Development of an Ion Mobility Spectrometer Based on a Pulsed Photoelectric Effect Ionization Source.

Ion mobility spectrometry (IMS) is a compact and sensitive trace gas analysis instrument that ionizes the sample into ions for detection. Typically, an ion gate is used to cut the continuous ion beam into ion packets for separation and detection. However, commonly used ion gates suffer from complex structures or low ion transmission rates, making the gateless IMS a viable alternative. In this study, an IMS based on a pulsed photoelectric effect ionization source was designed. The photoelectrons were generated by irradiating a photoelectric material with a back-illuminated pulsed xenon lamp. This allows for low-energy photoelectron generation and the production of simple reactant ions (O2-(H2O)n) and thus negative product ions. The photoelectron current generated by this ionization source was analyzed, which can reach an intensity of a few microamperes and can be converted into an ion signal exceeding 10 nA. The introduction of the pulsed photoelectric effect ionization source makes it possible to generate separate ion packets and complete ion injection when a constant electric field is maintained in the ionization region. And with an assisted pulsed electric field in the ionization region, the resolving power of the system can be effectively improved to 1.85 times that of the constant electric field. The IMS developed in this study was used for the detection of common volatile hazardous chemicals, yielding effective results. The detection limit for phenol was below 1 ppb, and the dynamic response range exceeded 1 order of magnitude, which implies the potential applications of this IMS to detect substances with high electron affinity, such as explosives detection in public safety.

Ultra-Fast Polarity Switching, Non-Radioactive Drift Tube for the Miniaturization of Drift-Time Ion Mobility Spectrometer.

Drift-time ion mobility spectrometer (DT-IMS) is a promising technology for gas detection and analysis in the form of miniaturized instrument. Analytes may exist in the form of positively or negatively charged ions according to their chemical composition and ionization condition, and therefore require both polarity of electric field for the detection. In this work the polarity switching of a drift-time ion mobility spectrometer based on a direct current (DC) corona discharge ionization source was investigated, with novel solutions for both the control of ion shutter and the stabilization of aperture grid. The drift field is established by employing a switchable high voltage power supply and a serial of voltage regulator diode, with optocouplers to drive the ion shutter when the polarity is switched. The potential of aperture grid is stabilized during the polarity switching by the use of four diodes to avoid unnecessary charging cycle of the aperture grid capacitor. Based on the proposed techniques, the developed DT-IMS with 50 mm drift path is able to switch its polarity in 10 ms and acquire mobility spectrum after 10 ms of stabilization. Coupled with a thermal desorption sampler, limit of detection (LoD) of 0.1 ng was achieved for ketamine and TNT. Extra benefits include single calibration substance for both polarities and largely simplified pneumatic design, together with the reduction of second drift tube and its accessories. This work paved the way towards further miniaturization of DT-IMS without compromise of performance.

Portable Digital Linear Ion Trap Mass Spectrometer Based on Separate-Region Corona Discharge Ionization Source for On-Site Rapid Detection of Illegal Drugs.

As narcotic control has become worse in the past decade and the death toll of drug abuse hits a record high, there is an increasing demand for on-site rapid detection of illegal drugs. This work developed a portable digital linear ion trap mass spectrometer based on separate-region corona discharge ionization source to meet this need. A separate design of discharge and reaction regions was adopted with filter air as both carrier gas for the analyte and protection of the corona discharge needle. The linear ion trap was driven by a digital waveform with a low voltage (±100 V) to cover a mass range of 50-500 Da with a unit resolution at a scan rate of 10,000 Da/s. Eighteen representative drugs were analyzed, demonstrating excellent qualitative analysis capability. Tandem mass spectrometry (MS/MS) was also performed by ion isolation and collision-induced dissociation (CID) with air as a buffer gas. With cocaine as an example, over two orders of magnitude dynamic range and 10 pg of detection limit were achieved. A single analysis time of less than 10 s was obtained by comparing the information of characteristic ions and product ions with the built-in database. Analysis of a real-world sample further validated the feasibility of the instrument, with the results benchmarked by GC-MS. The developed system has powerful analytical capability without using consumables including solvent and inert gas, meeting the requirements of on-site rapid detection applications.

Detection of Trace Explosives Using a Novel Sample Introduction and Ionization Method.

A novel sample introduction and ionization method for trace explosives detection is proposed and investigated herein, taking into consideration real-world application requirements. A thermal desorption sampling method and dielectric barrier discharge ionization (DBDI) source, with air as the discharge gas, were developed. The counter flow method was adopted firstly into the DBDI source to remove the interference of ozone and other reactive nitrogen oxides. A separated reaction region with an ion guiding electric field was developed for ionization of the sample molecules. Coupled with a homemade miniature digital linear ion trap mass spectrometer, this compact and robust design, with further optimization, has the advantages of soft ionization, a low detection limit, is free of reagent and consumable gas, and is an easy sample introduction. A range of common nitro-based explosives including TNT, 2,4-DNT, NG, RDX, PETN, and HMX has been studied. A linear response in the range of two orders of magnitude with a limit of detection (LOD) of 0.01 ng for TNT has been demonstrated. Application to the detection of real explosives and simulated mixed samples has also been explored. The work paves the path to developing next generation mass spectrometry (MS) based explosive trace detectors (ETDs).

Direct Performance of Triple-Stage Tandem Mass Spectrometry Analysis Using Dual-Direction Dipolar Excitation in a Digital Linear Ion Trap.

The ion trap mass spectrometer offers a unique advantage over other mass spectrometers by enabling multistage tandem mass spectrometry analysis with a single mass analyzer. It is employed to generate fragment ions through collision-induced dissociation (CID) usually by applying alternating current (AC) signals to a pair of electrodes for dipole excitation. The process of achieving double-stage tandem mass spectrometry analysis (MS/MS) in the mass spectrometer involves successive stages of injection, cooling, isolation, excitation, and scanning. For triple-stage tandem mass spectrometry analysis (MS/MS/MS), additional stages of isolation, cooling, and excitation need to be added based on the MS/MS analysis, resulting in a complex and time-consuming mass spectrometry workflow. In this study, a digital ion trap technology with the method of simultaneously applying dipole excitation signals to two pairs of electrodes in the ion trap was developed. This allows fragmentation of the precursor ion in one direction while exciting the first-generation product ions in the other direction, enabling direct acquisition of MS/MS/MS spectra. This approach simplifies the process of tandem mass spectrometry, as demonstrated by experimental studies on methamphetamine, which show that dual-direction excitation effectively reduces workflow and enhances the intensity of product ions. Additionally, the method of direct MS/MS/MS spectra achieved through dual-direction excitation in a digital ion trap mass spectrometer allows for a lower q value of the precursor ion owing to a pseudopotential well depth that is 1.648 times greater than that of a traditional sinusoidal ion trap. The experiments of analyzing high concentration n-butyl acetate and isobutyl acetate have shown that the implementation of MS/MS/MS analysis using dual-direction excitation can provide more mass spectral information and effectively distinguish between the two isomeric samples. The results of direct triple-stage spectra obtained by this technique for several typical volatile hazardous chemicals demonstrate the method's capability for rapid analysis and detection of such substances. In summary, the developed method of dual-directional excitation coupled with digital ion trap technology enables direct performance of triple-stage tandem mass spectrometry analysis, improving fragment ion intensities and providing more valuable mass spectral information. It offers advantages such as simplified workflows, faster analysis, and enhanced accuracy for analyzing compounds with low mass fragment ions.

[Inhibitory effect of recombinant HMGN2 protein on human hepatitis B viral].

OBJECTIVE: To construct a prokaryotic expression recombinant for the expression of HMGN2 and to evaluate its antiviral activity against human hepatitis virus. METHODS: The extracellular region cDNA of HMGN2 was isolated and amplified by RT-PCR, and introduced to the prokaryotic expression vector pGEX-4T-1. HMGN2 protein was expressed under IPTG induction and purified by GST protein purification system, then identified by SDS-PAGE and Western blot. The cytotoxicity of fusion HMGN2 to HBV-transfected HepG2. 2.15 cell was evaluated with MTT assay. Different concentration of fusion HMGN2 was applied on the HepG2. 2.15 cell and the cell culture supernatants were harvested after 3 and 6 days treatment. The HBsAg and HBeAg in the supernatants were detected by ELISA and the HBV DNA was detected by RT-PCR. RESULTS: In the range of tested 1-100 microg/mL of HMGN2, no cytotoxicity to HepG2. 2.15 cells was detected by MTT assay. When incubated with HMGN2 at 15 microg/mL for 72 h or 144 h, there was a significant reduction in HBeAg and HBsAg expression as well as the HBV DNA copies. CONCLUSION: pGEX-4T-1/HMGN2 vector was success constructed, and the recombinant HMGN2 protein could inhibit HBV expression and replication in vitro remarkably.

Enhanced Photoluminescence of All-Inorganic Manganese Halide Perovskite-Analogue Nanocrystals by Lead Ion Incorporation.

Herein, we develop an effective approach for incorporating lead (Pb) ions into manganese (Mn) halide perovskite-analogue nanocrystals (PA NCs) of CsMn(Cl/Br)3·2H2O via room-temperature supersaturation recrystallization. Pb2+-incorporated Mn-PA NCs exhibit strong orange emission upon UV light illumination, a peak centered at 600 nm assigned to Mn2+ transition (4T1g → 6A1g) with a photoluminescence quantum yield (PLQY) of 41.8% compared to the pristine Mn-PA NCs with very weak PL (PLQY = 0.10%). The significant enhancement of PLQY is attributed to the formation of [Mn(Cl/Br)4(OH)2]4--[Pb(Cl/Br)4(OH)2]4--[Mn(Cl/Br)4(OH)2]4- chain network structure, in which Pb2+ effectively dilutes the Mn2+ concentration to reduce magnetic coupling between Mn2+ pairs to relax the spin and parity selection rules. In addition, excited energy can effectively transfer from the [Pb(Cl/Br)4(OH)2]4- unit to Mn2+ luminescence centers owing to the low activation energy. Pb2+-incorporated PA NCs also exhibit excellent stability. The combined strong PL and high stability make Pb2+-incorporated Mn-based PA NCs an excellent candidate for potential optronic applications.

Transient Resistive Switching Devices Made from Egg Albumen Dielectrics and Dissolvable Electrodes.

Egg albumen as the dielectric, and dissolvable Mg and W as the top and bottom electrodes are used to fabricate water-soluble memristors. 4 × 4 cross-bar configuration memristor devices show a bipolar resistive switching behavior with a high to low resistance ratio in the range of 1 × 10(2) to 1 × 10(4), higher than most other biomaterial-based memristors, and a retention time over 10(4) s without any sign of deterioration, demonstrating its high stability and reliability. Metal filaments accompanied by hopping conduction are believed to be responsible for the switching behavior of the memory devices. The Mg and W electrodes, and albumen film all can be dissolved in water within 72 h, showing their transient characteristics. This work demonstrates a new way to fabricate biocompatible and dissolvable electronic devices by using cheap, abundant, and 100% natural materials for the forthcoming bioelectronics era as well as for environmental sensors when the Internet of things takes off.

High sensitivity flexible Lamb-wave humidity sensors with a graphene oxide sensing layer.

This paper reports high performance flexible Lamb wave humidity sensors with a graphene oxide sensing layer. The devices were fabricated on piezoelectric ZnO thin films deposited on flexible polyimide substrates. Two resonant peaks, namely the zero order antisymmetric (A0) and symmetric (S0) mode Lamb waves, were observed and fitted well with the theoretical analysis and modelling. With graphene oxide microflakes as the sensing layer, the sensing performance of both wave modes was investigated. The humidity sensitivity of the A0 mode is 145.83 ppm per %RH (at humidity 85%RH), higher than that of S0 mode of 89.35 ppm per %RH. For the first time, we have demonstrated that the flexible humidity sensors work as usual without noticeable deterioration in performance even under severe bending conditions up to 1500 µÎµ. Also the sensors showed an excellent stability upon repeated bending for thousand times. All the results demonstrated that the Lamb wave flexible humidity sensors have a great potential for application in flexible electronics.

Fast response and high sensitivity ZnO/glass surface acoustic wave humidity sensors using graphene oxide sensing layer.

We report ZnO/glass surface acoustic wave (SAW) humidity sensors with high sensitivity and fast response using graphene oxide sensing layer. The frequency shift of the sensors is exponentially correlated to the humidity change, induced mainly by mass loading effect rather than the complex impedance change of the sensing layer. The SAW sensors show high sensitivity at a broad humidity range from 0.5%RH to 85%RH with < 1 sec rise time. The simple design and excellent stability of our GO-based SAW humidity sensors, complemented with full humidity range measurement, highlights their potential in a wide range of applications.

Flexible surface acoustic wave resonators built on disposable plastic film for electronics and lab-on-a-chip applications.

Flexible electronics are a very promising technology for various applications. Several types of flexible devices have been developed, but there has been limited research on flexible electromechanical systems (MEMS). Surface acoustic wave (SAW) devices are not only an essential electronic device, but also are the building blocks for sensors and MEMS. Here we report a method of making flexible SAW devices using ZnO nanocrystals deposited on a cheap and bendable plastic film. The flexible SAW devices exhibit two wave modes - the Rayleigh and Lamb waves with resonant frequencies of 198.1 MHz and 447.0 MHz respectively, and signal amplitudes of 18 dB. The flexible devices have a high temperature coefficient of frequency, and are thus useful as sensitive temperature sensors. Moreover, strong acoustic streaming with a velocity of 3.4 cm/s and particle concentration using the SAW have been achieved, demonstrating the great potential for applications in electronics and MEMS.