RESUMEN
In this work, we explored the feasibility of the fabrication of PIN light-emitting diodes (LEDs) consisting of heterojunctions of amorphous silicon-carbide (a-Si1-xCx:H) thin films and crystalline silicon wafers (c-Si). The objective is the future development of electro-photonic systems in the same c-Si wafer, containing transistors, sensors, LEDs and waveguides. Two different heterojunction LEDs were fabricated consisting of PIN and PIN+N structures, where a-Si1-xCx:H thin films were used as P-type and I-type layers, while an N-type c-Si substrate was used as an active part of the device. The amorphous layers were deposited by the plasma-enhanced chemical vapor deposition (PECVD) technique at a substrate temperature of 200 °C. The PIN device presented electroluminescence (EL) only in the forward bias, while the PIN+N device presented in both the forward and reverse biases. The EL in reverse bias was possible due to the addition of an N+-type a-Si:H layer between the c-Si substrate and the I-type a-Si1-xCx:H active layer. Likewise, the EL intensity of the PIN+N structure was higher than that of the PIN device in forward bias, indicating that the addition of the N-type a-Si:H layer makes electrons flow more efficiently to the I layer. In addition, both devices presented red EL in the full area, which is observed with the naked eye.
RESUMEN
In this work, we show a correlation between the composition and the microstructural and optical properties of bright and uniform luminescent porous silicon (PSi) films. PSi films were synthesized by electrochemical etching using nitric acid in an electrolyte solution. PSi samples synthesized with nitric acid emit stronger (up to six-fold greater) photoluminescence (PL) as compared to those obtained without it. The PL peak is shifted from 630 to 570 nm by changing the concentration ratio of the HF:HNO3:(EtOH-H2O) electrolyte solution, but also shifts with the excitation energy, indicating quantum confinement effects in the silicon nanocrystals (Si-NCs). X-ray photoelectron spectroscopy analysis shows a uniform silicon content in the PSi samples that emit the strongest PL. High-resolution transmission electron microscopy reveals that the Si-NCs in these PSi samples are about ~2.9 ± 0.76 nm in size and are embedded in a dense and stoichiometric SiO2 matrix, as indicated by the Fourier transform infrared analysis. On the other hand, the PSi films that show PL of low intensity present an abrupt change in the silicon content depth and the formation of non-bridging oxygen hole center defects.
RESUMEN
Two multilayer (ML) structures, composed of five layers of silicon-rich oxide (SRO) with different Si contents and a sixth layer of silicon-rich nitride (SRN), were deposited by low pressure chemical vapor deposition. These SRN/SRO MLs were thermally annealed at 1100 °C for 180 min in ambient N2 to induce the formation of Si nanostructures. For the first ML structure (MLA), the excess Si in each SRO layer was about 10.7 ± 0.6, 9.1 ± 0.4, 8.0 ± 0.2, 9.1 ± 0.3 and 9.7 ± 0.4 at.%, respectively. For the second ML structure (MLB), the excess Si was about 8.3 ± 0.2, 10.8 ± 0.4, 13.6 ± 1.2, 9.8 ± 0.4 and 8.7 ± 0.1 at.%, respectively. Si nanopyramids (Si-NPs) were formed in the SRO/Si substrate interface when the SRO layer with the highest excess silicon (10.7 at.%) was deposited next to the MLA substrate. The height, base and density of the Si-NPs was about 2-8 nm, 8-26 nm and ~6 × 1011 cm-2, respectively. In addition, Si nanocrystals (Si-ncs) with a mean size of between 3.95 ± 0.20 nm and 2.86 ± 0.81 nm were observed for the subsequent SRO layers. Meanwhile, Si-NPs were not observed when the excess Si in the SRO film next to the Si-substrate decreased to 8.3 ± 0.2 at.% (MLB), indicating that there existed a specific amount of excess Si for their formation. Si-ncs with mean size of 2.87 ± 0.73 nm and 3.72 ± 1.03 nm were observed for MLB, depending on the amount of excess Si in the SRO film. An enhanced photoluminescence (PL) emission (eight-fold more) was observed in MLA as compared to MLB due to the presence of the Si-NPs. Therefore, the influence of graded silicon content in SRN/SRO multilayer structures on the formation of Si-NPs and Si-ncs, and their relation to the PL emission, was analyzed.