A coupled hydrodynamic (HEC-RAS 2D) and water quality model (WASP) for simulating flood-induced soil, sediment, and contaminant transport.

Increased intensity and frequency of floods raise concerns about the release and transport of contaminated soil and sediment to and from rivers and streams. To model these processes during flooding events, we developed an External Coupler in Python to link the Hydrologic Engineering Center-River Analysis System (HEC-RAS) 2D hydrodynamic model to the Water Quality Analysis Simulation Program (WASP). Accurate data transfer from a hydrodynamic model to a water quality model is critical. Our test results showed the External Coupler successfully linked HEC-RAS and WASP and addressed technical challenges in aggregating flow data and conserving mass during the flood event. We ran the coupled models for a 100-year flood event to calculate flood-induced transport of sediment-associated arsenic in Woodbridge Creek, NJ. Change in surface sediment and arsenic at the end of 48-h flood simulation ranged from a net loss of 13.5 cm to a net gain of 11.6 cm, and 16.2 to 2.9 mg/kg, respectively, per model segment, which demonstrates the capability of the coupled model for simulating sediment and contaminant transport in flood.

Economic and technical assessment of rooftop solar photovoltaic potential in Brownsville, Texas, U.S.A.

Localized assessment of solar energy economic feasibility will benefit the structuring of residential solar energy deployment globally. In the U.S. growing interest in rooftop residential solar among city managers has spurred the development of photovoltaic (PV) feasibility maps of the technical and economic solar potential within cities. The City of Brownsville, Texas was interested in evaluating solar feasibility for their city but lacked information to make informed policy decisions on PV development. This paper presents novel and systems approaches for determining the technical and economic feasibility of solar development for homes in the Brownsville using LiDAR and local information. Residential technical and economic potential was assessed by optimizing the internal rate of return (IRR) and an average residential building demand profile to determine ideal size and placement of solar arrays. Results showed that residential structures in Brownsville have the technical potential to generate approximately 11% of the total energy provided by the local utility; however, average IRR was only 2.9% with a payback period of over 15 years. Five neighborhoods in the City of Brownsville were identified with spatially clustered homes that had relatively higher IRRs compared with other areas in the city. Despite the high technical potential, modeled results indicate that perspective home owners interested in solar development may require additional incentives to improve the economic feasibility of PV in Brownsville. This study provides a demonstration of an interdisciplinary systems approach and methodology that can be adopted internationally to evaluate the feasibility of solar development in other areas.

Mapping Aedes aegypti (Diptera: Culicidae) and Aedes albopictus Vector Mosquito Distribution in Brownsville, TX.

Aedes mosquitoes are vectors of several emerging diseases and are spreading worldwide. We investigated the spatiotemporal dynamics of Aedes aegypti (Linnaeus) and Aedes albopictus (Skuse) mosquito trap captures in Brownsville, TX, using high-resolution land cover, socioeconomic, and meteorological data. We modeled mosquito trap counts using a Bayesian hierarchical mixed-effects model with spatially correlated residuals. The models indicated an inverse relationship between temperature and mosquito trap counts for both species, which may be due to the hot and arid climate of southern Texas. The temporal trend in mosquito populations indicated Ae. aegypti populations peaking in the late spring and Ae. albopictus reaching a maximum in winter. Our results indicated that seasonal weather variation, vegetation height, human population, and land cover determine which of the two Aedes species will predominate.

The impact of air pollutant deposition on solar energy system efficiency: An approach to estimate PV soiling effects with the Community Multiscale Air Quality (CMAQ) model.

Deposition and accumulation of aerosol particles on photovoltaics (PV) panels, which is commonly referred to as "soiling of PV panels," impacts the performance of the PV energy system. It is desirable to estimate the soiling effect at different locations and times for modeling the PV system performance and devising cost-effective mitigation. This study presents an approach to estimate the soiling effect by utilizing particulate matter (PM) dry deposition estimates from air quality model simulations. The Community Multiscale Air Quality (CMAQ) modeling system used in this study was developed by the U.S. Environmental Protection Agency (U.S. EPA) for air quality assessments, rule-making, and research. Three deposition estimates based on different surface roughness length parameters assumed in CMAQ were used to illustrate the soling effect in different land-use types. The results were analyzed for three locations in the U.S. for year 2011. One urban and one suburban location in Colorado were selected because there have been field measurements of particle deposition on solar panels and analysis on the consequent soiling effect performed at these locations. The third location is a coastal city in Texas, the City of Brownsville. These three locations have distinct ambient environments. CMAQ underestimates particle deposition by 40% to 80% when compared to the field measurements at the two sites in Colorado due to the underestimations in both the ambient PM10 concentration and deposition velocity. The estimated panel transmittance sensitivity due to the deposited particles is higher than the sensitivity obtained from the measurements in Colorado. The final soiling effect, which is transmittance loss, is estimated as 3.17 ±â€¯4.20% for the Texas site, 0.45 ±â€¯0.33%, and 0.31 ±â€¯0.25% for the Colorado sites. Although the numbers are lower compared to the measurements in Colorado, the results are comparable with the soiling effects observed in U.S.

A systematic review and evaluation of Zika virus forecasting and prediction research during a public health emergency of international concern.

INTRODUCTION: Epidemic forecasting and prediction tools have the potential to provide actionable information in the midst of emerging epidemics. While numerous predictive studies were published during the 2016-2017 Zika Virus (ZIKV) pandemic, it remains unknown how timely, reproducible, and actionable the information produced by these studies was. METHODS: To improve the functional use of mathematical modeling in support of future infectious disease outbreaks, we conducted a systematic review of all ZIKV prediction studies published during the recent ZIKV pandemic using the PRISMA guidelines. Using MEDLINE, EMBASE, and grey literature review, we identified studies that forecasted, predicted, or simulated ecological or epidemiological phenomena related to the Zika pandemic that were published as of March 01, 2017. Eligible studies underwent evaluation of objectives, data sources, methods, timeliness, reproducibility, accessibility, and clarity by independent reviewers. RESULTS: 2034 studies were identified, of which n = 73 met the eligibility criteria. Spatial spread, R0 (basic reproductive number), and epidemic dynamics were most commonly predicted, with few studies predicting Guillain-Barré Syndrome burden (4%), sexual transmission risk (4%), and intervention impact (4%). Most studies specifically examined populations in the Americas (52%), with few African-specific studies (4%). Case count (67%), vector (41%), and demographic data (37%) were the most common data sources. Real-time internet data and pathogen genomic information were used in 7% and 0% of studies, respectively, and social science and behavioral data were typically absent in modeling efforts. Deterministic models were favored over stochastic approaches. Forty percent of studies made model data entirely available, 29% provided all relevant model code, 43% presented uncertainty in all predictions, and 54% provided sufficient methodological detail to allow complete reproducibility. Fifty-one percent of predictions were published after the epidemic peak in the Americas. While the use of preprints improved the accessibility of ZIKV predictions by a median of 119 days sooner than journal publication dates, they were used in only 30% of studies. CONCLUSIONS: Many ZIKV predictions were published during the 2016-2017 pandemic. The accessibility, reproducibility, timeliness, and incorporation of uncertainty in these published predictions varied and indicates there is substantial room for improvement. To enhance the utility of analytical tools for outbreak response it is essential to improve the sharing of model data, code, and preprints for future outbreaks, epidemics, and pandemics.

Systematic Review: Land Cover, Meteorological, and Socioeconomic Determinants of Aedes Mosquito Habitat for Risk Mapping.

Asian tiger and yellow fever mosquitoes (Aedes albopictus and Ae. aegypti) are global nuisances and are competent vectors for viruses such as Chikungunya (CHIKV), Dengue (DV), and Zika (ZIKV). This review aims to analyze available spatiotemporal distribution models of Aedes mosquitoes and their influential factors. A combination of five sets of 3-5 keywords were used to retrieve all relevant published models. Five electronic search databases were used: PubMed, MEDLINE, EMBASE, Scopus, and Google Scholar through 17 May 2017. We generated a hierarchical decision tree for article selection. We identified 21 relevant published studies that highlight different combinations of methodologies, models and influential factors. Only a few studies adopted a comprehensive approach highlighting the interaction between environmental, socioeconomic, meteorological and topographic systems. The selected articles showed inconsistent findings in terms of number and type of influential factors affecting the distribution of Aedes vectors, which is most likely attributed to: (i) limited availability of high-resolution data for physical variables, (ii) variation in sampling methods; Aedes feeding and oviposition behavior; (iii) data collinearity and statistical distribution of observed data. This review highlights the need and sets the stage for a rigorous multi-system modeling approach to improve our knowledge about Aedes presence/abundance within their flight range in response to the interaction between environmental, socioeconomic, and meteorological systems.