Phase-Dependent Phonon Heat Transport in Nanoscale Gallium Oxide Thin Films.

Different phases of Ga2O3 have been regarded as superior platforms for making new-generation high-performance electronic devices. However, understanding of thermal transport in different phases of nanoscale Ga2O3 thin-films remains challenging, owing to the lack of phonon transport models and systematic experimental investigations. Here, thermal conductivity (TC) and thermal boundary conductance (TBC) of the ( 1 ¯ 010 ) $( {\bar 1010} )$ α-, ( 2 ¯ 01 ) $( {\bar 201} )\;$ ß-, and (001) κ-Ga2O3 thin films on sapphire are investigated. At ≈80 nm, the measured TC of α (8.8 W m-1 K-1) is ≈1.8 times and ≈3.0 times larger than that of ß and κ, respectively, consistent with model based on density functional theory (DFT), whereas the model reveals a similar TC for the bulk α- and ß-Ga2O3. The observed phase- and size-dependence of TC is discussed thoroughly with phonon transport properties such as phonon mean free path and group velocity. The measured TBC at Ga2O3/sapphire interface is analyzed with diffuse mismatch model using DFT-derived full phonon dispersion relation. Phonon spectral distribution of density of states, transmission coefficients, and group velocity are studied to understand the phase-dependence of TBC. This study provides insight into the fundamental phonon transport mechanism in Ga2O3 thin films and paves the way for improved thermal management of high-power Ga2O3-based devices.

Mg Doping of N-Polar, In-Rich InAlN.

Metal organic chemical vapor deposition was used to grow N-polar In0.63Al0.37N on sapphire substrates. P-doping was provided by a precursor flow of Cp2Mg between 0 and 130 nmol/min, reaching a Cp2Mg/III ratio of 8.3 × 10-3. The grain structure of 360 nm thick InAlN was spoiled by pits after introducing a flow of CP2Mg at 30 nmol/min. The surface quality was improved with a flow of 80 nmol/min; however, detrimental deterioration appeared at 130 nmol/min. This correlated with the XRD shape and determined density of dislocations, indicating a phase separation at the highest flow. Degenerated n-type conduction and a free carrier concentration of ~1019 cm-3 were determined in all samples, with a minor compensation observed at a CP2Mg flow of 30 nmol/min. The room temperature (RT) electron mobility of ~40 cm2/Vs of the undoped sample was reduced to ~6 and ~0.3 cm2/Vs with a CP2Mg flow of 30 and 80 nmol/min, respectively. Scattering at ionized acceptor/donor Mg-related levels is suggested. RT photoluminescence showed a red shift of 0.22 eV from the virgin 1.73 eV peak value with Mg doping. Mobility degradation was found to be the main factor by InAlN resistivity determination, which increased by two orders of magnitude, approaching ~0.5 Ωcm, at the highest Cp2Mg flow.

In(Ga)N 3D Growth on GaN-Buffered On-Axis and Off-Axis (0001) Sapphire Substrates by MOCVD.

In(Ga)N epitaxial layers were grown on on-axis and off-axis (0001) sapphire substrates with an about 1100 nm-thick GaN buffer layer stack using organometallic chemical vapor deposition at 600 °C. The In(Ga)N layers consisted of a thin (~10-25 nm) continuous layer of small conical pyramids in which large conical pyramids with an approximate height of 50-80 nm were randomly distributed. The large pyramids were grown above the edge-type dislocations which originated in the GaN buffer; the dislocations did not penetrate the large, isolated pyramids. The large pyramids were well crystallized and relaxed with a small quantity of defects, such as dislocations, preferentially located at the contact zones of adjacent pyramids. The low temperature (6.5 K) photoluminescence spectra showed one clear maximum at 853 meV with a full width at half maximum (FWHM) of 75 meV and 859 meV with a FWHM of 80 meV for the off-axis and on-axis samples, respectively.

Structure and Thermal Stability of ε/κ-Ga2O3 Films Deposited by Liquid-Injection MOCVD.

We report on crystal structure and thermal stability of epitaxial ε/κ-Ga2O3 thin films grown by liquid-injection metal−organic chemical vapor deposition (LI-MOCVD). Si-doped Ga2O3 films with a thickness of 120 nm and root mean square surface roughness of ~1 nm were grown using gallium-tetramethylheptanedionate (Ga(thd)3) and tetraethyl orthosilicate (TEOS) as Ga and Si precursor, respectively, on c-plane sapphire substrates at 600 °C. In particular, the possibility to discriminate between ε and κ-phase Ga2O3 using X-ray diffraction (XRD) φ-scan analysis or electron diffraction analysis using conventional TEM was investigated. It is shown that the hexagonal ε-phase can be unambiguously identified by XRD or TEM only in the case that the orthorhombic κ-phase is completely suppressed. Additionally, thermal stability of prepared ε/κ-Ga2O3 films was studied by in situ and ex situ XRD analysis and atomic force microscopy. The films were found to preserve their crystal structure at temperatures as high as 1100 °C for 5 min or annealing at 900 °C for 10 min in vacuum ambient (<1 mBar). Prolonged annealing at these temperatures led to partial transformation to ß-phase Ga2O3 and possible amorphization of the films.