Urban air quality in the Asian region.

Over the past decade, member states of the Regional Co-operation Agreement (RCA), an intergovernmental agreement for the East Asia and Pacific region under the auspices of the IAEA with the assistance of international organizations and financial institutions such as the World Bank and the Asian Development Bank, have started to set in place policies and legislation for air pollution abatement. To support planning and evaluate the effectiveness of control programs, data are needed that characterizes urban air quality. The focus of this measurement program describe in this report is on size segregated particulate air pollution. Such airborne particulate matter can have a significant impact on human health and urban visibility. These data provide the input to receptor models that may permit the mitigation of these impacts by identification and quantitative apportionment of the particle sources. The aim of this report is to provide an overview of the measurements of concentrations and composition of particulate air pollution in two size fractions across the participating countries. For many of the large cities in this region, the measured particulate matter concentrations are greater than air quality standards or guidelines that have been adopted in developed countries.

Determination of the elemental contents in stream sediments collected from Cheongju city by instrumental neutron activation analysis.

Sediment samples were collected from seven locations of the MeeHo stream in Cheongju city, strained out by a sieve, dried by an oven and pulverized by an agate mortar. Instrumental neutron activation analysis (INAA) was applied for the determination of the elemental contents in the sediment samples by using the NAA #1 and #2 irradiation holes of the HANARO research reactor and HPGe gamma-ray spectrometers. Twenty-five elements were determined by a relative method with NIST SRM 2711-Montan Soil and the ranges of the elemental contents for the seven locations were identified. The contamination levels for elements such as As, Ba, Cr, Mn, Fe and Zn were compared with the guidelines of USEPA. The detection limits and combined uncertainties for the hazardous elements such as As, Ba, Cr, Mn, Sb, V and Zn were estimated under the given analytical conditions.