ABSTRACT
Incorporating ultralow loading of nanoparticles into polymers has realized increases in dielectric constant and breakdown strength for excellent energy storage. However, there are still a series of tough issues to be dealt with, such as organic solvent uses, which face enormous challenges in scalable preparation. Here, a new strategy of dual in situ synthesis is proposed, namely polymerization of polyethylene terephthalate (PET) synchronizes with growth of calcium borate nanoparticles, making polyester nanocomposites from monomers directly. Importantly, this route is free of organic solvents and surface modification of nanoparticles, which is readily accessible to scalable synthesis of polyester nanocomposites. Meanwhile, uniform dispersion of as ultralow as 0.1 wt% nanoparticles and intense bonding at interfaces have been observed. Furthermore, the PET-based nanocomposite displays obvious increases in both dielectric constant and breakdown strength as compared to the neat PET. Its maximum discharged energy density reaches 15 J cm-3 at 690 MV m-1 and power density attains 218 MW cm-3 under 150 Ω resistance at 300 MV m-1, which is far superior to the current dielectric polymers that can be produced at large scales. This work presents a scalable, safe, low-cost, and environment-friendly route toward polymer nanocomposites with superior capacitive performance.
ABSTRACT
Integrating high-loading dielectric nanoparticles into polar polymer matrices potentially can profit the intrinsic polarization of each phase and allow for greatly enhanced dielectric properties in polymer nanocomposites. It is however challenging to achieve desirable highly filled polar polymer composites because of the lack of efficient approaches to disperse nanoparticles and maintain interfacial compatibility. Here, we report a versatile route to fabricate highly filled barium titanate/fluorinated silicone rubber (BT/FSR) nanocomposites by "thiol-ene click" and isostatic pressing techniques. The loaded BT nanoparticles (from 82 wt% to 90 wt%) are chemically bonded with FSR in the nanocomposites. The existence of the polar group (-CH2CF3) of the polymer matrix does not affect the uniform dispersion of the nanoparticles or the good interfacial compatibility. The 90 wt% BT/FSR nanocomposite shows the highest dielectric constant of 57.8 at 103 Hz, while the loss tangent can be kept below 0.03. Besides, BT/FSR nanocomposites display higher breakdown strength than BT/SR nanocomposites. This work offers a facile strategy towards superior dielectric properties of polymer nanocomposites.
ABSTRACT
Using an emulsion road and optimizing the dispersion process, we prepare polymer carbone nanotubes (CNT) and polymer reduced graphene oxide (rGO) composites. The introduction of conductive nanoparticles into polymer matrices modifies the electronic properties of the material. We show that these materials exhibit giant electrostriction coefficients in the intermediate filler concentration (below 1 wt %). This makes them very promising for applications such as capacitive sensors and actuators. In addition, the values of the piezoresistivity measured in the high filler concentration situation are at least an order of magnitude greater than the one reported in the literature. This opens the way to use these materials for stress or strain sensor applications considering their giant responses to mechanical deformations.
ABSTRACT
Near-percolated CNT-polymer composites are promising high-permittivity materials. The main challenge in the field consists of finding compromises that allow high permittivity and low losses in frequency ranges of interest. Using an emulsion approach and optimizing the size of the droplets and the curing procedure, we obtain unprecedented performances and measure giant permittivity larger than 20,000 at 100 Hz along with a conductivity below 10(-4) S/m.
ABSTRACT
Both carbon nanotubes (CNTs) and graphene nanosheets (GNs) have potential applications in polymer composites. Combining them may induce a synergistic effect on enhancing the properties of composites. Herein, CNT-GN 3D hybrids were prepared by liquid injection chemical vapor deposition through a spray containing both carbon feedstocks and catalyst precursors. Vertically aligned CNTs were self-organized on the GNs. The morphology of hybrids could be well controlled as a function of the synthesis parameters. The unique 3D geometry of the CNT-GN hybrids provided composites with a higher electrical conductivity as compared to composites solely reinforced by CNTs or GNs. However, the thermal stability of the neat poly(vinylidene fluoride) matrix was found to decrease upon the addition of these hybrid fillers.
ABSTRACT
OBJECTIVE: To observe the effect of SSd on reversing the malignant phenotype of HepG2 cells and to investigate its mechanism in order to prove that SSd is a new choice to prevent and treat HCC. METHODS: HepG2 cells were cultured and treated by different concentration (0 mg/L, 2.5 mg/L, 5.0 mg/L, 10.0 mg/L and 20.0 mg/L) of SSd for 24 h, and treated by 10 mg/L of SSd for 0 h, 6 h, 12 h, 24 h, 48 h and 72h respectively. The cell inhibition rates were measured by MTT assay. Then cells were treated by 10 mg/L SSd for 48 hr in experimental group and treated by no SSd as a control, their morphological changes were observed by contrast phase microscope. The concentrations of ALB and AFP in clear supernatant liquid of cells were detected by radio-immunity and chemiluminescence. The cell migration rates were observed by transwell method, the relative expression levels of p27 mRNA were measured by RT-PCR. RESULTS: The inhibitive effect of 10 mg/L SSd was the most significant among different concentrations ( F = 265.06, P less than 0.01). The shape of HepG2 from experimental group turned into small and round, and their volume ratios of nucleus to plasma decreased. ALB in supernatant liquid of HepG2 was higher ( t = 7.83, P less than 0.05, and its AFP was lower ( t = -10.72, P less than 0.01) as compared to control group. Cells migrated were fewer and p27 mRNA expression of HepG2 was higher in experimental group than that in control group (t = 22.00, P less than 0.05). CONCLUSION: SSd could reverse the malignant phenotype of HepG2 cells. It was suggested that the up-regulation of p27 mRNA expression play an important role in the differentiation of HepG2 cells treated by SSd.
Subject(s)
Carcinoma, Hepatocellular/pathology , Liver Neoplasms/pathology , Oleanolic Acid/analogs & derivatives , Saponins/pharmacology , Hep G2 Cells/drug effects , Humans , Oleanolic Acid/pharmacology , RNA, Messenger/geneticsABSTRACT
Carbon suspension electrodes are promising for flow-assisted electrochemical energy storage systems. They serve as flowable electrodes in electrolyte solutions of flow batteries, or flow capacitors. They can also be used for other applications such as capacitive deionization of water. However, developments of such suspensions remain challenging. The suspensions should combine low viscosity and high electronic conductivity for optimized performances. In this work, we report a flowable aqueous carbon dispersion which exhibits a viscosity of only 2 Pa.s at a shear rate of 5 s-1 for a concentration of particles of 7 wt%. This suspension displays an electronic conductivity of 65 mS/cm, nearly two orders of magnitude greater than previously investigated related materials. The investigated suspensions are stabilized by sodium alginate and arabic gum in the presence of ammonium sulfate. Their use in flowable systems for the storage and discharge of electrical charges is demonstrated.
ABSTRACT
Classic rotating engines are powerful and broadly used but are of complex design and difficult to miniaturize. It has long remained challenging to make large-stroke, high-speed, high-energy microengines that are simple and robust. We show that torsionally stiffened shape memory nanocomposite fibers can be transformed upon insertion of twist to store and provide fast and high-energy rotations. The twisted shape memory nanocomposite fibers combine high torque with large angles of rotation, delivering a gravimetric work capacity that is 60 times higher than that of natural skeletal muscles. The temperature that triggers fiber rotation can be tuned. This temperature memory effect provides an additional advantage over conventional engines by allowing for the tunability of the operation temperature and a stepwise release of stored energy.
Subject(s)
Artificial Organs , Carbon Fiber , Muscle Fibers, Skeletal/chemistry , Nanocomposites , Smart MaterialsABSTRACT
High electromechanical coupling is critical to perform effective conversion between mechanical and electrical energy for various applications of electrostrictive polymers. Herein, a giant electrostriction effect is reported in liquid crystalline graphene-doped dielectric elastomers. The materials are formulated by a phase-transfer method which allows the solubilization of graphenic monolayers in nonpolar solvents. Dielectric spectroscopy is combined with tensile test devices to measure the true electrostriction coefficients with differentiating the Maxwell stress effect. Because of their liquid crystal structure, the resultant composites show an ultralarge electrostriction coefficient (â¼10-14 m2/V2 at 0.1 Hz) coupled with good reproducibility during cycles at high deformation rates. This work offers a promising pathway to design high-performance electrostrictive polymer composites as well as to provide insights into mechanisms of true electrostriction in electrically heterogeneous systems. The use of obtained materials as a supersensitive capacitive sensor is demonstrated.
ABSTRACT
Graphene flakes with giant shape anisotropy are extensively used to establish connectedness electrical percolation in various heterogeneous systems. However, the percolation behaviour of graphene flakes has been recently predicted to be far more complicated than generally anticipated on the basis of excluded volume arguments. Here we confirm experimentally that graphene flakes self-assemble into nematic liquid crystals below the onset of percolation. The competition of percolation and liquid crystal transition provides a new route towards high-k materials. Indeed, near-percolated liquid-crystalline graphene-based composites display unprecedented dielectric properties with a dielectric constant improved by 260-fold increase as compared with the polymer matrix, while maintaining the loss tangent as low as 0.4. This performance is shown to depend on the structure of monodomains of graphene liquid-crystalline phases. Insights into how the liquid crystal phase transition interferes with percolation transition and thus alters the dielectric constant are discussed.
ABSTRACT
Study of flexible nanodielectric materials (FNDMs) with high permittivity is one of the most active academic research areas in advanced functional materials. FNDMs with excellent dielectric properties are demonstrated to show great promise as energy-storage dielectric layers in high-performance capacitors. These materials, in common, consist of nanoscale particles dispersed into a flexible polymer matrix so that both the physical/chemical characteristics of the nanoparticles and the interaction between the nanoparticles and the polymers have crucial effects on the microstructures and final properties. This review first outlines the crucial issues in the nanodielectric field and then focuses on recent remarkable research developments in the fabrication of FNDMs with special constitutents, molecular structures, and microstructures. Possible reasons for several persistent issues are analyzed and the general strategies to realize FNDMs with excellent integral properties are summarized. The review further highlights some exciting examples of these FNDMs for power-energy-storage applications.
ABSTRACT
Dielectric properties of poly(vinylidene fluoride) (PVDF) based nanocomposites filled with surface hydroxylated BaTiO(3) (h-BT) nanoparticles were reported. The h-BT fillers were prepared from crude BaTiO(3) (c-BT) in aqueous solution of H(2)O(2). Results showed that the dielectric properties of the h-BT/PVDF nanocomposites had weaker temperature and frequency dependences than that of c-BT/PVDF nanocomposites. Meanwhile, the h-BT/PVDF composites showed lower loss tangent and higher dielectric strength. It is suggested that the strong interaction between h-BT fillers and PVDF matrix is the main reason for the improved dielectric properties.