ABSTRACT
BACKGROUND AND AIMS: Cold snare polypectomy (CSP) is associated with higher rates of complete resection compared with cold biopsy forceps (CBF) for the removal of small polyps (4-9 mm). This study aimed to evaluate self-reported polypectomy preferences and actual practice patterns among endoscopists at an academic center and to identify factors associated with the use of CSP for small polyps. METHODS: In phase A, endoscopists completed a survey evaluating preferences for polypectomy techniques. In phase B, we performed a retrospective analysis of all consecutive colonoscopies with polypectomy (January 2016 to September 2018). Uni- and multivariate analysis were performed to identify factors associated with CSP for small polyps. RESULTS: Nineteen of 26 (73%) endoscopists completed the survey (phase A); 3 (15.8%) were interventional endoscopists. Most respondents indicated that they use CSP (89.5%) for small polyps and identified no reasons for choosing CBF over CSP (73.7%). In phase B, we identified 1118 colonoscopies with 2625 polypectomies for polyps ≤9 mm. Most diminutive polyps (≤3 mm) were removed with CBF (819 of 912; 90%). CBF (46.2%) was also preferentially used for removal of small polyps (n = 1713), followed by hot snare polypectomy (27.2%), and CSP (26.6%). On multivariate analysis, interventional endoscopists were associated with a higher likelihood of using CSP for small polyps (odds ratio, 1.38; 95% confidence interval, 1.07-1.79; P = .01). CONCLUSIONS: Significant discrepancy exists between self-reported preferences and actual polypectomy practices. CBF is still preferentially used over CSP for the removal of polyps sized 4-9 mm; further strategies are needed to monitor and implement adequate polypectomy techniques.
Subject(s)
Colonic Polyps , Colonoscopy/standards , Colonic Polyps/pathology , Colonic Polyps/surgery , Colonoscopy/methods , Health Care Surveys , Humans , Professional Practice/standards , Retrospective Studies , Self ReportABSTRACT
BACKGROUND: Lateral mass screw fixation is the treatment of choice for posterior cervical stabilization. Long or misdirected screws carry a risk of injury to spinal nerve roots or vertebral artery. This study was aimed to assess the gross anatomic and CT measurements of typical cervical vertebrae for the selection of lateral mass screws. METHODS: Dimensions of the articular pillars were measured on 1) Dry cervical vertebrae with Vernier calipers and 2) Multiplanar reformations of CT scans of the same vertebrae with Viewer software package. The data was statistically evaluated. RESULTS: The transverse diameter of the articular pillars with Vernier calipers varied from 6.0 to 15.4 mm (mean=10.5 mm ± 1.5) and on CT scans ranged from 8.2 - 16.1 mm (mean=11.6 mm ± 1.4). The antero-posterior diameter, an estimate of the screw length by Roy-Camille technique varied from 3.9 to 12.7 mm (mean=8.6 mm ± 1.6) by Vernier calipers and from 6.4 to 13.3 mm (mean=9.1 ± 1.2) on CT scans. The oblique AP diameter, an estimate of screw length by Magerl method varied from 10.8 to 20.3 mm (mean=14.9 mm ± 1.8) by Vernier calipers and from 11.4 to 19.3 mm (mean=14.5 mm ± 1.7) on CT. The CT measurements for height, transverse and AP diameter of the articular pillars were 0.5 - 1.0 mm larger than dimensions by Vernier calipers. No statistically significant difference was observed between the caliper and CT measurements for the oblique AP diameter. CONCLUSION: CT measurements of the articular pillars may slightly overestimate the desired screw length selected by spine surgeons when compared to actual anatomy. Although means of the articular pillars correspond to the screw lengths used, substantial number of observations below 10 mm for Roy-Camille trajectory and below 14 mm for Magerl trajectory requires careful preoperative planning and intra-operative confirmation to avoid long/misdirected lateral mass screws.