ABSTRACT
We propose a novel optimization method that combines two design criteria to reduce the differential modal gain (DMG) in few-mode cladding-pumped erbium-doped fiber amplifiers (FM-EDFAs). In addition to the standard criterion that considers the mode intensity and dopant profile overlap, we introduce a second criterion that ensures that all doped regions have the same saturation behavior. With these two criteria, we define a figure-of-merit (FOM) that allows the design of FM-EDFAs with low DMG without high computational cost. We illustrate this method with the design of six-mode erbium-doped fibers (EDFs) for amplification over the C-Band targeting designs that are compatible with standard fabrication processes. The fibers have either a step-index or a staircase refractive index profile (RIP), with two ring-shaped erbium-doped regions in the core. With a staircase RIP, a fiber length of 29 m and 20 W of pump power injected in the cladding, our best design leads to a minimum gain of 22.6â dB while maintaining a DMGmax under 0.18â dB. We further show that the FOM optimization achieves a robust design with low DMG over a wide range of variations in signal power, pump power and fiber length.
ABSTRACT
We demonstrate for the first time that a Bragg grating can be written over a large area inside the cladding of a multicore erbium-doped fiber amplifier to increase the power conversion efficiency (PCE) by recycling the output pump power. Our results indicate that a Bragg grating covering â¼25% of the cladding area allows us to recycle 19% of the output pump power which leads to a relative increase of the PCE by 16% for an input pump power of 10.6 W in the specific case of an eight-core erbium-doped fiber with a length of 20.3 m and one core loaded with an input signal power of 1.5 dBm.
ABSTRACT
We report a novel technique for side-pumping fluoride-based double-clad fibers, allowing a record coupling efficiency of 93% and a maximum power handling near 100 W at 981 nm. Our simple technique is based on wrapping a silica taper around a fluoride fiber and, therefore, does not require any complex fusion between these two dissimilar fibers. Under passive cooling, pump combiners made of undoped and erbium-doped fluoride fibers were successfully operated during several hours at respective incident powers of 91 and 44 W. Heat management issues and active cooling strategies are also discussed. This innovative combiner is a keystone towards the development of compact and robust high-power mid-infrared fiber lasers and amplifiers.