How Different is the Core of

The structure of a neutron-rich ^{25}F nucleus is investigated by a quasifree (p,2p) knockout reaction at 270A MeV in inverse kinematics. The sum of spectroscopic factors of π0d_{5/2} orbital is found to be 1.0±0.3. However, the spectroscopic factor with residual ^{24}O nucleus being in the ground state is found to be only 0.36±0.13, while those in the excited state is 0.65±0.25. The result shows that the ^{24}O core of ^{25}F nucleus significantly differs from a free ^{24}O nucleus, and the core consists of ∼35% ^{24}O_{g.s.}. and ∼65% excited ^{24}O. The result may infer that the addition of the 0d_{5/2} proton considerably changes neutron structure in ^{25}F from that in ^{24}O, which could be a possible mechanism responsible for the oxygen dripline anomaly.

A Shiga toxin-producing Escherichia coli O157 outbreak associated with consumption of rice cakes in 2011 in Japan.

In May 2011, an outbreak of Shiga toxin-producing Escherichia coli (STEC) O157 was reported from Yamagata Prefecture, Japan. Investigations, including a case-control study, revealed that the outbreak was linked to two varieties of rice cakes produced by a local manufacturer between 2 and 7 May. Active and passive surveillance identified 136 suspected cases, 142 confirmed cases, 26 asymptomatic cases, and 25 secondary cases. While no environmental samples taken from the manufacturing premises tested positive for STEC, other than a stool sample taken from one employee, on-site and epidemiological investigations indicated that STEC was introduced during the manufacturing process of rice cakes rather than through contamination of raw materials. This was the first reported outbreak of STEC associated with cakes and confectionery in Japan, which indicates that contamination and outbreaks of STEC can occur in any food unless proper precautions are taken.

Ion-production efficiency of a singly charged ion source developed toward a 11C irradiation facility for cancer therapy.

The ion-production efficiency of a newly developed singly charged ion source (SCIS) has been investigated to discuss the possibility of it being used in an isotope separation on-line system that provides 11C ions for heavy-ion cancer therapy with simultaneous verification of the irradiation field using positron emission tomography. The SCIS uses a low-energy hollow electron beam to produce singly charged carbon ions efficiently. To deliver sufficient 11C ions to the treatment room from a limited amount of 11C molecules, which are produced from a boron compound target and proton-beam irradiation via the 11B(p,n)11C reaction, the SCIS must have high ion-production efficiency. To realize this high efficiency, the SCIS was designed using a three-dimensional particle-in-cell code in previous work. With the fabricated SCIS, we performed experiments to measure the efficiency of producing CO2 + ions from nonradioactive 12CO2 molecules and C+ ions from nonradioactive 12CH4 molecules. We found that the SCIS achieved efficiencies of εC+ =4×10-3 (0.4%) for C+ production and εCO2 + =0.107 (10.7%) for CO2 + production.

Singly charged ion source designed using three-dimensional particle-in-cell method.

A singly charged ion source (SCIS) has been designed using a newly developed three-dimensional particle-in-cell (PIC) code. The SCIS is to be used in an isotope separation on-line (ISOL) system that provides 11C ions for heavy-ion cancer therapy with simultaneous verification of the dose distribution using positron emission tomography. The SCIS uses low-energy electron beams to produce singly charged carbon ions efficiently and maintain a high vacuum in the ISOL system. Because the SCIS has to realize a production efficiency of 1% if its carbon ions are to be used in the ISOL system, a suitable design for the SCIS was investigated by using the developed PIC code to study the beam trajectories of the electrons and extracted ions. The simulation results show that hollow electron beams are produced in the designed SCIS resulting in a high effective electron current. The results also predict that the designed SCIS would realize ion-production efficiencies (IPEs) of ε SCIS ≃ 6.7% for C O 2 + production from CO2 gas and ε SCIS ≃ 0.1% for C+ production from CH4 gas. Moreover, to examine the validity of the developed code and confirm that the SCIS was able to be designed appropriately, the space-charge-limited current of the electron gun and the total IPE obtained by adding the IPEs of each ion were compared between the experiment and the simulation.

A singly charged ion source for radioactive ¹¹C ion acceleration.

A new singly charged ion source using electron impact ionization has been developed to realize an isotope separation on-line system for simultaneous positron emission tomography imaging and heavy-ion cancer therapy using radioactive (11)C ion beams. Low-energy electron beams are used in the electron impact ion source to produce singly charged ions. Ionization efficiency was calculated in order to decide the geometric parameters of the ion source and to determine the required electron emission current for obtaining high ionization efficiency. Based on these considerations, the singly charged ion source was designed and fabricated. In testing, the fabricated ion source was found to have favorable performance as a singly charged ion source.

Cryogenic molecular separation system for radioactive (11)C ion acceleration.

A (11)C molecular production/separation system (CMPS) has been developed as part of an isotope separation on line system for simultaneous positron emission tomography imaging and heavy-ion cancer therapy using radioactive (11)C ion beams. In the ISOL system, (11)CH4 molecules will be produced by proton irradiation and separated from residual air impurities and impurities produced during the irradiation. The CMPS includes two cryogenic traps to separate specific molecules selectively from impurities by using vapor pressure differences among the molecular species. To investigate the fundamental performance of the CMPS, we performed separation experiments with non-radioactive (12)CH4 gases, which can simulate the chemical characteristics of (11)CH4 gases. We investigated the separation of CH4 molecules from impurities, which will be present as residual gases and are expected to be difficult to separate because the vapor pressure of air molecules is close to that of CH4. We determined the collection/separation efficiencies of the CMPS for various amounts of air impurities and found desirable operating conditions for the CMPS to be used as a molecular separation device in our ISOL system.

Study on work load of matrons under shift work in a special nursing home for the elderly.

In order to find out the work load of matrons under shift work in a special nursing home for the elderly (SNH), six healthy female matrons volunteered to participate in the present study. For each subject, care working time, heart rate, walking steps, estimated energy expenditure and working time in different postures were determined during day shift work (540 min) and night shift work (960 min). Although the time on duty, working and recess were significantly longer in night shift work than day shift work, the percentages of working and recess time to duty time were nearly the same regardless of shift work. The longest care work in each shift work was individual care of residents in the SNH. The maximum, minimum and mean heart rate and percentages to estimated maximal heart rate were similar in each shift work. Although total walking steps in night shift work were significantly larger than those in day shift work, steps per hour did not differ between them. The estimated total energy expenditure (kcal) was significantly higher in night shift work than in day shift work; however, the work intensity (kcal/kg/min) was significantly higher in day shift work. The longest length and larger percentage of working time were observed in standing posture in each shift work. These findings suggest that physical activity and energy expenditure of matrons under either shift work in the SNH seem to be high. Further studies are needed to clarify the work load of matrons engaged in SNH to formulate countermeasures.

Effects of room temperature, seasonal condition and food intake on finger skin temperature during cold exposure test for diagnosing hand-arm vibration syndrome.

For diagnosing the hand-arm vibration syndrome, peripheral circulation and sensory tests immersing one hand in cold water at 10 degrees C for 10 min have been performed widely in Japan. The authors investigated the effects of room temperature, seasonal condition and food intake on the test results, especially finger skin temperature. Six healthy males were examined repeatedly under six different room temperatures at 10 degrees C, 15 degrees C, 20 degrees C, 22.5 degrees C, 25 degrees C and 30 degrees C. Eight healthy males were examined under room temperatures at 10 degrees C, 20 degrees C and 30 degrees C, repeatedly in winter, spring, summer and autumn. Six healthy males were examined in summer under room temperature at 22.5 degrees C repeatedly 1 hr after, 3 hr after meal and after fasting for 13 hr. The finger skin temperature was strongly affected by room temperature. The finger skin temperature was also affected by seasonal condition. No remarkable effect of food intake was observed. For estimating circulatory function of the upper extremities using the finger skin temperature, the room temperature should be strictly controlled and the effect of seasonal condition must be taken into consideration.

Heart rate variability in response to psychological test in hand-arm vibration syndrome patients assessed by frequency domain analysis.

To investigate heart rate variability in response to psychological tests (Japanese version of Stroop color word test and mirror drawing test) in 29 hand-arm vibration syndrome (HAVS) patients, 16 of them with vibration-induced white finger (VWF) and 13 without VWF, and 10 healthy controls of similar age, heart rate variability during spontaneous and deep (6 cycles a minute) breathing in supine position before and after exposure to the psychological tests was examined calculating frequency domain components such as low frequency (LF) power-index of both the sympathetic and parasympathetic activity, high frequency (HF) power-index of the parasympathetic activity and LF/HF-index of the sympathovagal balance. The group of all patients and the group without VWF indicated significant increase in LF/HF in the deep breathing measurement after exposure to the psychological tests. The result suggests that the sympathetic tone in the sympathovagal balance predominated in the HAVS patients which means that they had larger sensitivity of the sympathetic nervous system to the psychological tests.

Determination of mechanical properties of impacted human morsellized cancellous allografts for revision joint arthroplasty.

This paper deals with the characterization of mechanical properties of impacted morsellized cancellous allograft (IMCA) produced by dynamic compaction of allograft femoral heads ground by commercially available bone mills, i.e. rotating rasp and reciprocating type bone mills. Various ranges and profiles of particle size in the graft aggregates were obtained using these bone mills, and the effect of number of compaction as well as the distribution of particle sizes on the mechanical properties of IMCA under quasistatic compression and shear loading conditions was discussed. The morsellized cancellous allograft prepared by the reciprocating type bone mill showed a broad distribution of particle sizes, and gave IMCA superior mechanical properties to the graft with a more uniform size distribution, or prepared by the rotating rasp type bone mills. The increase of number of compaction also improved the mechanical properties of IMCA in compression.