Guidelines for first responders based on results from deploying a mockup radiological dispersal device.

During the past 7th Security Framework Program the European Commission funded a research project called CATO (CBRN Crisis management, Architectures, Technologies and Operational procedures) to develop a prototype decision support system for crisis management in addition to providing a suite of guidelines for first responders and incident commanders when dealing with chemical, biological, radiological or nuclear incidents. In order to derive these guidelines a proof-of-concept experiment was setup during which several passive agent (Stable CsCl) dispersions with improvised explosive devices and vehicle-borne improvised explosive devices were carried out. Each dispersion was thoroughly characterised by a number of monitoring devices, including high-volume air samplers and size-segregated air samplers. All environmental and forensic samples were collected by the UK counter terrorism police, following strict labelling and chain-of-custody protocols. The samples were analysed at the Belgian Nuclear Research Center suing the k0 method for instrumental neutron activation technique. A full consequence assessment analysis was carried out assuming that the observed concentration of Cs-133 in samples was Cs-137 instead and use was made of the specific activity of Cs-137. Due to the sensitivity of the information the European Commission classified this research. The resulted reported on in this work have been unclassified and are released to assist emergency planners and first responders to take the necessary precautions. The results indicate that, up to distances of 50 m from ground zero radiation levels will be considerable and therefore live-saving actions must be performed by fire/rescue wearing full protective gear. In addition, low-wind conditions will favor a long airborne residence time and therefore the use of full-face protective gear is a must. In order to protect first responders, a radiation protection specialist is to determine how long people can enter and remain in the contaminated area. The recovery of evidence in the case of a car-bomb will be hard or even impossible due to the high level of radioactive material remaining inside the vehicle.

The use of a CZT detector with robotic systems.

This work is focused on the use of a CZT detector for a radiation mapping with an industrial robotic arm. Measurements were carried out within the RadioRoSo experiment (Radioactive Waste Robotic Sorter), under the umbrella of EU FP7 project ECHORD++. In tests with a dual-arm robot and standard point sources of 137Cs and 60Co, a Magnox waste was mimicked. Thereafter, for relevant measurement geometries and selected shielding materials, full energy peak efficiencies were calculated using the MCNP transport code. Simulated FEP efficiency values were used for minimum detectable activity assessments for expected measurement conditions. Obtained results would be also applicable for cases of shielded lost/orphan point-like sources.