Emissions of HCFC-22 and HCFC-142b in China during 2018-2021 Inferred from Inverse Modeling.

Hydrochlorofluorocarbons (HCFCs) are transitional substitutes for chlorofluorocarbons (CFCs). However, they still have the capacity to be ozone-depleting substances (ODSs). Therefore, they are scheduled to be phased out in China by 2030 under the Montreal Protocol. The emission estimates of HCFC-22 (CHClF2) and HCFC-142b (CH3CClF2) in China using atmospheric observations are lacking after 2017, making it hard to understand the effectiveness of the phase-out process of HCFCs in China. Here, we use flask and in situ measurements of HCFC-22 and HCFC-142b during 2018-2021 and inverse modeling to determine the emission magnitude and changes in China. It was determined that China's emissions were 172 ± 40, 154 ± 39, 160 ± 22, and 155 ± 33 Gg yr-1 of HCFC-22 and 8.3 ± 1.8, 7.8 ± 1.6, 7.4 ± 1.7, and 7.9 ± 1.7 Gg yr-1 of HCFC-142b from 2018 to 2021, respectively. Top-down estimates show that HCFC-22 emissions in China were stable, while HCFC-142b emissions were decreasing during 2013-2021, although both substances were in the stage of being phased out during 2013-2021. This study reveals that 46 and 39% of the global HCFC-22 and HCFC-142b emissions, respectively, cannot be traced to certain countries in 2020. We suggest that more studies on HCFC emissions around the world in the future are needed to better safeguard the ozone layer recovery and climate mitigation by ensuring compliance with the Montreal Protocol during HCFC phase-out processes.

Assessment of the osteogenic effect after maxillary sinus floor elevation and simultaneous implantation with or without bone grafts by analyzing trabecular bone parameters: a retrospective study.

OBJECTIVE: The aim of this population-based retrospective study was to compare the osteogenic effect of newly formed bone after maxillary sinus floor elevation (MSFE) and simultaneous implantation with or without bone grafts by quantitatively analyzing trabecular bone parameters. METHODOLOGY: A total of 100 patients with missing posterior maxillary teeth who required MSFE and implantation were included in this study. Patients were divided into two groups: the non-graft group (n=50) and the graft group (n=50). Radiographic parameters were measured using cone beam computed tomography (CBCT), and the quality of newly formed bone was analyzed by assessing trabecular bone parameters using CTAn (CTAnalyzer, SkyScan, Antwerp, Belgium) software. RESULTS: In the selected regions of interest, the non-graft group showed greater bone volume/total volume (BV/TV), bone surface/total volume (BS/TV), trabecular number (Tb. N), and trabecular thickness (Tb. Th) than the graft group (p<0.001). The non-graft group showed lower trabecular separation (Tb. Sp) than the graft group (p<0.001). The incidence of perforation and bleeding was higher in the graft group than in the non-graft group (p<0.001), but infection did not significantly differ between groups (p>0.05). Compared to the graft group, the non-graft group showed lower postoperative bone height, gained bone height and apical bone height (p<0.001). CONCLUSION: MSFE with and without bone grafts can significantly improve bone formation. In MSFE, the use of bone grafts hinders the formation of good quality bone, whereas the absence of bone grafts can generate good bone quality and limited bone mass.

Cervical vertigo due to rotational fixation of atlantoaxial joint combined with benign paroxysmal positional vertigo: A case report and literature review.

INTRODUCTION: Vertigo is the most common clinical complaint, misdiagnosed patients are not rare, so it is very important to exclude and identify vertigo. For vertigo caused by multiple causes, including cervical vertigo with atlantoaxial rotation fixation combined with benign paroxysmal positional vertigo (BPPV), tuina can correct joint misalignment. The reduction technique will return the fallen otolith to the correct position. The use of massage and reduction can improve clinical symptoms and improve quality of life and may be a simple, safe, and effective treatment strategy for this disease. PATIENT CONCERNS: We report on a patient with both cervical vertigo due to atlantoaxial rotational fixation and BPPV, including his imaging examination, clinical manifestations, and treatment methods. DIAGNOSIS: Cervical vertigo (atlantoaxial rotatory fixation) and BPPV. INTERVENTION: Tuina combined with atlantoaxial directional inverted reduction technique and reduction manipulation. OUTCOMES: The patient's vertigo symptoms improved significantly, nystagmus disappeared, cervical occipital pain, nausea, head distension, and other symptoms disappeared, and cervical motion rotation reached 60°. CONCLUSION: This study proved the effectiveness of massage combined with a reduction in the treatment of cervical vertigo and BPPV, as well as the importance of vertigo diagnosis and differential diagnosis, and provided a new treatment idea for the future diagnosis and treatment of vertigo caused by a variety of causes.

Atomic reconstruction for realizing stable solar-driven reversible hydrogen storage of magnesium hydride.

Reversible solid-state hydrogen storage of magnesium hydride, traditionally driven by external heating, is constrained by massive energy input and low systematic energy density. Herein, a single phase of Mg2Ni(Cu) alloy is designed via atomic reconstruction to achieve the ideal integration of photothermal and catalytic effects for stable solar-driven hydrogen storage of MgH2. With the intra/inter-band transitions of Mg2Ni(Cu) and its hydrogenated state, over 85% absorption in the entire spectrum is achieved, resulting in the temperature up to 261.8 °C under 2.6 W cm-2. Moreover, the hydrogen storage reaction of Mg2Ni(Cu) is thermodynamically and kinetically favored, and the imbalanced distribution of the light-induced hot electrons within CuNi and Mg2Ni(Cu) facilitates the weakening of Mg-H bonds of MgH2, enhancing the "hydrogen pump" effect of Mg2Ni(Cu)/Mg2Ni(Cu)H4. The reversible generation of Mg2Ni(Cu) upon repeated dehydrogenation process enables the continuous integration of photothermal and catalytic roles stably, ensuring the direct action of localized heat on the catalytic sites without any heat loss, thereby achieving a 6.1 wt.% H2 reversible capacity with 95% retention under 3.5 W cm-2.

CCl4 emissions in eastern China during 2021-2022 and exploration of potential new sources.

According to the Montreal Protocol, the production and consumption of ozone-layer-depleting CCl4 for dispersive applications was globally phased out by 2010, including China. However, continued CCl4 emissions were disclosed, with the latest CCl4 emissions unknown in eastern China. In the current study, based on the atmospheric measurements of ~12,000 air samples taken at two sites in eastern China, the 2021-2022 CCl4 emissions are quantified as 7.6 ± 1.7 gigagrams per year. This finding indicates that CCl4 emissions continued after being phased out for dispersive uses in 2010. Subsequently, our study identifies potential industrial sources (manufacture of general purpose machinery and manufacture of raw chemical materials, and chemical products) of CCl4 emissions.

Assessment of the osteogenic effect after maxillary sinus floor elevation and simultaneous implantation with or without bone grafts by analyzing trabecular bone parameters: a retrospective study

Abstract Objective: The aim of this population-based retrospective study was to compare the osteogenic effect of newly formed bone after maxillary sinus floor elevation (MSFE) and simultaneous implantation with or without bone grafts by quantitatively analyzing trabecular bone parameters. Methodology: A total of 100 patients with missing posterior maxillary teeth who required MSFE and implantation were included in this study. Patients were divided into two groups: the non-graft group (n=50) and the graft group (n=50). Radiographic parameters were measured using cone beam computed tomography (CBCT), and the quality of newly formed bone was analyzed by assessing trabecular bone parameters using CTAn (CTAnalyzer, SkyScan, Antwerp, Belgium) software. Results: In the selected regions of interest, the non-graft group showed greater bone volume/total volume (BV/TV), bone surface/total volume (BS/TV), trabecular number (Tb. N), and trabecular thickness (Tb. Th) than the graft group (p<0.001). The non-graft group showed lower trabecular separation (Tb. Sp) than the graft group (p<0.001). The incidence of perforation and bleeding was higher in the graft group than in the non-graft group (p<0.001), but infection did not significantly differ between groups (p>0.05). Compared to the graft group, the non-graft group showed lower postoperative bone height, gained bone height and apical bone height (p<0.001). Conclusion: MSFE with and without bone grafts can significantly improve bone formation. In MSFE, the use of bone grafts hinders the formation of good quality bone, whereas the absence of bone grafts can generate good bone quality and limited bone mass.