Mid-frequency acoustic localization of breaking waves.

During an experiment in deep water off the coast of Southern California, wind speeds ranged from 10 to 15 m/s and wind forcing produced large breaking waves. A mid-frequency vertical planar hydrophone array recorded underwater ambient noise while an airplane equipped with a high-resolution video camera captured images of the sea surface above the array. Beams of ambient noise between 5 and 6 kHz were projected onto the sea surface and synchronized in space and time with the aerial images. Despite the array's limited azimuthal resolution of the surface, due to its modest 1 m horizontal aperture and relatively deep 130 m deployment depth, concentrated areas of high intensity in the acoustic surface projection were observed to match visible breaking events in the aerial images.

Observations and simulations of caustic formation due to oceanographic fine structure.

An at-sea experiment in deep water was conducted to explore the impact of small-scale sound-speed variability on mid-frequency (1-10 kHz) acoustic propagation. Short-range (1-5 km) acoustic transmissions were sent through the upper ocean (0-200 m) while oceanographic instruments simultaneously measured the ocean environment within 2 km of the single upper turning points of the acoustic transmissions. During these transmissions, acoustic receptions over a 7.875 m vertical line array show closely spaced, sometimes interfering arrivals. Ray and full-wave simulations of the transmissions using nearby sound-speed profiles are compared deterministically to the received acoustic signals. The sensitivity of the acoustic arrivals to the vertical scales of ocean sound speed is tested by comparing the observed and simulated arrival intensity where the sound-speed profile used by the simulation is smoothed to varying scales. Observations and modeling both suggest that vertical fine-scale structures (1-10 m) embedded in the sound-speed profile have strong second derivatives which allow for the formation of acoustic caustics as well as potentially interfering acoustic propagation multipaths.

A Broadband View of the Sea Surface Height Wavenumber Spectrum.

Airborne lidar altimetry can measure the sea surface height (SSH) over scales ranging from hundreds of kilometers to a few meters. Here, we analyze the spectrum of SSH observations collected during an airborne lidar campaign conducted off the California coast. We show that the variance in the surface wave band can be over 20 times larger than the variance at submesoscales and that the observed SSH variability is sensitive to the directionality of surface waves. Our results support the hypothesis that there is a spectral gap between meso-to-submesoscale motions and small-scale surface waves and also indicate that aliasing of surface waves into lower wavenumbers may complicate the interpretation of SSH spectra. These results highlight the importance of better understanding the contributions of different physics to the SSH variability and considering the SSH spectrum as a continuum in the context of future satellite altimetry missions.

Mid-frequency acoustic tracking of breaking waves.

Large surface wave breaking events in deep water are acoustically detectable by beamforming at 5-6 kHz with a mid-frequency planar array located 130 m below the surface. Due to the array's depth and modest 1 m horizontal aperture, wave breaking events cannot be tracked accurately by beamforming alone. Their trajectories are estimated instead by splitting the array into sub-arrays, beamforming each sub-array toward the source, and computing the temporal cross-correlation of the sub-array beams. Source tracks estimated from sub-array cross-correlations match the trajectories of breaking waves that are visible in aerial images of the ocean surface above the array.