Impact of cumulative gain in expertise on the efficiency of handmade cloning in cattle.

The aim of this study was to determine the effects of the cumulative gain in expertise in carrying out handmade cloning (HMC) procedures on embryo yield and pregnancy outcome in cattle. Results from in vitro and in vivo embryo development after HMC during three periods of 7 months, separated by 3-month intervals, were compiled and designated as P1, P2 and P3. Blastocyst yield, morphological quality and stage of development, and pregnancy per embryo transfer (ET) on Day 30 of gestation were compared. Zona-intact oocytes were activated chemically in each experiment replicate, and development of parthenogenetic blastocysts was used as a control measurement of oocyte quality and in vitro culture conditions. A total of 21,231 cumulus-oocyte complexes (COCs) were in vitro-matured, with 5,432, 10,721 and 5078 COCs used in 16, 18 and 10 replicates for P1, P2 and P3, respectively. Cloned blastocyst yields on Day 7 increased from 15.5% (124/798) in P1 to 21.6% (309/1428) and 36.6% (280/764) in P2 and P3, respectively. No differences were observed in blastocyst development of parthenogenetic embryos, which average 30.0, 37.6, and 36.4% in P1, P2, and P3, respectively. A 10-fold higher probability of obtaining cloned blastocysts at more advanced stages of development and of higher morphological grade was seen during P3 compared with P1. Pregnancy per ET on Day 30 also increased with gain in expertise, being 6.7% (2/30), 20.8% (10/48) and 40.0% (24/60) for P1, P2 and P3, respectively. The relative efficiency for the establishment of pregnancies (per total COC) increased from 0.04% (1:2716) in P1 to 0.22% (1:460) in P2, reaching 0.47% (1:212) in P3. Results demonstrated a gradual improvement in in vitro and in vivo embryo development over time after establishment of HMC procedures in the laboratory, highlighting the importance of gaining experience and technical skills on the overall cloning efficiency.

Developmental potential of bovine hand-made clone embryos reconstructed by aggregation or fusion with distinct cytoplasmic volumes.

Animal cloning has been associated with developmental abnormalities, with the level of heteroplasmy caused by the procedure being one of its potential limiting factors. The aim of this study was to determine the effect of the fusion of hemicytoplasts or aggregation of hemiembryos, varying the final cytoplasmic volume, on development and cell density of embryos produced by hand-made cloning (HMC), parthenogenesis or by in vitro fertilization (IVF). One or two enucleated hemicytoplasts were paired and fused with one skin somatic cell. Activated clone and zona-free parthenote embryos and hemiembryos were in vitro cultured in the well-of-the-well (WOW) system, being allocated to one of six experimental groups, on a per WOW basis: single clone or parthenote hemiembryos (1 x 50%); aggregation of two (2 x 50%), three (3 x 50%), or four (4 x 50%) clone or parthenote hemiembryos; single clone or parthenote embryos (1 x 100%); or aggregation of two clone or parthenote embryos (2 x 100%). Control zona-intact parthenote or IVF embryos were in vitro cultured in four-well dishes. Results indicated that the increase in the number of aggregated structures within each WOW was followed by a linear increase in cleavage, blastocyst rate, and cell density. The increase in cytoplasmic volume, either by fusion or by aggregation, had a positive effect on embryo development, supporting the establishment of pregnancies and the birth of a viable clone calf after transfer to recipients. However, embryo aggregation did not improve development on a hemicytoplast basis, except for the aggregation of two clone embryos.