Time-efficient etching of LR-115 SSNTD film for indoor radon, thoron quantification.

LR-115 Solid State Nuclear Track Detector (SSNTD) is commonly utilized for quantifying indoor radon-thoron levels, by tallying the tracks formed in the films by exposure to these gases. Conventionally, sodium hydroxide (NaOH) is used to etch LR-115 films for 90 min at 60°C. However, this study suggests a time-efficient alternative approach utilizing potassium hydroxide (KOH) as the etchant. In an initial investigation, the bulk etch rates of KOH were examined at different normalities and temperatures, revealing that KOH exhibited nearly double the bulk etch rates compared to NaOH. Subsequently, a specially designed controlled experiment was conducted to assess the efficacy of the technique by enumerating the tracks generated in the films. Both etchants demonstrated very similar track counts for identical controlled exposures, indicating the reliability of the method. A consistent behavior was observed in the real-case scenario of LR-115 films exposed indoors to alpha particles from radon and its decay products. In both experiments, the etching with KOH for 45 min gave track densities comparable to standard NaOH etching for 90 min, highlighting the time efficiency of this method. Investigations were carried out into track shape and size features, aspects crucial to the measurement technique, using microscopic imaging of samples treated with both etchants. Strikingly similar track shapes and sizes were observed, affirming the consistency in the track measurement technique. Collectively, these findings suggest that KOH etchant reduces the etching time, presenting itself as a time-efficient method for quantifying radon and thoron track density.

A comprehensive study of radon in drinking waters of Hanumangarh district and the assessment of resulting dose to local population.

Study of radon concentration in drinking water from different sources (groundwater and surface water) used across the Hanumangarh district of Rajasthan, India, was done using scintillation-based detector. The concentration of radon in surface water varied from 0.12 to 2.07 Bq/l with an average value of 0.62 Bq/l and a standard deviation of 0.55 Bq/l and in groundwater samples varied from 1.61 to 8.73 Bq/l with an average value of 4.8 Bq/l and a standard deviation of 2.24 Bq/l. The ingestion and inhalation dose were calculated to assess the health risk for infants, children and adults. The resulting average annual effective dose has been found to be considerably lower than the recommended safe limit of 0.1 msv/y (WHO, In: Incorporating first and second addenda, third ed. WHO Press, Geneva. 3rd ed. World Health Organisation, Geneva, Switzerland, 2008). It can be concluded that radon in water does not pose a significant radiological health risk to the population of the studied area.

Radon and thoron inhalation doses in dwellings with earthen architecture: Comparison of measurement methods.

The radioactive noble gas radon (222Rn) and its decay products have been considered a health risk in the indoor environment for many years because of their contribution to the radiation dose of the lungs. The radioisotope thoron (220Rn) and its decay products came into focus of being a health risk only recently. The reason for this is its short half-life, so only building material can become a significant source for indoor thoron. In this study, dwellings with earthen architecture were investigated with different independent measurement techniques in order to determine appropriate methods for reliable dose assessment of the dwellers. While for radon dose assessment, radon gas measurement and the assumption of a common indoor equilibrium factor often are sufficient, thoron gas has proven to be an unreliable surrogate for a direct measurement of thoron decay products. Active/time-resolved but also passive/integrating measurements of the total concentration of thoron decay products demonstrated being precise and efficient methods for determining the exposure and inhalation dose from thoron and its decay products. Exhalation rate measurements are a useful method for a rough dose estimate only if the exhalation rate is homogeneous throughout the house. Before the construction of a building in-vitro exhalation rate measurements on the building material can yield information about the exposure that is to be expected. Determining the unattached fraction of radon decay products and even more of thoron decay products leads to only a slightly better precision; this confirms the relative unimportance of the unattached thoron decay products due to their low concentration. The results of this study thereby give advice on the proper measurement method in similar exposure situations.

Estimation of attached and unattached progeny of 222Rn and 220Rn concentration using deposition based progeny sensors.

The attached and unattached radon and thoron progeny concentrations have been calculated using deposition-based progeny sensors in Mansa, Muktsar, Bathinda and Faridkot districts of Punjab, India. The total (attached + unattached) equilibrium-equivalent (222)Rn concentration (EECRA + U) and total (attached + unattached) equilibrium-equivalent (220)Rn concentration (EECTA + U) were found to vary from 9 to 46 Bqm(-3) and 0.5 to 3.1 Bq m(-3), respectively. The concentrations of attached progeny nuclides for both (222)Rn and (220)Rn have been found to be greater than the unattached progeny nuclides in the dwellings of studied area. An attempt has also been made to assess the effective dose for (222)Rn and (220)Rn in the studied area. The radiation dose originated from (222)Rn and (220)Rn progeny is low and health risk is negligible.

Estimation of EEC, unattached fraction and equilibrium factor for the assessment of radiological dose using pin-hole cup dosimeters and deposition based progeny sensors.

High concentration of radon ((222)Rn), thoron ((220)Rn) and their decay products in environment may increase the risk of radiological exposure to the mankind. The (222)Rn, (220)Rn concentration and their separate attached and unattached progeny concentration in units of EEC have been measured in the dwellings of Muktsar and Mansa districts of Punjab (India), using Pin-hole cup dosimeters and deposition based progeny sensors (DTPS/DRPS). The indoor (222)Rn and (220)Rn concentration was found to vary from 21 Bqm(-3) to 94 Bqm(-3) and 17 Bqm(-3) to 125 Bqm(-3). The average EEC (attached + unattached) of (222)Rn and (220)Rn was 25 Bqm(-3) and 1.8 Bqm(-3). The equilibrium factor for (222)Rn and (220)Rn in studied area was 0.47 ± 0.13 and 0.05 ± 0.03. The equilibrium factor and unattached fraction of (222)Rn and (220)Rn has been calculated separately. Dose conversion factors (DCFs) of different models have been calculated from unattached fraction for the estimation of annual effective dose in the studied area. From the experimental data a correlation relationship has been observed between unattached fraction (f(p)(Rn)) and equilibrium factor (F(Rn)). The present work also aims to evaluate an accurate expression among available expression in literature for the estimation of f(p)(Rn).