ABSTRACT
Objective: To investigate the plasma pharmacokinetics of six representative components (nodakenin, osthole, 5-O-methylvisammioside, ferulic acid, liquiritigenin, and liquiritin), which were the ingredients of Qianghuo Shengshi Decoction (QSD) granules, in normal and rheumatoid arthritis (RA) rats administrated QSD granules intragastrically. Methods: A rapid and accurate ultra-high performance liquid chromatography-tandem mass spectrometry (LC-MS/MS) method was developed for the simultaneous determination of six components in plasma, and it showed a good specificity, linearity, intra-day and inter-day precision, intra-day and inter-day accuracy, extraction recovery, stability, and the less matrix effect. Results: The validated LC-MS/MS method was successfully used to compare the plasma pharmacokinetics of six ingredients between normal and RA rats after intragastrical administration of QSD granules and differences in the pharmacokinetics were found in two types of rats. The absorption rate in the RA rats was lower for nodakenin, osthole, 5-O-methylvisammioside, liquiritigenin and liquiritin than in the normal group, while the absorption rate of ferulic acid remained constant in two groups. In comparison with the normal rats, the exposure concentration of nodakenin was higher and that of other five components except for nodakenin was lower under pathological conditions. Additionally, the absorptive amount of nodakenin, osthole, 5-O-methylvisammioside and liquiritin was increased and that of ferulic acid and liquiritigenin was reduced in the RA rats than in the normal rats. Compared with the normal rats, the retention time of nodakenin, ferulic acid and liquiritin was reduced in vivo, whereas the retention time of osthole, 5-O-methylvisammioside and liquiritigenin was raised in the body for the RA rats. In contrast to the normal rats, the data demonstrated an increase in the elimination velocity of nodakenin and a decrease in the elimination velocity of the other five components except for nodakenin in the pathological state. Conclusion: This study showed that the pharmacokinetic behavior of the six components, nodakenin, osthole, 5-O-methylvisammioside, ferulic acid, liquiritigenin, and liquiritin, is different in vivo between normal and pathological states of rats, and this research provided the necessary experimental data to explain the pharmacokinetics of QSD granules in both normal and pathological states and provide some references for its clinical application at some level.
ABSTRACT
Aluminum-air (Al-air) batteries are considered one of the most promising next-generation energy storage devices. In this paper, we carry out an orthogonal experimental study on the SLM printing process parameters in 3D-printed Al-air battery anodes. The surface roughness, densification, and discharge performance of the electrodes under different process parameters are observed to reveal the effects of different process parameters on the forming quality and discharge performance of aluminum-air battery anodes. The results show that the laser power is the most important factor affecting the surface roughness of the porous aluminum anode, and the scanning spacing is the most important factor affecting the densification. The best printing parameters for the porous aluminum anode can be obtained when the laser power is 325 W, the scanning speed is 1000 mm/s, the scanning spacing is 0.12 mm, and the thickness of the powder spread is 0.03 mm. At this time, the surface roughness of the porous aluminum anode obtained by this process parameter is 15.01 µm, the densification is 94.97%, and the discharge is stable with a high value. In addition, we also carry out data validation to ensure that the data we obtain are optimal and valid.
ABSTRACT
Chronic wounds are a major health challenge that require new treatment strategies. Hydrogels are promising drug delivery systems for chronic wound healing because of their biocompatibility, hydration, and flexibility. However, conventional hydrogels cannot adapt to the dynamic and complex wound environment, which involves low pH, high levels of reactive oxygen species, and specific enzyme expression. Therefore, smart responsive hydrogels that can sense and respond to these stimuli are needed. Crucially, smart responsive hydrogels can modulate drug release and eliminate pathological factors by changing their properties or structures in response to internal or external stimuli, such as pH, enzymes, light, and electricity. These stimuli can also be used to trigger antibacterial responses, angiogenesis, and cell proliferation to enhance wound healing. In this review, we introduce the synthesis and principles of smart responsive hydrogels, describe their design and applications for chronic wound healing, and discuss their future development directions. We hope that this review will inspire the development of smart responsive hydrogels for chronic wound healing.