Occurrence of organochlorine pesticides in a tropical lake basin.

This study investigates the presence and distribution of organochlorine pesticides in streams and the lake in the Sembrong Lake Basin in Malaysia. The catchment of Sembrong Lake has been converted to agricultural areas over the past 30 years, with oil palm plantations and modern agricultural farming being the main land use. Surface water samples were collected from eight sites comprising the stream and lake and analysed for 19 organochlorine pesticides (OCPs). In situ measurement of temperature, dissolved oxygen, pH and conductivity were also undertaken at each site. Aldrin, endrin, δ-BHC, 4,4-DDT, methoxychlor and endosulfan were the main OCPs detected in the lake basin. The total OCP concentration ranged between 5.42 and 349.2 ng/L. The most frequently detected OCPs were δ-BHC, heptachlor and aldrin. The maximum values detected were 23.0, 43.2 and 50.4 ng/L respectively. The highest concentration of OCPs was attributed to 4,4-DDT, but such high residue was rare and only detected once. Other OCP residues were low. Significant differences in the mean values were observed between lake and stream for dichlorodiphenyldichloroethylene (DDE) and α-endosulfan concentration (p < 0.05). The highest endosulfan, endrin and methoxychlor residues were found in lake sites, while the highest 4,4,-DDT residues were observed for the river sites. Temporal variation of OCP residues was observed for heptachlor and ß-endosulfan. The highest concentrations of pesticide residues were found in October. DDX and α/É£ ratios indicate possible fresh inputs of the OCP pesticide in the basin.

Association between polychlorinated biphenyl (PCB) and dioxin with metabolic syndrome (METS): a systematic review and meta-analysis.

Polychlorinated biphenyls (PCBs) and dioxin are persistent endocrine disrupting chemicals (EDCs) and have been associated with an increased risk of metabolic syndrome (MetS). The aim of this systematic review and meta-analysis was to assess the associations of PCBs and dioxin with MetS and its risk factors, including obesity, hypertriglyceridaemia (HTG), hypertension (HTN) and diabetes mellitus (DM). We searched three electronic databases for epidemiological studies concerning PCBs and dioxin with MetS published up to the end of 2023. Meta-analysis was performed for MetS itself and each of the MetS risks based on a random-effects meta-analysis model, and odds ratios (ORs) with 95% confidence intervals (CIs) were obtained. Publication bias was assessed based on Egger's test. Eleven studies were included from three databases up to 2023. There were 40,528 participants aged 18-89, where 18-100% of them were males, included in our meta-analysis. The meta-analysis results showed a strong association between PCB exposure and DM (OR = 3.593, 95% CI 2.566, 5.031), while most of the risk factors for MetS, including obesity (OR = 1.875, 95% CI 0.883, 3.979), HTN (OR = 1.335, 95% CI 0.902, 1.976) and HTG (OR = 1.611, 95% CI 0.981, 2.643), were weakly associated with PCB. Furthermore, both PCBs (OR = 1.162, 95% CI 0.994, 1.357) and dioxin (OR = 2.742, 95% CI 1.936, 3.883) were found to be weakly and strongly associated with MetS, respectively. Meta-regression analysis showed that DM in the Asian population is associated with PCB exposure, while HTG in the Northern American population is associated with PCB exposure. Our meta-analysis has demonstrated a strong relationship between DM and PCBs, while the relationship between PCBs with MetS and other risk factors is less pronounced. Additionally, MetS is weakly associated with dioxin exposure. To improve primary care outcomes, healthcare providers should consider incorporating the assessment of patients' risk of exposure to PCBs and dioxins into their evaluation procedures for more targeted medical interventions.

The role of sheet-like TiO2 in polyamide reverse osmosis membrane for enhanced removal of endocrine disrupting chemicals.

Thin film composite (TFC) reverse osmosis (RO) membrane shows good promise for treating wastewater containing endocrine disrupting chemical (EDC) pollutants. The incorporation of functional materials with exceptional structural and physico-chemical properties offers opportunities for the membranes preparation with enhanced permselectivity and better antifouling properties. The present study aims to improve the EDC removal efficiency of TFC RO membrane using two-dimensional titania nanosheets (TNS). RO membrane was prepared by incorporating TNS in the dense layer of polyamide (PA) layer to form thin film nanocomposite (TFN) membrane. The TNS loading was varied and the influences on membrane morphology, surface hydrophilicity, surface charge, as well as water permeability and rejection of EDC were investigated. The results revealed that the inclusion of TNS in the membrane resulted in the increase of water permeability and EDC rejection. When treating the mixture of bisphenol A (BPA) and caffeine at 100 ppm feed concentration, the TFN membrane incorporated with 0.05% TNS achieved water permeability of 1.45 L/m2·h·bar, which was 38.6% higher than that of unmodified TFC membrane, while maintaining satisfactory rejection of >97%. The enhancement of water permeability for TFN membrane can be attributed to their hydrophilic surface and unique nanochannel structure created by the nanoscale interlayer spacing via staking of TiO2 nanosheets. Furthermore, the 0.05TFN membrane exhibited excellent fouling resistance towards BPA and caffeine pollutants with almost 100% flux recovery for three cycles of operations.

Enhanced Removal of Endocrine-Disrupting Compounds from Wastewater Using Reverse Osmosis Membrane with Titania Nanotube-Constructed Nanochannels.

This paper presents a comprehensive study of the performance of a newly developed titania nanotube incorporated RO membrane for endocrine-disrupting compound (EDC) removal at a low concentration. EDCs are known as an emerging contaminant, and if these pollutants are not properly removed, they can enter the water cycle and reach the water supply for residential use, causing harm to human health. Reverse osmosis (RO) has been known as a promising technology to remove EDCs. However, there is a lack of consensus on their performance, especially on the feed concentrations of EDC that vary from one source to another. In this study, polyamide thin-film composite (PA TFC) membrane was incorporated with one-dimensional titania nanotube (TNT) to mitigate trade-off between water permeability and solute rejection of EDC. The characterization indicated that the membrane surface hydrophilicity has been greatly increased with the presence of TNT. Using bisphenol A (BPA) and caffeine as model EDC, the removal efficiencies of the pristine TFC and thin-film nanocomposite (TFN) membranes were evaluated. Compared to TFC membrane, the membrane modified with 0.01% of TNT exhibited improved permeability of 50% and 49% for BPA and caffeine, respectively. A satisfactory BPA rejection of 89.05% and a caffeine rejection of 97.89% were achieved by the TNT incorporated TFN membranes. Furthermore, the greater hydrophilicity and smoother surface of 0.01 TFN membrane led to lower membrane fouling tendency under long-term filtration.

Removal of emerging organic micropollutants via modified-reverse osmosis/nanofiltration membranes: A review.

Hazardous micropollutants (MPs) such as pharmaceutically active compounds (PhACs), pesticides and personal care products (PCPs) have emerged as a critical concern nowadays for acquiring clean and safe water resources. In the last few decades, innumerable water treatment methods involving biodegradation, adsorption and advanced oxidation process have been utilized for the removal of MPs. Of these methods, membrane technology has proven to be a promising technique for the removal of MPs due to its sustainability, high efficiency and cost-effectiveness. Herein, the aim of this article is to provide a comprehensive review regarding the MPs rejection mechanisms of reverse osmosis (RO) and nanofiltration (NF) membranes after incorporation of nanomaterials and also surface modification atop the PA layer. Size exclusion, adsorption and electrostatic charge interaction mechanisms play important roles in governing the MP removal rate. In addition, this review also discusses the state-of-the-art research on the surface modification of thin film composite (TFC) membrane and nanomaterials-incorporated thin film nanocomposite (TFN) membrane in enhancing MPs removal performance. It is hoped that this review can provide insights in modifying the physicochemical properties of NF and RO membranes to achieve better performance in water treatment process, particularly for the removal of emerging hazardous substances.