A Study on the Electro-Optical Properties of Thiol-Ene Polymer Dispersed Cholesteric Liquid Crystal (PDChLC) Films.

In this study, a polymer dispersed cholesteric liquid crystal (PDChLC) film obtained via a one-step fabrication technique based on photopolymerization of a thiol-acrylate reaction system was prepared and characterized for the first time. The effects of the chiral dopant, the influence of thiol monomer functionality and content on the morphology and subsequent performance of the PDChLC films were systematically investigated. It was demonstrated that the addition of a small amount of chiral dopant slightly increased the driving voltage, but decreased the off-state transmittance significantly. Furthermore, scanning electron micrographs (SEM) shown that the liquid crystal (LC) droplet size decreased at first and then increased with the increasing amount of thiol monomer functionality, while increasing the thiol content increased the LC droplet size. Correspondingly, the electro-optical switching behavior was directly dependent on LC droplet size. By tuning the raw material composition, PDChLC film with optimized electro-optical performance was prepared.

Effect of a Polymercaptan Material on the Electro-Optical Properties of Polymer-Dispersed Liquid Crystal Films.

Polymer-dispersed liquid crystal (PDLC) films were prepared by the ultraviolet-light-induced polymerization of photopolymerizable monomers in nematic liquid crystal/chiral dopant/thiol-acrylate reaction monomer composites. The effects of the chiral dopant and crosslinking agents on the electro-optical properties of the PDLC films were systematically investigate. While added the chiral dopant S811 into the PDLC films, the initial off-state transmittance of the films was decreased. It was found that the weight ratio among acrylate monomers, thiol monomer PETMP and the polymercaptan Capcure 3-800 showed great influence on the properties of the fabricated PDLC films because of the existence of competition between thiol-acrylate reaction and acrylate monomer polymerization reaction. While adding polymercaptans curing agent Capcure 3-800 with appropriate concentration into the PDLC system, lower driven voltage and higher contrast ratio were achieved. This made the polymer network and electro-optical properties of the PDLC films easily tunable by the introduction of the thiol monomers.

Morbidity Analysis of the Notifiable Infectious Diseases in China, 2018.

What is already known about this topic? Annual morbidity analysis reports that summarized trends and changing epidemiology for notifiable diseases were published in 2013 and 2015 (1,2). What is added by this report? In 2018, the morbidity of national notifiable diseases was 559.41 per 100,000 population, an increase of 12.88% compared with the average rate between 2015-2017. The five notifiable diseases with the highest reported morbidity were hand, foot, and mouth disease (HFMD), infectious diarrhea, hepatitis B, tuberculosis, and influenza. The five regions with the highest reported morbidity of infectious diseases were Zhejiang Province, Guangxi Autonomous Region, Guangdong Province, Beijing Municipality, and Xinjiang Autonomous Region. What are the implications for public health practice? Evidence on notifiable disease morbidity trends and changing epidemiology should help disease control and prevention agencies and medical institutions direct their response and prevention efforts. In addition, this report demonstrates the continued need for surveillance systems and high-quality data to identify focal points for disease control.