 RMB), higher economic benefit (net income of 311.36 RMB), and was more in line with the characteristics of raw materials. This research can provide scientific basis and technical support for the cleaning and upgrading and resource utilization of plastic in refuse.

Pillararene-Based Fluorescent Supramolecular Systems: The Key Role of Chain Length in Gelation.

Four supramolecular assemblies are fabricated from two pillararene tetramers with aggregation-induced emission properties (SH and LH) and two different lengths of neutral guests with three binding sites (arms) for pillararene cavities (SG and LG) through host-guest interactions, and their fluorescent behaviors in organic solvent are investigated. SG⊂SH exhibits the largest fluorescent enhancement in chloroform due to supramolecular assembly-induced emission enhancement, while only LG⊂LH turns into supramolecular gel with stimuli responsiveness owing to their most flexible arms.

MA104 Cell line presents characteristics suitable for enterovirus A71 isolation and proliferation.

Enterovirus A71 (EV-A71), one of the most important causative agents of hand, foot and mouth disease (HFMD) in children, can lead to severe clinical outcomes, even death. However, the infection spectrum of EV-A71 in different cell lines remains unknown. Therefore, in this study, the biological characteristics of EV-A71 Subgroup C4 in different cell lines were investigated. To this end, the infectivity of EV-A71Jinan1002 isolated from children with severe HFMD was assessed in 18 different host cell lines. It was found that the MA104 cell line displayed biological characteristics suitable for EV-A71 Subgroup C4 strain isolation and proliferation; indeed, it was found that a broad spectrum of cell lines can be infected by EV-A71Jinan1002. Among the screened cells, four cell lines (HEK293, RD, MA104 and Marc145) produced high 50% tissue culture infective dose (TCID50 ) values calculated in viral proliferations (ranged from 10(7.6) to 10(7.8) ); the TCID50 being negatively associated with the time to appearance of CPE. Proliferation curves demonstrated that EV-A71Jinan1002 amplifies more efficiently in MA104, Hep-2 and RD cells. Remarkably, the virus isolation rate was much higher in MA104 cells than in RD cells. Thus this study, to our knowledge, is for the first to explore the infection spectrum of EV-A71 subgroup C4 in such a large number of different cell lines. Our data provide useful reference data for facilitating further study of EV-A71.

A new surgical procedure for phallic reconstruction in partial penis necrosis: penile elongation in combination with glanuloplasty.

The radial forearm flap transfer has proved to be the standard technique in penile reconstruction. However, this operation still leads to a residual scar on the forearm. In the reconstruction of partial penis necrosis, achieving a desirable appearance and functional recovery while minimizing donor-site damage remains an unsolved problem. In this study, we report our experience using penile elongation combined with glanuloplasty to rebuild the partially necrotic penis.A retrospective review of a consecutive series of 33 patients with partial penis necrosis after microwave thermotherapy (not from our hospital) from December 2008 to May 2012 was conducted at the Department of Plastic and Reconstructive Surgery, Shanghai 9th People's Hospital. These patients, with an age range from 20 to 36 years, first underwent a scrotal skin flap transfer to cover residual cavernosum. The penis was simultaneously elongated at the proximal end. Six months later, all patients received glanuloplasty using expanded polytetrafluoroethylene that was implanted at the distal end of transferred scrotal skin flap to create the neoglans.Anthropometric measurements of preoperative and postoperative penile length were performed with an average follow-up period of 28 months. The mean extended penile length average was 2.57 cm, ranging from 3.16 to 5.73 cm. Patients' satisfaction rate was 88%. In addition, preoperative and postoperative photographs were reviewed for objective and subjective assessment of outcome parameters such as appearance of neophallus, urination, and erogenous sensation. Most importantly, the rebuilt penis postoperatively showed almost normal shape and restoration of basic physiologic function in most of the patients, with an acceptable complication rate. These preliminary results may provide a useful strategy for the reconstruction of a partially necrotic penis using a novel, simple, and effective approach.

Microplastics in large marine animals stranded in the Republic of Korea.

Microplastics (MPs) are found in every ocean and are frequently ingested by marine animals. This study analyzed MPs in the stomachs and intestines of 12 large marine animals comprising one fin whale (Balaenoptera physalus), seven finless porpoises (Neophocaena asiaeorientalis), two loggerhead turtles (Caretta caretta), one Indo-Pacific bottlenose dolphin (Tursiops aduncus), and one common dolphin (Delphinus delphis) that were stranded off the Republic of Korea between 2019 and 2021. MPs were detected with a mean abundance of 3.42 ± 3.2 items/g and were predominantly of transparent-white, fragment-shaped polypropylene smaller than 200 µm. The abundance of MPs found did not correlate with the biological information (maturity, body length) of the finless porpoises and there were no significant differences in the abundance of MPs between the stomachs and intestines. These results cannot accurately assess the impact of MPs on large marine animals, so further studies are necessary to understand how MPs can potentially affect them.

Variation and Uncertainty of Microplastics in Commercial Table Salts: Critical Review and Validation.

Increasing concern of human exposure to microplastics (MPs) necessitates an assessment of the quality of MP data relevant to human exposure. In this literature review for table salt, we addressed the variability and uncertainty of MP data caused by different analytical methods among studies. Additionally, validation experiment was conducted to identify and correct uncertainties related to MP size. When combined without validation, salt data in literature (n = 150) showed a wide range of 0-39800 (1386 ±â€¯5477) MPs kg-1. All procedures, including sample treatment, MP identification, and quality assurance were related to this variability. Most serious variability originated from the MP identification methods associated with minimum cut-off size of targeted/measured MPs and the selection of particles identified. When not corrected by size, MP content differed by 10-600 times among MP identification methods, with greatest value from visual observation, followed by FTIR and Raman methods. Meanwhile, there was a significant correlation-regardless of identification method-between logarithmic mean abundances and minimum cut-off sizes. The size-corrected values showed that adults intake up to 19000 MPs ≥10 µm annually via table salt, compared with 5100 MPs that was estimated from uncorrected mean abundance. Our validation experiment also showed the possibility of serious errors being caused by arbitrary selection of "MP-like particles" in spectroscopic analysis, specifically for smaller-sized particles. A combination of unverified data originated from different methods might have failed to adequately produce reliable human health-relevant results, thereby undermining the ability to quantify human risk.

Construction of Antibacterial N-Halamine Polymer Nanomaterials Capable of Bacterial Membrane Disruption for Efficient Anti-Infective Wound Therapy.

The increasing occurrence of bacterial infection at the wound sites is a serious global problem, demanding the rapid development of new antibacterial materials for wound dressing to avoid the abuse of antibiotics and thereby antibiotic resistance. In this work, the authors first report on antibacterial N-halamine polymer nanomaterials based on a strategic copolymerization of 3-allyl-5,5-dimethylhydantoin (ADMH) and methyl methacrylate (MMA), which exhibits in vitro and in vivo antimicrobial efficacy against pathogenic bacteria including Staphylococcus aureus and Escherichia coli. Particularly, when a biological evaluation is run for wound therapy, the N-halamine polymer nanomaterials exhibit a powerful antibacterial efficiency and wound healing ability after a series of histological examination of mouse wound. After the evaluation of biological and chemical surroundings, the proposed four-stage mechanism suggests that, with unique antibacterial NCl bonds, the N-halamine polymer nanomaterials can disrupt the bacterial membrane, as a result causing intracellular content leaked out and thereby cell death. Based on the synergistic action of antibacterial and wound therapy, the N-halamine polymer nanomaterials are expected to be promising as wound dressing materials in medical healing and biomaterials.

GS-9620 inhibits enterovirus 71 replication mainly through the NF-κB and PI3K-AKT signaling pathways.

Human enterovirus 71 (EV71) is the second most common cause of hand, foot, and mouth disease (HFMD), which can occur as a severe epidemic especially among children under 5-years old. New and improved treatment strategies to control EV71 infection are therefore urgently required. The heterocyclic compound GS-9620, a potent and selective agonist of Toll-like receptor 7 (TLR7), has been reported to activate plasmacytoid dendritic cells (pDCs), and suppress HBV as well as HIV replication. In this study, we indicated that GS-9620 also could inhibit EV71 replication in the mouse model of EV71 infection. With three-days treatment after EV71 infection, the levels of proinflammatory cytokines/chemokines, like IFN-α, IFN-γ and MCP-1, were sharply reduced in serum compared to those without treatment. Furthermore, GS-9620 activated TLR7 in the limb muscle cells, which stimulated the NF-κB and PI3K/AKT signaling pathways. When NF-κB or PI3K/AKT inhibitors were used, the antiviral effect of the GS-9620 was impacted. Overall, our data implied GS-9620 probably activates NF-κB and PI3K/AKT signaling pathways to clear the virus.

Stimuli-responsive blue fluorescent supramolecular polymers based on a pillar[5]arene tetramer.

A tetraphenylethene-bridged pillarene tetramer with aggregation-induced emission properties forms an A4/B2-type supramolecular polymer and a gel with a symmetric neutral guest linker, showing a remarkable fluorescence emission enhancement in solution and the solid state and a good responsiveness to temperature and solvent composition.