Determining the performance of lignin-based flocculants in improving biosludge dewaterability.

In the wastewater treatment plant of pulp and paper mills, biosludge dewatering is needed to reduce the sludge handling and disposal costs. It is usually facilitated by means of the addition of synthetic polymers. There is increasing interest in replacing synthetic polymers with biopolymers derived from low value by-products or industrial residuals to improve the environmental footprint of dewatering. In this study, lignin-based flocculants (LBF) were tested for their ability to improve the biosludge dewaterability based on Capillary Suction Time (CST) and dry cake solids achieved with a Crown Press. The results demonstrate that LBFs alone can significantly enhance dewatering with a decrease in CSTs from 72.7 ± 5.1 s (unconditioned biosludge) to 23.3 ± 0.4 s and an increase in dry cake solids after pressing from 7.1 ± 0.5% to 13.9 ± 1.3% with a relatively high dosage of 7.5% w/w. However, with dual conditioning a LBF and 0.1% w/w anionic polyacrylamide (APAM), the required dosage of LBF was reduced to 3% w/w to achieve a dry cake solids content of 13.8 ± 0.4%, the same as that achieved with Zetag8165, a commercial synthetic polymer. LBF addition lowered the particle surface charge, allowing the particles to agglomerate and enhancing for the biosludge dewaterability. The application of LBFs for sludge dewatering offers novel considerable promise for providing more sustainable approaches by optimizing the use of lignin from different extraction processes, applying various types of lignin modifications in combination with anionic polymers, and exploring different methods of disposal or utilization of the dewatered sludge.

Enhancing Biosludge Dewaterability with Hemoglobin from Waste Blood as a Bioflocculant.

Synthetic polymers are widely used in the treatment of biosludge (waste activated sludge) to enhance its dewaterability. This paper discusses the results of a systematic study using hemoglobin (Hb) from animal blood and methylated hemoglobin (MeHb), a derivative in which a methyl group replaces the hydrogen carboxyl groups, to replace synthetic polymers to improve the dewatering efficiency of biosludge. With regular hemoglobin, no improvement in biosludge dewatering was found. With 10% of methylated hemoglobin per total solids content, however, the dry solids content of biosludge increased from 10.2 (±0.3) wt% to 15.0 (±1.0) wt%. Zeta potential measurements showed a decrease in the negative surface charge of the particles in biosludge from -34.3 (±3.2) mV to -19.0 (±2.1) mV after the treatment with methylated hemoglobin. This, along with an unchanged particle size distribution after conditioning, suggests that charge neutralization is likely the main cause of particle flocculation. With charges neutralized, the extracellular polymeric substances (EPS) around the biosludge flocs become loose, releasing the trapped water, thus increasing dewaterability.