RESUMEN
OBJECTIVE: To determine possible effects of unilateral alveolar cleft closure on internal nasal volume and external nasolabial surface. DESIGN: Retrospective, single-arm, cohort study. SETTING: Institutional, tertiary care. PATIENTS: Patients with complete unilateral cleft lip, alveolus, and palate (CUCLAP), who underwent closure of the alveolar cleft with autologous bone graft (ABG) at the age of 9-11 years, with cone beam computed tomography (CBCT) and/or three-dimensional (3D) stereophotogrammetry images taken before and one year after the ABG procedure. INTERVENTIONS: ABG-pocedure in patients with CUCLAP. MAIN OUTCOME MEASURES: The influence of ABG on the internal and external nasal morphology. RESULTS: A total of 28 patients (21M/7F, 14R/14L) were divided into internal (CBCT) and external (3D-stereophotogrammetry) measurement subgroups. The external nasolabial surface showed a significant decrease of the angle alar curvature right-subnasale-alar curvature left (-1.99°; P = .02; 95% CI -2.61, -0.36) and an increase of the linear measurement between these points (+1.01â mm; P = .03; 95% CI: 0.11, 1.91). No significant differences were found when comparing the distance maps of the affected side with the non-affected side (P = .50, 95% CI: -0.20, 0.29). CONCLUSIONS: Closure of the alveolar cleft in CUCLAP patients with ABG did not affect the internal nasal volume, but significantly affected the external nasal surface. The procedure resulted in the nose becoming wider because both alar curvatures moved caudally and laterally relative to the subnasale.
RESUMEN
In this retrospective study, 2 intraoral scans with an interval of at least 1 year were superimposed in 25 oligodontic patients. The differences in vertical eruption (mm) were measured and the orthopantomograms were analyzed for the presence of ankylotic deciduous molars with no successor. The mean eruption of deciduous molars with and without successor was significantly lower than the mean eruption of permanent molars. The eruption of permanent molars was a predictive variable for the eruption of deciduous molars. The number of agenetic elements and the presence of a successor were strongly associated with the eruption of deciduous molars. Also, the mean eruption of deciduous molars with ankylosis was significantly lower than that of deciduous molars without ankylosis. This study showed a strong relationship between the diagnosis of ankylotic deciduous molars and the measurement of negative vertical eruption when monitored by intraoral scans.
Asunto(s)
Anquilosis , Anquilosis del Diente , Humanos , Estudios Retrospectivos , Diente Primario , Erupción Dental , Diente MolarRESUMEN
PURPOSE: The purpose of this study was to evaluate the clinical accuracy of the fusion of intra-oral scans in cone-beam computed tomography (CBCT) scans using two commercially available software packages. MATERIALS AND METHODS: Ten dry human skulls were subjected to structured light scanning, CBCT scanning, and intra-oral scanning. Two commercially available software packages were used to perform fusion of the intra-oral scans in the CBCT scan to create an accurate virtual head model: IPS CaseDesigner® and OrthoAnalyzer™. The structured light scanner was used as a gold standard and was superimposed on the virtual head models, created by IPS CaseDesigner® and OrthoAnalyzer™, using an Iterative Closest Point algorithm. Differences between the positions of the intra-oral scans obtained with the software packages were recorded and expressed in six degrees of freedom as well as the inter- and intra-observer intra-class correlation coefficient. RESULTS: The tested software packages, IPS CaseDesigner® and OrthoAnalyzer™, showed a high level of accuracy compared to the gold standard. The accuracy was calculated for all six degrees of freedom. It was noticeable that the accuracy in the cranial/caudal direction was the lowest for IPS CaseDesigner® and OrthoAnalyzer™ in both the maxilla and mandible. The inter- and intra-observer intra-class correlation coefficient showed a high level of agreement between the observers. CLINICAL RELEVANCE: IPS CaseDesigner® and OrthoAnalyzer™ are reliable software packages providing an accurate fusion of the intra-oral scan in the CBCT. Both software packages can be used as an accurate fusion tool of the intra-oral scan in the CBCT which provides an accurate basis for 3D virtual planning.
Asunto(s)
Tomografía Computarizada de Haz Cónico , Imagenología Tridimensional , Humanos , Mandíbula/diagnóstico por imagen , Maxilar , Programas InformáticosRESUMEN
OBJECTIVES: The purpose of this study was to quantify the symmetry of the alveolar process of the maxilla and palate during the first year of life in healthy infants with the help of a semiautomatic segmentation technique. MATERIALS AND METHODS: Maxillary plaster models of seventy healthy babies at 0, 3, 6, 9, and 12 months were collected and digitized. A semiautomatic segmentation tool was used to extract the alveolus and palate. The resulting model was aligned within a reference frame and mirrored on its medial plane. Distance maps were created and analyzed to compare and quantify the differences between the two hemispheres. Additional hemispherical width and area measurements were performed. An ANOVA test with additional post hoc tests was performed to check if the symmetry changed during development. Finally, the results were tested on intra- and interobserver variability. RESULTS: The absolute mean inter-surface distance between the original and mirrored models in each age group ranged between 0.23 and 0.30 mm. Width and area analysis showed a small but significant larger left palatal hemisphere. ANOVA and post hoc tests showed no significant difference in symmetry between groups. Reliability analysis showed no significant differences between observers. CONCLUSIONS: This study showed that in this infant population, only a small degree of palatal asymmetry was present, which can be considered as normal and clinically irrelevant. CLINICAL RELEVANCE: The data from this study can be used in future comparative studies as reference data. Furthermore, modeling of these data can help in predicting the growth pattern, which may lead to improved treatment protocols for children with craniofacial anomalies.
Asunto(s)
Fisura del Paladar , Arco Dental , Niño , Humanos , Lactante , Maxilar , Reproducibilidad de los ResultadosRESUMEN
OBJECTIVES: The purpose of this study was to evaluate the clinical accuracy of virtual orthodontic setups by using a new CBCT-based approach. MATERIALS AND METHODS: Ten patients who underwent pre-surgical orthodontics were included in this study. Pre-treatment and pre-surgical cone-beam CT (CBCT) scans and digital dental models were available. The pre-treatment digital dental model was used to create an orthodontic virtual setup. The digital dental models were fused with the corresponding CBCT scans, and the two CBCT scans were aligned using voxel-based matching. Moving each individual tooth from the virtual setup to the final outcome allows the calculation of the accuracy of the virtual setup by using an iterative closest point algorithm. Differences between virtual setup and final outcome were recorded as well as the ICC between two observers. RESULTS: The inter-observer variability showed a high level of agreement between the observers. The largest mean difference between observers was found in the cranial/caudal direction (0.36 ± 0.30 mm) and the roll rotation (1.54 ± 0.98°). Differences between the virtual setup and final outcome were small in the translational direction (0.45 ± 0.48 mm). Rotational mean differences were larger with the pitch of the incisors (0.00 ± 7.97°) and molars (0.01 ± 10.26°) as largest difference. Excessive extrusion of all upper teeth and more anterior movement than planned were seen for both upper and lower arch. Lower molars showed less extrusion. CLINICAL RELEVANCE: The data of this study can be used to obtain more insight in the accuracy and achievability of orthodontic virtual setup. Tooth movement can now be studied in more details which can lead to new insights.
Asunto(s)
Ortodoncia , Técnicas de Movimiento Dental , Interfaz Usuario-Computador , Tomografía Computarizada de Haz Cónico , Humanos , Imagenología Tridimensional , Incisivo , Diente MolarRESUMEN
OBJECTIVES: The aim of this study was to develop an accurate and intuitive semi-automatic segmentation technique to calculate an average maxillary arch and palatal growth profile for healthy newborns in their first year of life. MATERIALS AND METHODS: Seventy babies born between 1985 and 1988 were included in this study. Each child had five impressions made in the first year after birth that were digitalized. A semi-automatic segmentation tool was developed and used to assess the maxillary dimensions. Finally, random effect models were built to describe the growth and build a simulation population of 10,000 newborns. The segmentation was tested for inter- and intra-observer variability. RESULTS: The Pearson correlation coefficient for each of the variables was between 0.94 and 1.00, indicating high inter-observer agreement. The paired sample t test showed that, except for the tuberosity distance, there were small, but significant differences in the landmark placements between observers. Intra-observer repeatability was high, with Pearson correlation coefficients ranging from 0.87 to 1.00 for all measurements, and the mean differences were not significant. A third or second degree growth curve could be successfully made for each parameter. CONCLUSIONS: These findings indicated this method could be used for objective clinical evaluation of maxillary growth. CLINICAL RELEVANCE: The resulting growth models can be used for growth studies in healthy newborns and for growth and treatment outcome studies in children with cleft lip and palate or other craniofacial anomalies.
Asunto(s)
Maxilar/crecimiento & desarrollo , Labio Leporino , Fisura del Paladar , Arco Dental/crecimiento & desarrollo , Humanos , Lactante , Recién Nacido , Variaciones Dependientes del Observador , Hueso Paladar/crecimiento & desarrolloRESUMEN
The aim of this study was to assess the influence of surgical therapy, intraoperative evaluation, and immediate physiotherapy on the facial asymmetry of patients with congenital muscular torticollis (CMT). Patients who underwent a combination of unipolar sternocleidomastoid muscle release with perioperative physiotherapy between 2014 and 2020 in the Department of Oral and Maxillofacial Surgery, Radboud University Medical Center, Nijmegen were enrolled. Three-dimensional photographs of the face acquired 2 months preoperatively and 1.5-2 years postoperatively were assessed. Based on 43 patients, there was a significant improvement in the asymmetry indices (angles between bilateral exocanthion, bilateral cheilion, and nasion-gnathion lines): mean ± standard deviation reductions in indices (Ex-Ex)-(Ch-Ch), (Ex-Ex)-(Na-Gn), and (Ch-Ch)-(Na-Gn) of 0.88 ± 1.08° (P < 0.001), 1.04 ± 1.26° (P < 0.001), and 0.21 ± 1.06° (P = 0.024), respectively. Analysis of covariance (ANCOVA) showed that intervention at an early age (P = 0.017) and left-sided torticollis (P = 0.030) were associated with a significantly greater improvement in the facial asymmetry. This study found that the use of combined surgery and physiotherapy reduced the facial asymmetry of patients with CMT at 2 years postoperatively. Early intervention and left-sided torticollis were associated with a greater improvement in the facial asymmetry. This indicates that attention should be given to early intervention and right-sided CMT cases postoperatively.
RESUMEN
The aim of this retrospective study was to determine whether a virtually created occlusion is as accurate as a conventionally created occlusion. Seventeen orthognathic patients were included in the study, which was conducted in a university clinic. Plaster cast models were obtained and digitized. Two experienced observers created the conventional (gold standard) and virtual occlusion to assess inter-observer variability. One observer created the conventional and virtual occlusion a second time to assess the intra-observer variability. The criterion for accepting the virtual occlusion was that the difference between the gold standard and the virtual occlusion was not larger than the intra-observer variability for the gold standard. A non-parametric Kruskal-Wallis H test was performed to detect statistically significant differences between the intra- and inter-observer groups for both the conventional and virtual occlusion. No statistically significant differences were found between the different groups. The difference between the conventional and virtual occlusion group was 0.20mm larger than the intra-observer variability of the gold standard. The virtual occlusion tool presented here can be utilized in daily clinical practice and makes the use of physical dental models redundant.