Microwave-Assisted One-Pot Synthesis of Indole-Based Fluorescent Probe for Sensitive Detection of Copper (II).

In this study, a rapid, inexpensive and convenient microwave assisted synthesis of indole-3-propionic acid-bisphenol A diglycidyl ether (IPA-SR3) fluorescent probe was developed. This fluorescent probe has the dual illumination characteristics of photoinduced electron transfer and aggregation-induced emission for the specific detection of Cu2+ ion in water. The wavelength-dependent photoluminescence behavior of the aggregated IPA-SR3 was highly selective (Ksv = 1.5 × 104 M-1) and sensitive in Cu2+ ion detection, with a low limit of detection (2.9 µM). Therefore, it can be used to detect low-concentration Cu2+ in water samples. Details of the synthesis procedure and fluorescence characteristics are presented herein. Graphical Abstract.

Partitioning of Aromatic Constituents into Water from Jet Fuels.

A comprehensive study of the most commonly used jet fuels (i.e., Jet A-1 and JP-8) was performed to properly assess potential contamination of the subsurface environment from a leaking underground storage tank occurred in an airport. The objectives of this study were to evaluate the concentration ranges of the major components in the water-soluble fraction of jet fuels and to estimate the jet fuel-water partition coefficients (K fw) for target compounds using partitioning experiments and a polyparameter linear free-energy relationship (PP-LFER) approach. The average molecular weight of Jet A-1 and JP-8 was estimated to be 161 and 147 g/mole, respectively. The density of Jet A-1 and JP-8 was measured to be 786 and 780 g/L, respectively. The distribution of nonpolar target compounds between the fuel and water phases was described using a two-phase liquid-liquid equilibrium model. Models were derived using Raoult's law convention for the activity coefficients and the liquid solubility. The observed inverse, log-log linear dependence of the K fw values on the aqueous solubility were well predicted by assuming jet fuel to be an ideal solvent mixture. The experimental partition coefficients were generally well reproduced by PP-LFER.

Microwave-enhanced catalytic degradation of 4-chlorophenol over nickel oxides under low temperature.

Microwave-enhance catalytic degradation (MECD) of 4-chlorophenol (4-CP) using nickel oxide was studied. A mix-valenced nickel oxide was obtained from nickel nitrate aqueous solution through a precipitation with sodium hydroxide and an oxidation by sodium hypochlorite (assigned as PO). Then, the as-prepared PO was irradiated under microwave irradiation to fabricate a high active mix-valenced nickel oxide (assigned as POM). Further, pure nanosized nickel oxide was obtained from the POM by calcination at 300, 400 and 500 degrees C (labeled as C300, C400 and C500, respectively). They were characterized by X-ray (XRD), infrared spectroscopy (IR) and temperature-programmed reduction (TPR). Their catalytic activities towards the degradation of 4-CP on the efficiency of the degradation were further investigated under continuous bubbling of air through the liquid-phase and quantitative evaluation by high pressure liquid chromatography (HPLC). Also, the effects of temperature, pH and kinds of catalysts on the efficiency of the degradation have been investigated. The results showed that the 4-CP was degraded completely by MECD method within 20 min under pH 7, T=40 degrees C and C=200 g dm(-3) over POM catalyst. The relative activity was affected significantly with the oxidation state of nickel.

Analysis of semi-volatile organic compounds in aqueous samples by microwave-assisted headspace solid-phase microextraction coupled with gas chromatography-electron capture detection.

The pretreatment technique of microwave-assisted headspace solid-phase microextraction (MA-HS-SPME) has been developed and studied for the extraction of semi-volatile organic compounds (SVOCs) in aqueous samples prior to chromatographic analysis. The optimum conditions for obtaining extraction efficiency, such as the extraction time, extraction temperature, addition of salts, and the ratio of sample to headspace volume parameters were investigated. Experimental results indicated that the proposed MA-HS-SPME technique attained the best extraction efficiency under the optimized conditions, i.e., irradiation of extraction solution (20mL aqueous sample in 40mL headspace vial with no addition of salt) under 30W microwave power for 30min at 70 degrees C. The detection was linear at 1-250ng/L with correlation coefficient exceeding 0.997. The detection limits obtained were between 0.2-10.7ng/L, repeatability range from 2 to 15%. Real water samples collected from known sites in southern Taiwan were analyzed using the optimized conditions.

Assessing soil and groundwater contamination from biofuel spills.

Future modifications of fuels should include evaluation of the proposed constituents for their potential to damage environmental resources such as the subsurface environment. Batch and column experiments were designed to simulate biofuel spills in the subsurface environment and to evaluate the sorption and desorption behavior of target fuel constituents (i.e., monoaromatic and polyaromatic hydrocarbons) in soil. The extent and reversibility of the sorption of aromatic biofuel constituents onto soil were determined. When the ethanol content in ethanol-blended gasoline exceeded 25%, enhanced desorption of the aromatic constituents to water was observed. However, when biodiesel was added to diesel fuel, the sorption of target compounds was not affected. In addition, when the organic carbon content of the soil was higher, the desorption of target compounds into water was lower. The empirical relationships between the organic-carbon normalized sorption coefficient (Koc) and water solubility and between Koc and the octanol-water partition coefficient (Kow) were established. Column experiments were carried out for the comparison of column effluent concentration/mass from biofuel-contaminated soil. The dissolution of target components depended on chemical properties such as the hydrophobicity and total mass of biofuel. This study provides a basis for predicting the fate and transport of hydrophobic organic compounds in the event of a biofuel spill. The spill scenarios generated can assist in the assessment of biofuel-contaminated sites.

Analysis of polychlorinated biphenyls in aqueous samples by microwave-assisted headspace solid-phase microextraction.

The hyphenated technique namely microwave-assisted headspace solid-phase microextraction (MA-HS-SPME) was developed and studied for the simultaneous extraction/enrichment of polychlorinated biphenyls (PCBs) in aqueous samples prior to the quantification by gas chromatography (GC). The PCBs in aqueous media are extracted onto a solid-phase micro fibre via the headspace with the aid of microwave irradiation. The optimum conditions for obtaining extraction efficiency, such as the extraction time, addition of salts, addition of methanol, ratio of sample to headspace volume, and the desorption parameters were investigated. Experimental results indicated that the proposed MA-HS-SPME method attained the best extraction efficiency under the optimized conditions, i.e., irradiation of extraction solution (20 ml aqueous sample in 40 ml headspace vial with no additions of salt and methanol) under 30 W microwave power for 15 cycles (1 min power on and 3 min power off of each cycle). Desorption at 270 degrees C for 3 min provided the best detection results. The detection limit obtained were between 0.27 and 1.34 ng/l. The correlation coefficient for the linear dynamic range from 1 to 80 ng/l exceeded 0.99 for 18 PCBs.

Study of factors affecting on the extraction efficiency of polycyclic aromatic hydrocarbons from soils using open-vessel focused microwave-assisted extraction.

As part of an evaluation of focused microwave-assisted extraction (FMAE) using an open-vessel system, the effects of matrix, moisture content, ageing, and solvent have been studied on the extraction efficiency of polycyclic aromatic hydrocarbons (PAHs) from spiked soils. PAHs were spiked onto three different uncontaminated air dried and originally wet soil matrices with 1- and 20-day ageing periods. Solvents used were hexane-acetone (1:1), cyclohexane-acetone (1:1) and dichloromethane. FMAE only required a small amount of solvent (20 ml) and short extraction time (10 min) in the open cell under 90 W of microwave power. The results revealed that the extraction efficiency strongly depends on the nature of soil matrix; moisture content may enhance the recoveries of PAHs for many cases; and, the influence of the type of solvent is not significant. A comparison between microwave extraction and 16-h Soxhlet extraction has been made on spiked soils. It evidenced that the microwave method under ambient pressure is a suitable alternative to Soxhlet method for the analysis of PAHs in soils. For the evaluation of the developed FMAE method, three reference materials were used. The PAHs recovered from three reference materials were in a good agreement with reference values.

Purge-assisted headspace solid-phase microextraction combined with gas chromatography/mass spectrometry for the determination of trace nitrated polycyclic aromatic hydrocarbons in aqueous samples.

This study describes a new procedure, namely, purge-assisted headspace solid phase microextraction combined with gas chromatography/negative ion chemical ionization mass spectrometry (PA/HS-SPME-GC/NICI-MS), which is used to determine seven nitrated polycyclic aromatic hydrocarbons (NPAHs) in aqueous samples. High extraction efficiency was obtained with PA/HS-SPME with polydimethylsiloxane (PDMS) fiber coating. A programmable temperature vaporizing (PTV) inlet was used in the desorption process. Selected ion monitoring (SIM) was used for quantitative and qualitative purposes. The linear range of detection of the proposed method was 5-5000 pg/mL with coefficients of determination between 0.995 and 0.999. Limits of detection (LODs) for seven NPAHs were 0.01-0.06 pg/mL. The relative standard deviation was below 12.7% at a concentration of 50 pg/mL. Compared with headspace-solid phase microextraction (HS-SPME), the purge procedure enhanced the extraction efficiency for high boiling point analytes, such as 7-nitrobenz[a]anthracene (7-NBA) and 6-nitrochrysene (6-NC). The proposed method provides a sensitive method for NPAH analysis at the pg/mL level. The application of the proposed method for the determination of trace NPAHs in real samples was investigated by analyzing aqueous samples from rivers. The concentrations of NPAHs detected from the samples ranged from 5.2 to 7.5 pg/mL. This method was applied successfully in the analysis of trace NPAHs in river samples.

High efficiency degradation of 4-nitrophenol by microwave-enhanced catalytic method.

Application of the microwave-enhanced catalytic degradation (MECD) method on the abatement of 4-nitrophenol (4-NP) using nickel oxide was studied. A mix-valenced nickel oxide was prepared from nickel nitrate aqueous solution through a precipitation with sodium hydroxide and an oxidation by sodium hypochlorite with/without microwave-assisted heating. They were characterized by X-ray (XRD), infrared spectroscopy (IR), temperature programmed reduction (TPR), and transmission electron micrographs (TEM). Their catalytic activities towards the degradation of 4-NP were investigated through continuous bubbling of air during the liquid phase and evaluated quantitatively with high pressure liquid chromatography (HPLC). Also, the effect of the kinds of catalyst, temperature, pH, initial concentration, and dosage of catalyst on the efficiency of 4-NP degradation was investigated. The results showed that the 4-NP was completely degraded using the high efficiency MECD method within 15 min under [H(+)] = 1.0M, T = 40 °C, and C = 200 ppm over nickel oxide.