ABSTRACT
The luminescence properties of green Ba4Si6O16:Eu2+, rare-earths (RE) (RE = Sc, Y, La and Lu except Pm) phosphors are reported. Their long-lasting phosphorescence is discussed in view of trap depths and concentrations determined from thermally stimulated luminescence experiments. A second emission band centered at 439 nm was evidenced at low temperatures, which stems from the substitution of Eu2+ in the two non-equivalent Ba2+ sites of Ba4Si6O16. The mechanoluminescence properties of Ba4Si6O16:Eu2+, RE phosphors are described, and a new mechanoluminescence mechanism is proposed, in the case where RE = Ho3+, involving a trap distribution from 0.694 to 0.924 eV. Mechanical loading (post UV irradiation) induces a decrease in depth of the trap distribution, leading to an increase of the luminescence intensity, whereas a drop of the luminescence intensity is observed upon unloading, following the faster release of the charge carriers.
ABSTRACT
Cerium-doped-silica glasses are widely used as ionizing radiation sensing materials. However, their response needs to be characterized as a function of measurement temperature for application in various environments, such as in vivo dosimetry, space and particle accelerators. In this paper, the temperature effect on the radioluminescence (RL) response of Cerium-doped glassy rods was investigated in the 193-353 K range under different X-ray dose rates. The doped silica rods were prepared using the sol-gel technique and spliced into an optical fiber to guide the RL signal to a detector. Then, the experimental RL levels and kinetics measurements during and after irradiation were compared with their simulation counterparts. This simulation is based on a standard system of coupled non-linear differential equations to describe the processes of electron-hole pairs generation, trapping-detrapping and recombination in order to shed light on the temperature effect on the RL signal dynamics and intensity.
ABSTRACT
The purpose of this work is to assess eight detectors performance for output factor (OF), percent depth dose (PDD), and beam profiles in a 6-MV Clinac stereotactic radiosurgery mode for cone irradiation using Monte Carlo simulation as reference. Cones with diameters comprised between 30 and 4 mm have been studied. The evaluated detectors were ionization chambers: pinpoint and pinpoint 3D, diodes: SRS, P and E, Edge, MicroDiamond and EBT3 radiochromic films. The results showed that pinpoints underestimate OF up to -2.3% for cone diameters ≥10 mm and down to -12% for smaller cones. Both nonshielded (SRS and E) and shielded diodes (P and Edge) overestimate the OF respectively up to 3.3% and 5.2% for cone diameters ≥10 mm and in both cases more than 7% for smaller cones. MicroDiamond slightly overestimates the OF, 3.7% for all the cones and EBT3 film is the closest to Monte Carlo with maximum difference of ±1% whatever the cone size is. For the profiles and the PDD, particularly for the small cones, the size of the detector predominates. All diodes and EBT3 agree with the simulation within ±0.2 mm for beam profiles determination. For PDD curve all the active detectors response agree with simulation up to 1% for all the cones. EBT3 is the more accurate detector for beam profiles and OF determinations of stereotactic cones but it is restrictive to use. Due to respectively inappropriate size of the sensitive volume and composition, pinpoints and diodes do not seem appropriate without OF corrective factors below 10 mm diameter cone. MicroDiamond appears to be the best detector for OF determination regardless all cones. For off-axis measurements, the size of the detector predominates and for PDD all detectors give promising results.
Subject(s)
Monte Carlo Method , Neoplasms/surgery , Particle Accelerators/instrumentation , Phantoms, Imaging , Radiosurgery/methods , Radiotherapy Planning, Computer-Assisted/methods , Algorithms , Computer Simulation , Humans , Radiotherapy Dosage , Radiotherapy, Intensity-Modulated/methodsABSTRACT
By pumping thulium-doped silica-based fibers at 1.07 µm, rapid generation of absorbing centers leads to photoinduced attenuation (PIA). This detrimental effect prevents exploiting laser emissions in the visible and near infrared. We report on the characterization of the PIA versus the fiber core composition, particularly the concentration of thulium (Tm), lanthanum (La), and cerium (Ce) ions. We show that UV emission induced by Tm-Tm energy transfers is the source of photodarkening and that lanthanum and cerium are efficient hardeners against PIA.
ABSTRACT
This Letter demonstrates a remarkable interplay between photo- and radiation-induced darkening of ytterbium-doped alumino-silica optical fibers operated in amplifying conditions and harsh environments (as, e.g., in space-based applications). Influences of the pump power, ionizing dose, and dose rate on this interaction are characterized. The pump is capable of accelerating or slowing down the radiation-induced darkening build-up depending on the ionizing dose. The steady-state photo-radio-darkening level is independent of the dose and at least equal to the equilibrium level of pure photo-darkening. This lower limit is notably reached at low dose rates, including those encountered in space. We, therefore, argue that photo-resistant ytterbium-doped fibers will resist against a space mission, whatever the dose.
ABSTRACT
The gain of erbium-doped fiber amplifiers is damaged by irradiation partly because of creation of color centers responsible of excess absorption at pump and signal wavelengths. Based on the combination of thermally stimulated luminescence and spectrophotometry, this Letter demonstrates that a part of the gain loss should be associated with the reduction of the density of Er3+ ions by irradiation.
ABSTRACT
Radioluminescent silica-based fiber dosimeters offer great advantages for designing miniaturized realtime sensors for high dose-rate dosimetry. Rise and fall kinetics of their response must be properly understood to better assess their performances in terms of measurement speed and repeatability. A standard model of radioluminescence (RL) has already been quantitatively validated for doped silica glasses, but beyond conclusive comparisons with specific experiments, a comprehensive understanding of the processes and parameters determining transient and equilibrium kinetics of RL is still lacking. We analyze in detail the kinetics inherent in the standard RL model. Several asymptotical regimes in the RL growth are demonstrated in the case of a pristine sample (succesive quadratic, linear and power-law time dependencies before the plateau is reached). We show how this situation is modified when a pre-irradiation partly fills traps beforehand. RL growth is then greatly accelerated because of the pre-formation of recombination centers (RCs) from dopant ions, but not due to pre-filling of trapping levels. In all cases, the RL intensity eventually tends to a constant level equal to the pair generation rate, long before all carrier densities themselves reach equilibrium. This occurs late under irradiation, when deep traps get to saturation. The fraction of dopants converted into RCs is then 'frozen' at a lower level the smaller the density of deep traps. Controlling RL kinetics through the engineering of material traps is not an option. Pre-irradiation appears to be the simplest way to obtain accelerated and repeatable kinetics.
ABSTRACT
The photodarkening (PD) mechanisms of ytterbium-doped silica optical fibers have still not been elucidated, although hardening routes have been proposed. Most basic questions are still under debate about the assignment of the darkening excitation bands into the UV range, the nature of absorbing centers (photoionized centers or trapped carriers?), or of traps accepting photo-released carriers (electron or hole traps?). We used thermoluminescence measurements to characterize traps populated by different radiation types. It is notably demonstrated that photodarkening involves silica hole traps. The popular idea that color centers are formed upon carrier trapping is not consistent with our observations.