Implementing a completely autotrophic nitrogen removal over nitrite process using a novel umbrella basalt fiber carrier.

The completely autotrophic nitrogen removal over nitrite (CANON) process is significantly hindered by prolonged start-up periods and unstable nitrogen removal efficiency. In this study, a novel umbrella basalt fiber (BF) carrier with good biological affinity and adsorption performance was used to initiate the CANON process. The CANON process was initiated on day 64 in a sequencing batch reactor equipped with umbrella BF carriers. During this period, the influent NH4+-N concentration gradually increased from 100 to 200 mg·L-1, and the dissolved oxygen was controlled below 0.8 mg L-1. Consequently, an average ammonia nitrogen removal efficiency (ARE) and total nitrogen removal efficiency (TNRE) of ∼90 and 80% were achieved, respectively. After 130 days, ARE and TNRE remained stable at 92 and 81.1%, respectively. This indicates a reliable method for achieving rapid start-up and stable operation of the CANON process. Moreover, Candidatus Kuenenia and Candidatus Brocadia were identified as dominant anammox genera on the carrier. Nitrosomonas was the predominant genus among ammonia-oxidizing bacteria. Spatial differences were observed in the microbial population of umbrella BF carriers. This arrangement facilitated autotrophic nitrogen removal in a single reactor. This study indicates that the novel umbrella BF carrier is a highly suitable biocarrier for the CANON process.

Rapid cultivation of anammox sludge based on Ca-alginate cell beads.

Current gel entrapment technology has certain advantages for the enrichment of anammox sludge. In this study, the optimal preparation conditions and cultivation equipment of Ca-alginate cell beads for the culturing anammox sludge were proposed. The preparation parameters of the Ca-alginate cell beads were as follows: 3% sodium alginate, 4% CaCl2, VSA:Vcell = 1:1, a drop height of 9 cm, stirring speed of 300 rpm, and cross-linking time of 24 h. The prepared cell beads were regular spheres with a uniform size and hard texture. Throughout the 9 days of cultivation, the number of anammox bacteria in the Ca-alginate cell beads was 4.3 times that of the initial sludge, and the color of the cell beads changed from yellowish-brown to reddish-brown. Scanning electron microscopy (SEM) analysis showed that the SA gel beads had a good microporous structure. The fluorescence in situ hybridization (FISH) results illustrated that the bacteria were mostly dispersed inside the Ca-alginate cell beads. Additionally, the qPCR results implied that only a relatively small amount of anammox biomass (2.74×106 copies/gel-bead) was required to quickly start the anammox process. The anammox bacteria in the Ca-alginate cell beads grew with a fast growth rate in a short period and exhibited high activity due to diffusion limitations. In addition, the anammox bacteria cultivated in the Ca-alginate cell beads could adapt to the increase in substrate concentration in a short period. The optimal incubation time of this gel entrapment method for anammox sludge was no more than 17 days under the experimental conditions of this work. Therefore, this simple and practicable gel entrapment method may serve as a suitable pre-culture means for the rapid enrichment of anammox bacteria.