Determination of nitrofurantoin, furazolidone and furaltadone in milk by high-performance liquid chromatography with electrochemical detection.

A HPLC method with coulometric detection has been established to carry out the separation of the three nitrofuran derivatives, nitrofurantoin, furazolidone and furaltadone. A Nova-Pak C18 column (150 x 3.9 mm) and a Coulochem II detector from ESA have been used. After obtaining the hydrodynamic curves of the three compounds in the porous graphite electrode a potential of -600 mV was selected as the working potential. The influence of other variables such as mobile phase composition and flow-rate were studied. The mobile phase considered as an optimum was acetonitrile-0.1 M aqueous solution of sodium perchlorate (28:72), with 0.5% glacial acetic acid. The oxygen of the mobile phase was removed with a vacuum system on-line and a nitrogen stream was used to remove the oxygen of the samples. The calibration graphs and the detection limits were established. The method proposed was used, with good results, for the determination of the three compounds in milk.

Rapid and sensitive determination of 4-nitrophenol, 3-methyl-4-nitrophenol, 4,6-dinitro-o-cresol, parathion-methyl, fenitrothion, and parathion-ethyl by liquid chromatography with electrochemical detection.

Liquid chromatography with electrochemical detection has been used to determine various nitropesticides, DNOC, fenitrothion, and parathion (methyl and ethyl), and some of their main metabolites, 4-nitrophenol for parathion (methyl and ethyl) and 3-methyl-4-nitrophenol for fenitrothion, by using indirect detection. Analysis of them in river water samples has been performed without a preconcentration step. The recovery efficiencies of the tested compounds yielded values between 96 and 112% at the fortification level of 0.5 ppb in a river water sample, and their relative standard deviations were between 1 and 15%. The detection limits of these compounds ranged between 0.05 and 0.14 ppb.

Rapid kinetic spectrophotometric determination of phosalone (Zolone) in a commercial formulation.

A kinetic study of the degradation of phosalone in an alkaline medium was undertaken by using a pneumatic stopped-flow system. A rapid semiautomatic method is proposed for determining phosalone. Linear calibration graphs up to 8.0 x 10(-5) M (detection limit = 1.40 x 10(-6) M) were obtained, with a measurement period of only 3.5 s per sample and a relative standard deviation of 1.4%. Several pesticides were assayed as interference species, and several did not interfere even at a 6:1, M:M foreign species/phosalone ratio. A strong interference (ratio < 1) was generated by azinphos-methyl and carbaryl. The proposed method was applied to the analysis of a commercial formulation, and the results were validated by comparison with those for a chromatographic method.

Simultaneous determination of quinolones for veterinary use by high-performance liquid chromatography with electrochemical detection.

A selective method based on high-performance liquid chromatography with electrochemical detection (HPLC-ECD) has been developed to enable simultaneous determination of three fluoroquinolones (FQs), namely danofloxacin (DANO), difloxacin (DIFLO) and sarafloxacin (SARA). The fluoroquinolones are separated on a Novapack C-18 column and detected in a high sensitivity amperometric cell at a potential of +0.8 V. Solid-phase extraction was used for the extraction of the analytes in real samples. The range of concentration examined varied from 10 to 150 ng g(-1) for danofloxacin, from 25 to 100 ng g(-1) for sarafloxacin and from 50 to 315 ng g(-1) for difloxacin, respectively. The method presents detection limits under 10 ng g(-1) and recoveries around 90% for the three analytes have been obtained in the experiments with fortified samples. This HPLC-ECD approach can be useful in the routine analysis of antibacterial residues being less expensive and less complicated than other more powerful tools as hyphenated techniques.

Quantification of danofloxacin and difloxacin in chicken tissues in the presence of sarafloxacin as interference.

A new spectrofluorimetric method has been developed for the quantification of danofloxacin (DANO) and difloxacin (DIFLO), in the presence of the primary metabolite of difloxacin, with sarafloxacin (SARA) as interference, in chicken tissue samples. The method is based on second-order multivariate calibration, applying parallel factor analysis (PARAFAC), to the excitation-emission matrices (EEMs) of these compounds. High overlapping of the signals and influence of matrix effects were observed. To solve the problem, the standard addition method was used. Chemical variables were optimized. The measured EEMs of the analytes, as analytical signals, allowed their quantification in chicken tissue samples. Solid phase extraction was used for the extraction of the analytes in real samples. The range of concentration examined varied from 30 to 100 ng g(-1) for danofloxacin, and from 100 to 200 ng g(-1) for difloxacin. Both analytes can be analyzed individually, and the binary mixture can be resolved, with recoveries comprising between 88.7 and 106.6%.

Adsorptive stripping square wave voltammetry (Ad-SSWV) accomplished with second-order multivariate calibration determination of fenitrothion and its metabolites in river water samples.

A method, using stripping square wave voltammetry (Ad-SSWV), for the simultaneous determination of fenitrothion (FEN) and its metabolites: fenitrooxon (OXON) and 3-methyl-4-nitrophenol (3-MET) in environmental samples is reported. All three compounds produce, at mercury electrode (HMDE), an electrochemical signal due to an adsorptive-reductive process. The electrochemical approach shows a very high overlap degree for FEN and OXON voltammograms, however the adsorption kinetic profile could be used as an additional differential variable between both analytes. Second-order multivariate calibration has been tested to solve the mixture of the three compounds. The second-order assayed methods were parallel factor analysis (PARAFAC), unfolded partial least squares (U-PLS), multidimensional partial least squares (N-PLS) and the latest ones were used in combination with the residual bilinearization procedure RBL. U-PLS/RBL model was stated as the best second-order algorithm for the simultaneous determination of these three compounds up to 50 ng mL(-1) for each analyte. The detection limits and recovery values were 1.6 ng mL(-1) and 92+/-7% for FEN; 3.7 ng mL(-1) and 101+/-9% for OXON and 0.6 ng mL(-1) and 97+/-8% for 3-MET.