ABSTRACT
Direct back-face transmission steady-state fluorescence was successfully applied to the study of aggregation of ibuprofen and ibuprofenate anion in solution taking advantage of its own fluorescence. The analysis of the experimental data involves the use of the differential reabsorption model to account for re-absorption phenomenon and the closed association model to describe aggregation. The fluorescence quantum yield of ibuprofenate increases when it aggregates in the presence of sodium, but it markedly decreases when 1-butyl-3-methylimidazolium is used as counterion. The proposed methodology allows the accurate determination of the critical aggregation concentrations and the mean aggregation numbers. Results were supported by complementary techniques such as time-resolved fluorescence, 1H-NMR and small-angle neutron and X-ray scattering. The developed technique constitutes a promising strategy to characterize the aggregation of poorly fluorescent surfactants that aggregates at high concentrations and hence at high absorbance values, conditions in which the most common right-angle configuration for fluorescence acquisition is troublesome due to re-absorption.
Subject(s)
Ibuprofen , Surface-Active Agents , Anions , Ibuprofen/chemistry , Ibuprofen/pharmacology , Magnetic Resonance Spectroscopy , Surface-Active Agents/chemistryABSTRACT
Mesoporous oxide thin films (MOTF) present very high surface areas and highly controlled monodisperse pores in the nanometer range. These features spurred their possible applications in separation membranes and permselective electrodes. However, their performance in real applications is limited by their reactivity. Here, we perform a basic study of the stability of MOTF toward dissolution in aqueous media using a variety of characterization techniques. In particular, we focus in their stability behavior under the influence of ionic strength, adsorption of electrochemical probes, and applied electrode potential. Mesoporous silica thin films present a limited chemical stability after electrochemical cycling, particularly under high ionic strength, due to their high specific surface area and the interactions between the electrochemical probes and the surface. In contrast, TiO2 or Si0.9Zr0.1O2 matrices present higher stability; thus, they are an adequate alternative to produce accessible, sensitive, and robust permselective electrodes or membranes that perform under a wide variety of conditions.
ABSTRACT
In this paper, a systematic study regarding the effect of the mesoporous structure over Au nanoparticles (NPs) growth inside and through the pores of mesoporous TiO2 thin films (MTTFs) is presented, and the effect of such characteristics over the composites' sensing capabilities is evaluated. Highly stable MTTFs with different pore diameters (range: 4-8 nm) and pore arrangements (body- and face-centered cubic) were synthesized and characterized. Au NPs were grown inside the pores, and it was demonstrated-through a careful physicochemical characterization-that the amount of incorporated Au and NP size depends on the pore array; being higher for bigger pore diameters and face-centered cubic structures. The same structure allows the growth of more and longer tips over Au NPs deposited at the thin film-substrate interface. Finally, to confirm the effect of the structural characteristics of the composites over their possible applications, the materials were tested as surface-enhanced Raman scattering (SERS)-based substrates. The composites with a higher amount of Au and more ramified NPs were the ones that presented better sensitivity in the detection of a probe molecule (4-nitrothiophenol). Overall, this work demonstrates that the pore size and ordering in MTTFs determine the materials' accessibility and connectivity, and therefore, have a clear impact on their potential applications.
ABSTRACT
Mesoporous oxide films are attractive frameworks in technological areas such as catalysis, sensing, environmental protection, and photovoltaics. Herein, we used fluorescence correlation spectroscopy to explore how the pore dimensions of hydrated TiO2 mesoporous calcined films modulate the molecular diffusion. Rhodamine B molecules in mesoporous films follow a Fickian process 2-3 orders slower compared to the probe in water. The mobility increases with the pore and neck radii reaching an approximately constant value for a neck radius >2.8 nm. However, the pore size does not control the dye diffusion at low ionic strength emphasizing the relevance of the probe interactions with the pore walls on dye mobility. In conclusion, our results show that the thermal conditioning of TiO2 mesoporous films provides an exceptional tool for controlling the pore and neck radii on the nanometer scale and has a major impact on molecular diffusion within the mesoporous network.
ABSTRACT
The increasing interest in developing safe and sustainable energy storage systems has led to the rapid rise in attention to superconcentrated electrolytes, commonly called water-in-salt (WiS). Several works indicate that the transport properties of these liquid electrolytes are related to the presence of nanodomains, but a detailed characterization of such structure is missing. Here, the structural nano-heterogeneity of lithium WiS electrolytes, comprising lithium trifluoromethanesulfonate (LiTf) and bis(trifluoromethanesulfonyl)imide (LiTFSI) solutions as a function of concentration and temperature, was assessed by resorting to the analysis of small-angle neutron scattering (SANS) patterns. Variations with the concentration of a correlation peak, rather temperature-independent, in a Q range around 3.5-5 nm-1 indicate that these electrolytes are composed of nanometric water-rich channels percolating a 3D dispersing anion-rich network, with differences between Tf and TFSI anions related to their distinct volumes and interactions. Furthermore, a common trend was found for both systems' morphology above a salt volume fraction of â¼0.5. These results imply that the determining factor in the formation of the nanostructure is the salt volume fraction (related to the anion size), rather than its molality. These findings may represent a paradigm shift for designing WiS electrolytes.