Early ontogenesis from embryo to juvenile in Senegalese sole Solea senegalensis under laboratory conditions.

Senegalese sole, Solea senegalensis, is a flatfish of high commercial value in the world. It has been identified as an interesting and promising species for marine commercial aquaculture diversification in Europe for at least four decades and was introduced to China in 2003. Early ontogenesis from embryo to juvenile stages in S. senegalensis was analysed under controlled laboratory conditions to provide morphological information for aquaculture. From 0 to 59 days post hatching (dph), 10-20 larvae were sampled and measured each day (0-17 dph) or every 2-6 days (17-59 dph). Morphological characteristics from the egg to the juvenile stage were described. The eggs were separate and spherical with multiple oil globules. After 3 dph, the yolk sac was completely absorbed, mouth and anus were open, a swim bladder appeared, and larvae began feeding on rotifers (Brachionus plicatilis). The larvae began metamorphosis as the notochord flexed upward and the left eye migrated upward after 10 dph. The left eye migrated to the dorsal midline at 15 dph. At 19 dph, the left eye was translocated to the right-ocular side, and the juveniles adopted a benthic lifestyle. The swim bladder degenerated, and the juveniles completed metamorphosis at 23 dph. The growth patterns of some parameters (TL, SL, BH, BW) during larval and juvenile development stages were identified. The inflection points, which are slopes of growth changes, were calculated in growth curves. Three inflection points occurring in the growth curves of larvae and juveniles were found to be associated with metamorphosis, weaning, and transitions in feeding habits. The basic information of embryo development and ontogenesis in this study represents a valuable contribution to the S. senegalensis industry, especially in artificial breeding and rearing techniques.

Injectable hydrogels embedded with alginate microspheres for controlled delivery of bone morphogenetic protein-2.

Some delivery carriers with injectable characteristics were built using the thermosensitive chitosan/dextran-polylactide/glycerophosphate hydrogel and selected alginate microspheres for the controllable release of bone morphogenetic protein-2 (BMP-2). BMP-2 was first loaded into the microspheres with an average size of around 20 µm and the resulting microspheres were then embedded into the gel in order to achieve well-controlled BMP-2 release. The microsphere-embedded gels show their incipient gelation temperature at around 32 °C and pH at about 7.1. Some gels had their elastic modulus close to 1400 Pa and the ratio of elastic modulus to viscous modulus at around 34, revealing that they behaved like mechanically strong gels. Optimized microsphere-embedded gels were found to be able to administer the BMP-2 release without significant initial burst release in an approximately linear manner over a period of time longer than four weeks. The release rate and the released amount of BMP-2 from these gels could be regulated individually or cooperatively by the initial BMP-2 load and the dextran-polylactide content in the gels. Measurements of the BMP-2 induced alkaline phosphatase activity in C2C12 cells confirmed that C2C12 cells responded to BMP-2 in a dose-dependent way and the released BMP-2 from the microsphere-embedded gels well retained their bioactivity. In vivo assessment of some gels revealed that the released BMP-2 maintained its osteogenesis functions.