RESUMEN
Superior fast charging is a desirable capability of lithium-ion batteries, which can make electric vehicles a strong competition to traditional fuel vehicles. However, the slow transport of solvated lithium ions in liquid electrolytes is a limiting factor. Here, a Lix Cu6 Sn5 intermetallic network is reported to address this issue. Based on electrochemical analysis and X-ray photoelectron spectroscopy mapping, it is demonstrated that the reported intermetallic network can form a high-speed solid-state lithium transport matrix throughout the electrode, which largely reduces the lithium-ion-concentration polarization effect in the graphite anode. Employing this design, superior fast-charging graphite/lithium cobalt oxide full cells are fabricated and tested under strict electrode conditions. At the charging rate of 6 C, the fabricated full cells show a capacity of 145 mAh g-1 with an extraordinary capacity retention of 96.6%. In addition, the full cell also exhibits good electrochemical stability at a high charging rate of 2 C over 100 cycles (96.0% of capacity retention) in comparison to traditional graphite-anode-based cells (86.1% of capacity retention). This work presents a new strategy for fast-charging lithium-ion batteries on the basis of high-speed solid-state lithium transport in intermetallic alloy hosts.
RESUMEN
Extremely fast-charging lithium-ion batteries are highly desirable to shorten the recharging time for electric vehicles, but it is hampered by the poor rate capability of graphite anodes. Here, we present a previously unreported particle size and electrode porosity dual-gradient structure design in the graphite anode for achieving extremely fast-charging lithium ion battery under strict electrode conditions. We develop a polymer binder-free slurry route to construct this previously unreported type particle size-porosity dual-gradient structure in the practical graphite anode showing the extremely fast-charging capability with 60% of recharge in 10 min. On the basis of dual-gradient graphite anode, we demonstrate extremely fast-charging lithium ion battery realizing 60% recharge in 6 min and high volumetric energy density of 701 Wh liter-1 at the high charging rate of 6 C.
RESUMEN
Using highly dispersed metal fluoride nanoparticles to construct a uniform fluorinated alloy type interfacial layer on the surface of Li metal anodes is realized by an ex situ solution chemical modification method. The fluorinated alloy-type interfacial layer can effectively inhibit the growth of undesirable Li dendrites while enhancing the performance of Li metal anodes.
RESUMEN
Two-dimensional (2D) boron nitride nanosheets (BNNSs) were chemically exfoliated from bulk boron nitride and coated onto the surface of a poly(ethylene oxide) (PEO)-based electrolyte through a dry-pressing transfer process. The fabricated BNNSs coating formed a robust interfacial layer to improve the chemical and mechanical stability of the PEO-based electrolyte, leading to the enhanced performance of solid-state Li metal batteries.