RESUMEN
Objective: Klinefelter syndrome (KS) is associated with increased risk of thrombosis. Hypogonadism and accumulating body fat in KS have a potential impact on fibrinolysis. In this study, we assessed the fibrinolytic system and the association with testosterone levels in KS. Design: This study is a cross-sectional comparison of men with KS and age-matched male controls. Methods: Fibrin clot lysis was evaluated by turbidity measurements and by measuring levels of individual fibrinolytic proteins in plasma samples. Fibrin clot structure was evaluated by scanning electron microscopy. Total testosterone was measured by liquid chromatography-tandem mass spectrometry. Body fat was evaluated by dual-energy X-ray absorptiometry. Results: In this study, 45 men with KS and 45 age- and education-matched controls were included. Men with KS had a 24% reduction in fibrin clot lysis compared with controls (46.2 ± 17.1 vs 60.6 ± 18.8 %/h, P = 0.0003) and higher levels of fibrinogen, factor XIII (P ≤ 0.01), and plasminogen activator inhibitor type 1 (P = 0.04). Men with KS had lower total testosterone (P = 0.008) and higher body fat (P = 0.001). In KS, reduced fibrin clot lysability was associated with higher fibrinogen and body fat related to decreasing total testosterone and hypogonadism among men with KS. Fibrin clot structure was not different compared to KS and controls. Conclusions: Fibrin clot lysis in KS was markedly reduced, potentially contributing to a prothrombotic state and increasing thrombotic risk. Hypogonadism in KS was associated with increased fibrinogen and total body fat, predicting reduced fibrin clot lysis.
RESUMEN
This work explores a new technique for the out-of-plane patterning of metal thin films prefabricated on the surface of a polymer substrate. This technique is based on an ion-beam-induced material modification in the bulk of the polymer. Effects of subsurface and surface processes on the surface morphology have been studied for three polymer materials: poly(methyl methacrylate), polycarbonate, and polydimethylsiloxane, by using focused ion beam irradiation with He+, Ne+, and Ga+. Thin films of a Pt60Pd40 alloy and of pristine Au were used to compare the patterning of thin films with different microstructures. We show that the height of Pt60Pd40 thin films deposited onto poly(methyl methacrylate) and polycarbonate substrates can be patterned by He+ ion beams with ultrahigh precision (nanometers) while preserving in-plane features, at the nanoscale, of the pre-deposited films. Ion irradiation of the Au-coated samples results in delamination, bulging, and perforation of the Au film, which is attributed to the accumulation of gases from radiolysis at the film-substrate interface. The irradiation with Ne+ and Ga+ ions destroys the films and roughens the surface due to dominating sputtering processes. A very different behavior, resulting in the formation of complex, multiscale 3D patterns, is observed for polydimethylsiloxane samples. The roles of the metal film structure, elastic properties of the polymer substrate, and irradiation-induced mechanical strain in the patterning process are elaborated and discussed.