Fructose-2,6-bisphosphate counteracts guanidinium chloride-, thermal-, and ATP-induced dissociation of skeletal muscle key glycolytic enzyme 6-phosphofructo-1-kinase: A structural mechanism for PFK allosteric regulation.

Rabbit muscle 6-phosphofructo-1-kinase (PFK) is the key glycolytic enzyme being regulated by diverse molecules and signals. This enzyme may undergo a reversible dissociation from a fully active homotetramer to a quite inactive dimer. There are evidences that some positive and negative modulators of PFK, such as ADP and citrate, may interfere with the enzyme oligomeric structure shifting the tetramer-dimer equilibrium towards opposite orientations, where the negative modulators favor the dissociation of tetramers into dimers and vice versa. PFK is allosterically inhibited by ATP at its physiological range of concentration, an effect counteracted by fructose-2,6-bisphosphate (F2,6BP). However, the structural molecular mechanism by which ATP and F2,6BP regulate PFK is hitherto demonstrated. The present paper aimed at demonstrating that either the ATP-induced inhibition of PFK and the reversion of this inhibition by F2,6BP occur through the same molecular mechanism, i.e., the displacement of the oligomeric equilibrium of the enzyme. This conclusion is arrived assessing the effects of ATP and F2,6BP on PFK inactivation through two distinct ways to dissociate the enzyme: (a) upon incubation at 50 degrees C, or (b) incubating the enzyme with guanidinium hydrochloride (GdmCl). Our results reveal that temperature- and GdmCl-induced inactivation of PFK prove remarkably more effective in the presence 5mM ATP than in the absence of additives. On the other hand, the presence of 100 nM F2,6BP attenuate the effects of both high-temperature exposition and GdmCl on PFK, even in the simultaneous presence of 5mM ATP. These data support the hypothesis that ATP shifts the oligomeric equilibrium of PFK towards the smaller conformations, while F2,6BP acts in the opposite direction. This conclusion leads to important information about the molecular mechanism by which PFK is regulated by these modulators.

Application of toxicity identification evaluation to sediment in a highly contaminated water reservoir in southeastern Brazil.

Rasgão Reservoir, located close to the Metropolitan region of São Paulo, Brazil, has been analyzed previously, and its sediment was found to be highly toxic, with high levels of metals and polycyclic aromatic hydrocarbons and a complete absence of benthic life. Polychlorinated biphenyls also were present, as was mutagenic activity, detected with the Salmonella/microsome assay. Because of the extremely complex mixture of contaminants in these sediments, a toxicity identification evaluation was performed on the pore water and elutriate using Ceriodaphnia dubia and Vibrio fischeri. Toxicity characterization, identification, and confirmation procedures were performed in one representative sample of the reservoir, and the results indicated that ammonia was the main cause of the toxicity detected with C. dubia in both sediment pore water and elutriate. Chemical analysis corroborated this observation by revealing un-ionized ammonia concentrations as high as 5.14 mg/L in pore water and 2.06 mg/L in elutriate. These high ammonia levels masked possible toxicity caused by other classes of compounds. The toxicity detected with V. fischeri decreased with the time of sample storage and was related to the organic fraction of the pore water and the elutriate, in which compounds such as benzothiazole and nonylphenol were detected.

A preliminary nationwide survey of the presence of emerging contaminants in drinking and source waters in Brazil.

This is the first nationwide survey of emerging contaminants in Brazilian waters. One hundred drinking water samples were investigated in 22 Brazilian state capitals. In addition, seven source water samples from two of the most populous regions of the country were evaluated. Samples were collected from June to September of 2011 and again during the same period in 2012. The study covered emerging contaminants of different classes, including hormones, plasticizers, herbicides, triclosan and caffeine. The analytical method for the determination of the compounds was based on solid-phase extraction followed by analysis via liquid chromatography electrospray triple-quadrupole mass spectrometry (LC-MS/MS). Caffeine, triclosan, atrazine, phenolphthalein and bisphenol A were found in at least one of the samples collected in the two sampling campaigns. Caffeine and atrazine were the most frequently detected substances in both drinking and source water. Caffeine concentrations in drinking water ranged from 1.8ngL-1 to values above 2.0µgL-1 while source-water concentrations varied from 40ngL-1 to about 19µgL-1. For atrazine, concentrations were found in the range from 2.0 to 6.0ngL-1 in drinking water and at concentrations of up to 15ngL-1 in source water. The widespread presence of caffeine in samples of treated water is an indication of the presence of domestic sewage in the source water, considering that caffeine is a compound of anthropogenic origin.

Demystifying "oxi" cocaine: Chemical profiling analysis of a "new Brazilian drug" from Acre State.

Recent information from various sources suggests that a new illicit drug, called "oxi", is being spread across Brazil. It would be used in the smoked form and it would look like to crack cocaine: usually small yellowish or light brown stones. As fully released in the media, "oxi" would differ from crack cocaine in the sense that crack would contain carbonate or bicarbonate salts whereas "oxi" would include the addition of calcium oxide and kerosene (or gasoline). In this context, this work presents a chemical profiling comparative study between "oxi" street samples seized by the Civil Police of the State of Acre (CP/AC) and samples associated with both international and interstate drug trafficking seized by the Brazilian Federal Police in Acre (FP/AC). The outcome of this work assisted Brazilian authorities to stop inaccurate and alarmist releases on this issue. It may be of good use by the forensic community in order to better understand matters in their efforts to guide local law enforcement agencies in case such claims reach the international illicit market.

Development of the permeability/performance reference compound approach for in situ calibration of semipermeable membrane devices.

Permeability/performance reference compounds (PRCs) are analytically noninterfering organic compounds with moderate to high fugacity from semipermeable membrane devices (SPMDs) that are added to the lipid prior to membrane enclosure. Assuming that isotropic exchange kinetics (IEK) apply and that SPMD-water partition coefficients are known, measurement of PRC dissipation rate constants during SPMD field exposures and laboratory calibration studies permits the calculation of an exposure adjustment factor (EAF). In theory, PRC-derived EAF ratios reflect changes in SPMD sampling rates (relative to laboratory data) due to differences in exposure temperature, membrane biofouling, and flow velocity-turbulence at the membrane surface. Thus, the PRC approach should allow for more accurate estimates of target solute/vapor concentrations in an exposure medium. Undersome exposure conditions, the impact of environmental variables on SPMD sampling rates may approach an order of magnitude. The results of this study suggest that most of the effects of temperature, facial velocity-turbulence, and biofouling on the uptake rates of analytes with a wide range of hydrophobicities can be deduced from PRCs with a much narrower range of hydrophobicities. Finally, our findings indicate that the use of PRCs permits prediction of in situ SPMD sampling rates within 2-fold of directly measured values.

Contaminaçäo atmosférica num centro cirúrgico por compostos orgânicos voláteis e dióxido de carbono / Surgical center air contamination by volatile organic compounds and carbon dioxide

Justificativa e objetivos: a contaminaçäo ambiental por anestésicos inalatórios, CO2 e éter etílico podem ocasionar alguns sintomas de desconforto ocupacional. O objetivo deste estudo foi verificar a concentraçäo destes compostos, frente à diferentes condiçöes de ventilaçäo no Centro Cirúrgico do Centro de Atençäo Integral à Saúde da Mulher (CAISM), Hospital da UNICAMP. Método: foram colhidas amostras de ar, em diversos locais do Centro Cirúrgico e em diferentes horários do dia. O CO2 foi determinado através de um sistema de Análise por Injeçäo em Fluxo de detecçäo condutométrica, enquanto os compostos orgânicos foram determinados por cromatografia gasosa. A qualidade do ar foi monitorada na primavera, sob duas condiçöes distintas de ventilaçäo: Baixa Taxa de Ventilaçäo (BTV) e Altas Taxas de Ventilaçäo (ATV). Resultados: sob BTV, o CO2 variou entre 703-1973 ppmv e o éter etílico variou entre 5-20 ppmv, enquanto que sob ATV, o CO2 variou entre 428-1596 ppmv e o éter etílico entre 4-13 ppmv. Entre os anestésicos, o isoflurano foi o único detectado, apenas sob BTV, em concentraçöes que variam de 4 a 15 ppmv. Conclusöes: sob ATV, as concentraçöes atmosféricas dos compostos estudados estäo todas abaixo dos níveis máximos. O CO2 pode ser um bom indicativo da qualidade de ar interno de um hospital e útil para se inferir a velocidade de ventilaçäo ambiental