Underwater dynamic polarization imaging without dependence on the background region.

Active-polarization imaging holds significant promise for achieving clear underwater vision. However, only static targets were considered in previous studies, and a background region was required for image restoration. To address these issues, this study proposes an underwater dynamic polarization imaging method based on image pyramid decomposition and reconstruction. During the decomposition process, the polarized image is downsampled to generate an image pyramid. Subsequently, the spatial distribution of the polarization characteristics of the backscattered light is reconstructed by upsampling, which recovered the clear scene. The proposed method avoids dependence on the background region and is suitable for moving targets with varying polarization properties. The experimental results demonstrate effective elimination of backscattered light while sufficiently preserving the target details. In particular, for dynamic targets, processing times that fulfill practical requirements and yield superior recovery effects are simultaneously obtained.

A strategy to build a library of oil tracers by oleophilic silica-encapsulated DNA nanoparticles.

Artificially synthesized DNA is involved in the construction of a library of oil tracers due to their unlimited number and no-biological toxicity. The strategy of the construction is proposed by oleophilic Silica-encapsulated DNA nanoparticles, which offers fresh thinking in developing novel tracers, sensors, and molecular machines in engineering & applied sciences based on artificially synthesized DNA blocks.

A Novel Preparation Method of Composite Bolted T-Joint with High Bending Performance Based on the Prepreg-RTM Co-Curing Process.

A co-curing resin system consisting of 9368 epoxy resin for prepreg and 6808 epoxy resin for resin transfer molding (RTM) was developed. A corresponding preparation method for a novel polymer composite bolted T-joint with internal skeleton and external skin was proposed based on the prepreg-RTM co-curing process, and novel T-joints were fabricated. A series of conventional configuration T-joints based on the RTM process and T-joints made of 2A12 aluminum alloy were prepared simultaneously. Bending performances were studied on these T-joints experimentally. The results indicate that 9368 epoxy resin and 6808 epoxy resin exhibit good compatibility in rheological and thermophysical properties. The novel T-joints prepared with the prepreg-RTM co-curing process show no obvious fiber local winding or resin-rich regions inside, and the interface quality between the internal skeleton and the external skin is excellent. The main failure modes of the novel T-joint under bending load include the separation of the skin and skeleton and the fracture along the thickness on the base panel; the skeleton carries the main bending load, but there is still load transfer between external skin and internal skeleton through their interface. The internal damages of the novel T-joint are highly consistent with surface damages observed visually, facilitating the detection and timely discovery of damages. The initial stiffness, damage initiation load, and ultimate load of the novel T-joint are 1.65 times, 5.89 times, and 3.45 times that of the conventional T-joint, respectively. When considering the influence of the density, the relative initial stiffness and relative ultimate load of the novel T-joint are 1.44 times and 2.07 times that of the aluminum alloy T-joint, respectively.