ABSTRACT
The exploration of stable, efficient, and low-cost catalysts toward ammonia borane hydrolysis is of vital significance for the practical implementation of this hydrogen production technology. Integrating interface engineering and nano-architecture engineering is a favorable strategy to elevate catalytic performance, as it can modify the electronic structure and provide sufficient active sites simultaneously. In this work, urchin-like NiCoP/CoP heterostructures are prepared via a three-step hydrothermal-oxidation-phosphorization synthesis route. It is demonstrated that the original Ni/Co molar ratio and the amount of phosphorus are crucial for adjusting the morphology, enhancing the exposed surface area, facilitating charge transfer, and modulating the adsorption and activation of H2O molecules. Consequently, the optimal Ni1Co2P heterostructure displays remarkable catalytic properties in the hydrolysis of ammonia borane with a turnover frequency (TOF) value of 30.3â molH2 â min-1 â molmetal -1, a low apparent activation energy of 25.89â kJ â mol-1, and good stability. Furthermore, by combining infrared spectroscopy and isotope kinetics experiments, a possible mechanism for the hydrolysis of ammonia borane was proposed.
ABSTRACT
The heterogeneous photodegradation behavior of liquid crystal monomers (LCMs) in standard dust (standard reference material, SRM 2583) and environmental dust was investigated. The measured photodegradation ratios for 23 LCMs in SRM and environmental dust in 12 h were 11.1 ± 1.8 to 23.2 ± 1.1% and 8.7 ± 0.5 to 24.0 ± 2.8%, respectively. The degradation behavior of different LCM compounds varied depending on their structural properties. A quantitative structure-activity relationship model for predicting the degradation ratio of LCMs in SRM dust was established, which revealed that the molecular descriptors related to molecular polarizability, electronegativity, and molecular mass were closely associated with LCMs' photodegradation. The photodegradation products of the LCM compound 4'-propoxy-4-biphenylcarbonitrile (PBIPHCN) in dust, including â¢OH oxidation, C-O bond cleavage, and ring-opening products, were identified by nontarget analysis, and the corresponding degradation pathways were suggested. Some of the identified products, such as 4'-hydroxyethoxy-4-biphenylcarbonitrile, showed predicted toxicity (with an oral rat lethal dose of 50%) comparable to that of PBIPHCN. The half-lives of the studied LCMs in SRM dust were estimated at 32.2-82.5 h by fitting an exponential decay curve to the observed photodegradation data. The photodegradation mechanisms of LCMs in dust were revealed for the first time, enhancing the understanding of LCMs' environmental behavior and risks.
Subject(s)
Dust , Liquid Crystals , Animals , Rats , Quantitative Structure-Activity Relationship , PhotolysisABSTRACT
To promote the bioconversion of marine chitin waste into value-added products, we expressed a novel pH-stable Micromonospora aurantiaca-derived chitinase, MaChi1, in Escherichia coli and subsequently purified, characterized, and evaluated it for its chitin-converting capacity. Our results indicated that MaChi1 is of the glycoside hydrolase (GH) family 18 with a molecular weight of approximately 57 kDa, consisting of a GH18 catalytic domain and a cellulose-binding domain. We recorded its optimal activity at pH 5.0 and 55 °C. It exhibited excellent stability in a wide pH range of 3.0-10.0. Mg2+ (5 mM), and dithiothreitol (10 mM) significantly promoted MaChi1 activity. MaChi1 exhibited broad substrate specificity and hydrolyzed chitin, chitosan, cellulose, soluble starch, and N-acetyl chitooligosaccharides with polymerization degrees ranging from three to six. Moreover, MaChi1 exhibited an endo-type cleavage pattern, and it could efficiently convert colloidal chitin into N-acetyl-D-glucosamine (GlcNAc) and (GlcNAc)2 with yields of 227.2 and 505.9 mg/g chitin, respectively. Its high chitin-degrading capacity and exceptional pH tolerance makes it a promising tool with potential applications in chitin waste treatment and bioactive oligosaccharide production.
Subject(s)
Chitin , Chitinases , Micromonospora , Chitinases/metabolism , Chitinases/chemistry , Chitinases/isolation & purification , Chitinases/genetics , Chitin/analogs & derivatives , Chitin/metabolism , Chitin/chemistry , Hydrogen-Ion Concentration , Substrate Specificity , Micromonospora/enzymology , Micromonospora/genetics , Hydrolysis , Escherichia coli/genetics , Chitosan/chemistry , Enzyme StabilityABSTRACT
Chitooligosaccharides, the hydrolysis products of chitin, have superior biological activities and application value to those of chitin itself; however, the ordered and highly crystalline structure of chitin renders its degradation by chitinase difficult. Herein, the effects of plasma-activated water (PAW) pre-treatment on the physicochemical properties, crystal structure, and enzymatic hydrolysis of chitin were investigated. The hydrolysis of PAW-pre-treated chitin (PAW activation time of 5 min) using chitinase from Vibrio harveyi (VhChit2) yielded 71 % more reducing sugar, compared with that from untreated chitin, with the degree of chitin hydrolysis increasing from 13 % without pre-treatment to 23 % post-treatment. Moreover, the amount of VhChit2 adsorbed by chitin increased from 41.7 to 58.2 mg/g. Fourier transform infrared spectrometry revealed that PAW could break the ß-1,4-glycosidic bonds of chitin (but had no effects on the hydrogen and amido bonds), thereby decreasing the molecular weight and crystallinity of the polysaccharide, which caused its structural damage and enhanced its enzymatic hydrolysis by chitinase. Consequently, PAW pre-treatment can be considered a simple, effective, and environmentally-friendly method for the biotransformation of chitin as its easier hydrolysis yields high-value products.
Subject(s)
Chitin , Chitinases , Molecular Weight , Vibrio , Water , Chitinases/chemistry , Chitinases/metabolism , Chitin/chemistry , Chitin/metabolism , Chitin/analogs & derivatives , Water/chemistry , Hydrolysis , Vibrio/enzymologyABSTRACT
The purpose of this work was to construct liver-targeted nanoparticles based on the redox response to effectively deliver cannabidiol (CBD) for the prevention of acute liver injury (ALI). CBD-loaded nanoparticles (CBD NPs) with a particle size of 126.5 ± 1.56 nm were prepared using the polymer DA-PP-LA obtained by grafting pullulan polysaccharide with deoxycholic acid (DA) and α-lipoic acid (α-LA). CBD NPs showed typical redox-response release behavior. Interestingly, CBD NPs exhibited admirable liver targeting ability, significantly accumulated in the liver, and effectively promoted the internalization of CBD in liver cells, thus effectively reducing the H2O2-induced oxidative damage of HepG2 cells and avoiding apoptosis. More importantly, CBD NPs effectively prevented CCl4-induced ALI by protecting liver function, ameliorating oxidative stress levels, inhibiting the production of inflammatory factors, and protecting the liver from histological damage. This study provides a promising strategy for achieving targeted delivery of CBD NPs in the liver, thereby effectively preventing ALI.
ABSTRACT
The Maillard reaction (MR) of tilapia byproduct protein hydrolysates was investigated for the use of byproduct protein as a food ingredient and to mask its fishy odor and bitter flavor. The flavor differences in tilapia byproduct hydrolysates before and after the MR were analyzed to explore the key flavor precursor peptides and amino acids involved in MR. The results suggested that eight key volatile substances, including 2,5-dimethylpyrazine, 2-pentylfuran, hexanal, octanal, nonanal, (E)-2-decenal, decanal, and 1-octen-3-ol contributed most to the MR products group (ROAV > 1). Ten volatile compounds, including 1-octen-3-ol, hexanal, 2-pentylfuran, 2,5-dimethylpyrazine, methyl decanoate, and 2-octylfuran, were the flavor markers that distinguished the different samples (VIP > 1). The four most consumed peptides were VAPEEHPTL, GPIGPRGPAG, KSADDIKKAF, and VWEGQNIVK. Umami peptides and bitter free amino acids (FAAs) were the key flavor precursor peptide and FAAs, respectively. Overall, the hydrolysates of tilapia byproducts with flavor improved by MR are a promising strategy for the production of flavorings.
Subject(s)
Aldehydes , Maillard Reaction , Octanols , Tilapia , Animals , Gas Chromatography-Mass Spectrometry , Amino Acids , PeptidesABSTRACT
The pathogenesis of ulcerative colitis (UC) is closely related to severe inflammation, damaged colonic mucosal barrier, increased oxidative stress and intestinal ecological imbalance. However, due to the nonspecific distribution and poor bioavailability of drugs, UC treatment is still a serious challenge. Here, a mitochondria/colon dual targeted nanoparticles based on redox response was developed to effectively alleviate UC. Cannabidiol nanoparticles (CBD NPs) with a particle size of 143.2 ± 3.11 nm were prepared by self-assembly using polymers (TPP-IN-LA) obtained by modifying inulin with (5-carboxypentyl) triphenyl phosphonium bromide (TPP) and α-lipoic acid (α-LA). Excitingly, the constructed CBD NPs showed excellent mitochondrial targeting, with a Pearson correlation coefficient of 0.76 at 12 h. The results of animal imaging in vivo showed that CBD NPs could be effectively accumulated in colon tissue. Not only that, CBD showed significant glutathione stimulated release in the presence of 10 mM glutathione at pH 7.4. The results of in vivo animal experiments showed that CBD NPs significantly ameliorated DSS-induced colonic inflammation by modulating the TLR4-NF-κB signaling pathway. Moreover, CBD NPs significantly improved the histological damage of colon in UC mice, increased the expression level of tight junction protein ZO-1, and effectively restored the intestinal mucosal barrier function and intestinal mucosal permeability. More importantly, CBD NPs significantly improved the species composition, abundance and amount of short chain fatty acids of intestinal flora in UC mice, thus effectively maintaining the balance of intestinal flora. The dual-targeted and glutathione-responsive nanoparticles prepared in this study provide a promising idea for achieving targeted delivery of CBD for effective treatment of UC.
ABSTRACT
Although rapid eye movement (REM) sleep is conventionally treated as a unified state, it comprises two distinct microstates: phasic and tonic REM. Recent research emphasizes the importance of understanding the interplay between these microstates, hypothesizing their role in transient shifts between sensory detachment and external awareness. Previous studies primarily employed linear metrics to probe cognitive states, such as oscillatory power, while in this study, we adopt Lempel-Ziv Complexity (LZC), to examine the nonlinear features of electroencephalographic (EEG) data from the REM microstates and to gain complementary insights into neural dynamics during REM sleep. Our findings demonstrate a noteworthy reduction in LZC during phasic REM compared to tonic REM states, signifying diminished EEG complexity in the former. Additionally, we noted a negative correlation between decreased LZC and delta band power, along with a positive correlation with alpha band power. This study highlights the potential of nonlinear EEG metrics, particularly LZC, in elucidating the distinct features of REM microstates. Overall, this research contributes to advancing our understanding of the complex dynamics within REM sleep and opens new avenues for exploring its implications in both clinical and nonclinical contexts.
Subject(s)
Electroencephalography , Sleep, REM , Humans , Sleep, REM/physiology , Electroencephalography/methods , Male , Female , Adult , Polysomnography , Young Adult , Nonlinear Dynamics , Brain/physiologyABSTRACT
The effect of a high internal phase emulsion (HIPE) on three-dimensional-printed surimi gel inks was studied. Increasing the concentration of collagen peptide decreased the particle size of HIPE droplets and improved the viscoelasticity and stability. For example, when the collagen peptide concentration was 5 wt%, the viscoelasticity of the HIPE was high, as indicated by the presence of small and uniform particles, which formed a monolayer in the outer layer of the oil droplets to form stable a HIPE. A HIPE was used as the filling material to fill the surimi gel network, which reduced the porosity of the network. Surimi protein and peptides have dual emulsifying effects on the stabilization of oil. After adding the emulsion, the texture, gel properties and rheological properties of the surimi were reduced, and its printing adaptability was improved. This study provides new ideas for the production of surimi and its application in 3D printing.