Modelling of Flexible Adhesives in Simple Mechanical States with the Use of the Darijani-Naghdabadi Strain Tensors and Kirchhoff-de Saint-Venant Elastic Potential.

Practical aspects of modelling of flexible adhesives with the energy conjugate measures of stress and strain of the Darijani-Naghdabadi (D-N) family are discussed. A possibility of description of materials exhibiting non-linear physical characteristics with the use of non-linear geometric relationships and linear elastic constitutive law is considered. Nominal stress vs. stretch relations are specified in cases of simple tension and simple shear with the use of the Kirchhoff-de Saint-Venant elastic potential and D-N energy conjugate stress and strain measures. Obtained theoretical estimates were compared with experimental results of simple tension and simple shear tests performed on Sika PM polyurethane (Cracow, Sika Poland). The deformation rate was fixed in order to minimize the influence of viscosity. Values of parameters α,ß in the definition of the D-N strain tensor were optimized in order to provide good agreement between model predictions and experimental results. Observed discrepancies indicate that the proposed approach is not appropriate for constitutive modelling of the PM polymer. The presented approach is proposed to be used as a simple design model providing practical formulas describing the behavior of materials of non-linear characteristics in chosen mechanical states. Admissible values of exponents α,ß are discussed regarding its bijectivity in a limited range of variation of principal stretches.

Deformable Polyurethane Joints and Fibre Grids for Resilient Seismic Performance of Reinforced Concrete Frames with Orthoblock Brick Infills.

The behaviour of reinforced concrete frames with masonry wall infills is influenced a lot by the stiffness and strength difference between the frame and the infill, causing early detrimental damage to the infill or to the critical concrete columns. The paper reports the results from shake table seismic tests on a full-scale reinforced concrete (RC) frame building with modified hollow clay block (orthoblock brick) infill walls, within INMASPOL SERA Horizon 2020 project. The building received innovative resilient protection using Polyurethane Flexible Joints (PUFJs) made of polyurethane resin (PU), applied at the frame-infill interface in different schemes. Further, PUs were used for bonding of glass fibre grids to the weak masonry substrate to form Fibre Reinforced Polyurethanes (FRPUs) as an emergency repair intervention. The test results showed enhancement in the in-plane and out-of-plane infill performance under seismic excitations. The results confirmed remarkable delay of significant infill damages at very high RC frame inter-story drifts as a consequence of the use of PUFJs. Further, the PUFJ protection enabled the resilient repair of the infill even after very high inter-story drift of the structure up to 3.7%. The applied glass FRPU system efficiently protected the damaged infills against collapse under out-of-plane excitation while they restored large part of their in-plane stiffness.

Recent advances of ultrasonic testing of cement based materials at early ages.

To summarize some of the most important findings in the field of ultrasonic (US) testing of early age hydration and formation of structure of different cement based materials (CBMs), a review of literature with focus on US P-wave transmission and S-wave reflection methods is presented in this paper. The review shows a great ability of both US techniques to observe setting phenomena and to determine different milestones during the early age formation of CBM's microstructure. Clear physical basis, high accuracy, and non-destructive nature of the method indicate that US methods could become standardized in the near future.