Suppression of nonlinear phonon relaxation in Yb:YAG thin disk via zero phonon line pumping.

A quantitative comparison of conventional absorption line (940 nm) pumping and zero phonon line (ZPL) (969 nm) pumping of a Yb:YAG thin disk laser is reported. Characteristics of an output beam profile, surface temperature, and deformation of a thin disk under the different pump wavelengths are evaluated. We found that a nonlinear phonon relaxation (NPR) of the excited state in Yb:YAG, which induces nonlinear temperature rise and large aspheric deformation, did not appear in the case of a ZPL pumped Yb:YAG thin disk. This means that the advantage of ZPL pumping is not only the reduction of quantum defect but also the suppression of NPR. The latter effect is more important for high power lasers.

Ultrafast Infrared Laser Crystallization of Amorphous Si/Ge Multilayer Structures.

Silicon-germanium multilayer structures consisting of alternating Si and Ge amorphous nanolayers were annealed by ultrashort laser pulses at near-infrared (1030 nm) and mid-infrared (1500 nm) wavelengths. In this paper, we investigate the effects of the type of substrate (Si or glass), and the number of laser pulses (single-shot and multi-shot regimes) on the crystallization of the layers. Based on structural Raman spectroscopy analysis, several annealing regimes were revealed depending on laser fluence, including partial or complete crystallization of the components and formation of solid Si-Ge alloys. Conditions for selective crystallization of germanium when Si remains amorphous and there is no intermixing between the Si and Ge layers were found. Femtosecond mid-IR laser annealing appeared to be particularly favorable for such selective crystallization. Similar crystallization regimes were observed for both single-shot and multi-shot conditions, although at lower fluences and with a lower selectivity in the latter case. A theoretical analysis was carried out based on the laser energy absorption mechanisms, thermal stresses, and non-thermal effects.

Highly Regular LIPSS on Thin Molybdenum Films: Optimization and Generic Criteria.

A systematic experimental study was performed to determine laser irradiation conditions for the large-area fabrication of highly regular laser-induced periodic surface structures (HR-LIPSS) on a 220 nm thick Mo film deposited on fused silica. The LIPSS were fabricated by scanning a linearly polarized, spatially Gaussian laser beam at 1030 nm wavelength and 1.4 ps pulse duration over the sample surface at 1 kHz repetition rate. Scanning electron microscope images of the produced structures were analyzed using the criterion of the dispersion of the LIPSS orientation angle (DLOA). Favorable conditions, in terms of laser fluence and beam scanning overlaps, were identified for achieving DLOA values <10∘. To gain insight into the material behavior under these irradiation conditions, a theoretical analysis of the film heating was performed, and surface plasmon polariton excitation is discussed. A possible effect of the film dewetting from the dielectric substrate is deliberated.