RESUMEN
SignificanceNatural photochromic minerals have been reported by geologists for decades. However, the understanding of the photochromism mechanism has a key question still unanswered: What in their structure gives rise to the photochromism's reversibility? By combining experimental and computational methods specifically developed to investigate this photochromism, this work provides the answer to this fundamental question. The specific crystal structure of these minerals allows an unusual motion of the sodium atoms stabilizing the electronic states associated to the colored forms. With a complete understanding of the photochromism mechanism in hand, it is now possible to design new families of stable and tunable photochromic inorganic materials-based devices.
RESUMEN
Germanium (Ge) is a vital element for applications that operate in near-infrared wavelengths. Recent progress in developing nanostructured Ge surfaces has resulted in >99% absorption in a wide wavelength range (300-1700 nm), promising unprecedented performance for optoelectronic devices. However, excellent optics alone is not enough for most of the devices (e.g. PIN photodiodes and solar cells) but efficient surface passivation is also essential. In this work, we tackle this challenge by applying extensive surface and interface characterization including transmission electron microscopy and x-ray photoelectron spectroscopy, which reveals the limiting factors for surface recombination velocity (SRV) of the nanostructures. With the help of the obtained results, we develop a surface passivation scheme consisting of atomic-layer-deposited aluminum oxide and sequential chemical treatment. We achieve SRV as low as 30 cm s-1combined with â¼1% reflectance all the way from ultraviolet to NIR. Finally, we discuss the impact of the achieved results on the performance of Ge-based optoelectronic applications, such as photodetectors and thermophotovoltaic cells.
RESUMEN
Properties of Ge oxides are significantly different from those of widely used Si oxides. For example, the instability of GeO x at device junctions causes electronic defect levels that degrade the performance of Ge-containing devices (e.g., transistors and infrared detectors). Therefore, the passivating Si layers have been commonly used at Ge interfaces to reduce the effects of Ge oxide instability and mimic the successful strategy of Si oxidation. To contribute to the atomic-scale knowledge and control of oxidation of such Si-alloyed Ge interfaces (O/Si/Ge), we present a synchrotron radiation core-level study of O/Si/Ge, which is combined with scanning probe microscopy measurements. The oxidation processes and electronic properties of O/Si/Ge(100) are examined as functions of Si amount and oxidation doses. In particular, the incorporation of Si into Ge is shown to cause the strengthening of Ge-O bonds and the increase of incorporated oxygen amount in oxide/Ge junctions, supporting that the method is useful to decrease the defect-level densities.
RESUMEN
Radiochromic films are used as position-sensitive dose meters in e.g. medical physics and radiation processing. The currently available films like those based on lithium-10,12-pentacosdiynoate or leucomalachite green are either toxic or non-reusable, or both. There is thus a great need for a sustainable solution for radiochromic detection. In the present work, we present a suitable candidate: hackmanite with the general formula Na8Al6Si6O24(Cl,S)2. This material is known as a natural intelligent material capable of changing color when exposed to ultraviolet radiation or X-rays. Here, we show for the first time that hackmanites are also radiochromic when exposed to alpha particles, beta particles (positrons) or gamma radiation. Combining experimental and computational data we elucidate the mechanism of gamma-induced radiochromism in hackmanites. We show that hackmanites can be used for gamma dose mapping in high dose applications as well as a memory material that has the one-of-a-kind ability to remember earlier gamma exposure. In addition to satisfying the requirements of sustainability, hackmanites are non-toxic and the films made of hackmanite are reusable thus showing great potential to replace the currently available radiochromic films.
Asunto(s)
Dosimetría por Película , Rayos Ultravioleta , Rayos gamma , Rayos XRESUMEN
Low-temperature (LT) passivation methods (<450 °C) for decreasing defect densities in the material combination of silica (SiOx) and silicon (Si) are relevant to develop diverse technologies (e.g., electronics, photonics, medicine), where defects of SiOx/Si cause losses and malfunctions. Many device structures contain the SiOx/Si interface(s), of which defect densities cannot be decreased by the traditional, beneficial high temperature treatment (>700 °C). Therefore, the LT passivation of SiOx/Si has long been a research topic to improve application performance. Here, we demonstrate that an LT (<450 °C) ultrahigh-vacuum (UHV) treatment is a potential method that can be combined with current state-of-the-art processes in a scalable way, to decrease the defect densities at the SiOx/Si interfaces. The studied LT-UHV approach includes a combination of wet chemistry followed by UHV-based heating and preoxidation of silicon surfaces. The controlled oxidation during the LT-UHV treatment is found to provide an until now unreported crystalline Si oxide phase. This crystalline SiOx phase can explain the observed decrease in the defect density by half. Furthermore, the LT-UHV treatment can be applied in a complementary, post-treatment way to ready components to decrease electrical losses. The LT-UHV treatment has been found to decrease the detector leakage current by a factor of 2.
RESUMEN
Oxidation treatment creating a well-ordered crystalline structure has been shown to provide a major improvement for III-V semiconductor/oxide interfaces in electronics. We present this treatment's effects on InSb(111)B surface and its electronic properties with scanning tunneling microscopy and spectroscopy. Possibility to oxidize (111)B surface with parameters similar to the ones used for (100) surface is found, indicating a generality of the crystalline oxidation among different crystal planes, crucial for utilization in nanotechnology. The outcome is strongly dependent on surface conditions and remarkably, the (111) plane can oxidize without changes in surface lattice symmetry, or alternatively, resulting in a complex, semicommensurate quasicrystal-like structure. The findings are of major significance for passivation via oxide termination for nano-structured III-V/oxide devices containing several crystal plane surfaces. As a proof-of-principle, we present a procedure where InSb(111)B surface is cleaned by simple HCl-etching, transferred via air, and post-annealed and oxidized in ultrahigh vacuum.
RESUMEN
InAs crystals are emerging materials for various devices like radio frequency transistors and infrared sensors. Control of oxidation-induced changes is essential for decreasing amounts of the harmful InAs surface (or interface) defects because it is hard to avoid the energetically favored oxidation of InAs surface parts in device processing. We have characterized atomic-layer-deposition (ALD) grown Al2O3/InAs interfaces, preoxidized differently, with synchrotron hard X-ray photoelectron spectroscopy (HAXPES), low-energy electron diffraction, scanning tunneling microscopy, and time-of-flight elastic recoil detection analysis. The chemical environment and core-level shifts are clarified for well-embedded InAs interfaces (12 nm Al2O3) to avoid, in particular, effects of a significant potential change at the vacuum-solid interface. High-resolution As 3d spectra reveal that the Al2O3/InAs interface, which was sputter-cleaned before ALD, includes +1.0 eV shift, whereas As 3d of the preoxidized (3 × 1)-O interface exhibits a shift of -0.51 eV. The measurements also indicate that an As2O3 type structure is not crucial in controlling defect densities. Regarding In 4d measurements, the sputtered InAs interface includes only a +0.29 eV shift, while the In 4d shift around -0.3 eV is found to be inherent for the crystalline oxidized interfaces. Thus, the negative shifts, which have been usually associated with dangling bonds, are not necessarily an indication of such point defects as previously expected. In contrast, the negative shifts can arise from bonding with O atoms. Therefore, specific care should be directed in determining the bulk-component positions in photoelectron studies. Finally, we present an approach to transfer the InAs oxidation results to a device process of high electron mobility transistors (HEMT) using an As-rich III-V surface and In deposition. The approach is found to decrease a gate leakage current of HEMT without losing the gate controllability.