ABSTRACT
We demonstrate that symmetry breaking opens a new degree of freedom to tailor energy-momentum dispersion in photonic crystals. Using a general theoretical framework in two illustrative practical structures, we show that breaking symmetry enables an on-demand tuning of the local density of states of the same photonic band from zero (Dirac cone dispersion) to infinity (flatband dispersion), as well as any constant density over an adjustable spectral range. As a proof of concept, we demonstrate experimentally the transformation of the very same photonic band from a conventional quadratic shape to a Dirac dispersion, a flatband dispersion, and a multivalley one. This transition is achieved by finely tuning the vertical symmetry breaking of the photonic structures. Our results provide an unprecedented degree of freedom for optical dispersion engineering in planar integrated photonic devices.
ABSTRACT
We propose to use a localized Γ-point slow Bloch mode in a 2D-Photonic Crystal (PC) membrane to realize an efficient surface emitting source. This device can be used as a quantum photonic device, e.g. a single photon source. The physical mechanisms to increase the Q/V factor and to improve the directivity of the PC microcavity rely on a fine tuning of the geometry in the three directions of space. The PC lateral mirrors are first engineered in order to optimize photons confinement. Then, the effect of a Bragg mirror below the 2DPC membrane is investigated in terms of out-of-plane leakages and far field emission pattern. This photonic heterostructure allows for a strong lateral confinement of photons, with a modal volume of a few (λ/n)3 and a Purcell factor up to 80, as calculated by two different numerical methods. We finally discuss the efficiency of the single photon source for different collection set-up.
ABSTRACT
Two integrated devices based on the vertical coupling between a photonic crystal microcavity and a silicon (Si) ridge waveguide are presented in this paper. When the resonator is coupled to a single waveguide, light can be spectrally extracted from the waveguide to free space through the far field emission of the resonator. When the resonator is vertically coupled to two waveguides, a vertical add-drop filter can be realized. The dropping efficiency of these devices relies on a careful design of the resonator. In this paper, we use a Fabry-Perot (FP) microcavity composed of two photonic crystal (PhC) slab mirrors. Thanks to the unique dispersion properties of slow Bloch modes (SBM) at the flat extreme of the dispersion curve, it is possible to design a FP cavity exhibiting two quasi-degenerate modes. This specific configuration allows for a coupling efficiency that can theoretically achieve 100%. Using 3D FDTD calculations, we discuss the design of such devices and show that high dropping efficiency can be achieved between the Si waveguides and the PhC microcavity.
ABSTRACT
A study of vertical coupling conditions between microdisk based resonators and waveguides is presented using an analytical model. The coupling efficiency optimization is investigated and compared to 3D FDTD computations. We also demonstrate that coupling losses can be exploited to favor high quality factor modes in circular resonators. In addition, we propose to modify the shape of the coupled waveguide to enhance mode selectivity and obtain a very compact structure with mode hoping capacities. Lower thresholds and modulation are also expected.
Subject(s)
Lasers , Transducers , Computer-Aided Design , Equipment Design , Equipment Failure Analysis , Feedback , Miniaturization , VibrationABSTRACT
Vertical Fabry Perot cavities (VFPC) have been extensively studied, especially for the realization of vertical-cavity surface emitting lasers (VCSELs). They are traditionally composed of two Distributed Bragg Reflectors (DBR) which reflectivity has to be sufficient in order to obtain highly resonant cavity, which is particularly necessary for laser emission in VCSELs. As a consequence, DBRs consist generally in very thick layer stacks. In this paper, we demonstrate the smallest conceivable high Q vertical Fabry-Perot cavity, using ultra-thin and highly-efficient photonic crystal slab mirrors instead of conventional DBRs, which enable moreover a control of the polarization.
ABSTRACT
The authors report a compact and highly selective tunable filter using a Fabry-Perot resonator combining a bottom micromachined 3-pair-InP/air-gap Bragg reflector with a top photonic crystal slab mirror. It is based on the coupling between radiated vertical cavity modes and waveguided modes of the photonic crystal. The full-width at half maximum (FWHM) of the resonance, as measured by microreflectivity experiments, is close to 1.5nm (around 1.55 microm). The presence of the photonic crystal slab mirror results in a very compact resonator, with a limited number of layers. The demonstrator was tuned over a 20nm range for a 4V tuning voltage, the FWHM being kept below 2.5nm. Bending of membranes is a critical issue, and better results (FWHM=0.5nm) should be obtained on the same structure if this technological point is fixed.
ABSTRACT
A new approach for an electrically driven microlaser based on a microdisk transferred onto Silicon is proposed. The structure is based on a quaternary InGaAsP p-i-n junction including three InAsP quantum wells, on a thin membrane transferred onto silicon by molecular bonding. A p++/n++ tunnel junction is used as the p-type contact. The technological procedure is described and first experimental results show a laser emission in pulsed regime at room temperature, with a threshold current near 1.5 mA.
ABSTRACT
Diffraction losses in one-dimensional photonic crystal (PC) waveguides are the primary limitation on second-harmonic (SH) conversion efficiency. By using a finite difference time domain (FDTD) code taking into account second-order nonlinear polarization, we investigated these losses numerically, particularly at the SH wavelength. We propose an efficient SH conversion scheme in Al(x)Ga(1-x)As/air-etched waveguides. An analytical model is used to extrapolate the conversion efficiency to a number of periods for which time consumption makes the FDTD codes unsuitable.
ABSTRACT
We report on wide wavelength tuning through optical injection of carriers of a photonic resonance observed in reflectivity at 1543 nm in an InP-based two-dimensional photonic crystal slab. An 8-nm blueshift, which represents 20 times the resonance linewidth, is observed when a 4-kW/cm2 intense optical pump is incident on the sample. An analytical model that we developed, based on a coupled-mode nonlinear approach, allows us to describe this phenomenon in detail.
ABSTRACT
We report the direct, room-temperature, near-field mapping and spectroscopy of the optical modes of a photonic-crystal microcavity containing quantum wells. We use a near-field optical probe to reveal the imprint of the cavity mode structure on the quantum-well emission. Furthermore, near-field spectroscopy allows us to demonstrate the strong spatial and spectral dependence of the coupling between the sources and the microcavity. This knowledge will be essential in devising future nanophotonic devices.
ABSTRACT
We report a study of the optical near field of an active integrated component operating near the 1.55-mum telecommunications wavelength. The device is based on a two-dimensional photonic crystal etched in a suspended InP membrane. Topographic as well as optical information is collected by use of a scanning near-field optical microscope in collection mode, providing information about the local distribution of the losses.