RESUMEN
Photovoltaic photodiodes often face challenges in effectively harvesting electrical signals, especially when detecting faint light. In contrast, photomultiplication type photodetectors (PM-PDs) are renowned for their exceptional sensitivity to weak signals. Here, an advanced PM-PD is introduced based on quasi 2D Ruddlesden-Popper (Q-2D RP) perovskites, optimized for weak light detection at minimal operating voltages. The abundant traps at the Q-2D RP surface capture charge carriers, inducing a trap-assisted tunneling mechanism that leads to the photomultiplication (PM) effect. Deep-lying trap states within the Q-2D RP bulk accelerate charge carrier recombination, resulting in an outstanding rise/fall time of 1.14/1.72 µs for the PM-PDs. The PM-PD achieves a remarkable response level of up to 45.89 A W-1 and an extraordinary external quantum efficiency of 14400% at -1 V under an illumination of 1 µW cm- 2. The intrinsic high resistance of the Q-2D perovskite results in a low dark current, enabling an impressive detectivity of 4.23 × 1012 Jones based on noise current at -1 V. Furthermore, the practical application of PM-PDs has been demonstrated in weak-light, high-rate communication systems. These findings confirm the significant potential of PM-PDs based on Q-2D perovskites for weak light detection and suggest new directions for developing low-power, high-performance PM-PDs for future applications.
RESUMEN
Achieving high power conversion efficiency in perovskite solar cells (PSCs) heavily relies on fabricating homogeneous perovskite films. However, understanding microscopic-scale properties such as current generation and open-circuit voltage within perovskite crystals has been challenging due to difficulties in quantifying intragrain behavior. In this study, the local current intensity within state-of-the-art perovskite films mapped by conductive atomic force microscopy reveals a distinct heterogeneity, which exhibits a strong anticorrelation to the external biases. Particularly under different external bias polarities, specific regions in the current mapping show contrasting conductivity. Moreover, grains oriented differently exhibit varied surface potentials and currents, leading us to associate this local current heterogeneity with the grain orientation. It was found that the films treated with isopropanol exhibit ordered grain orientation, demonstrating minimized lattice heterogeneity, fewer microstructure defects, and reduced electronic disorder. Importantly, devices exhibiting an ordered orientation showcase elevated macroscopic optoelectronic properties and boosted device performance. These observations underscore the critical importance of fine-tuning the grain homogenization of perovskite films, offering a promising avenue for further enhancing the efficiency of PSCs.