Experimental Demonstration of the Stabilizing Effect of Dielectric Coatings on Magnetically Accelerated Imploding Metallic Liners.

Enhanced implosion stability has been experimentally demonstrated for magnetically accelerated liners that are coated with 70 µm of dielectric. The dielectric tamps liner-mass redistribution from electrothermal instabilities and also buffers coupling of the drive magnetic field to the magneto-Rayleigh-Taylor instability. A dielectric-coated and axially premagnetized beryllium liner was radiographed at a convergence ratio [CR=Rin,0/Rin(z,t)] of 20, which is the highest CR ever directly observed for a strengthless magnetically driven liner. The inner-wall radius Rin(z,t) displayed unprecedented uniformity, varying from 95 to 130 µm over the 4.0 mm axial height captured by the radiograph.

Transformation of a tungsten wire to the plasma state by nanosecond electrical explosion in vacuum.

Experiment demonstrates the first direct transformation of a tungsten wire core to the plasma state by Joule heating during nanosecond electrical explosion in vacuum. Energy of approximately 130 eV/atom was deposited into the 12 microm W wire coated by 2 microm polyimide during the first approximately 10 ns. All the metal rapidly transformed to highly ionized plasma, while the surrounding polyimide coating remained primarily in a gaseous state. This coating totally suppressed corona formation. The expansion velocity of the wire was approximately 12-18 km/s, the average wire ionization at 50 ns reached approximately 67% with corresponding LTE temperature of approximately 1.2 eV . Explosion of bare W wire demonstrated earlier termination of the wire core heating due to shunting corona generation. Magnetohydrodynamic (MHD) simulation reproduces the main features of coated and uncoated W wire explosion.

Thermodynamical calculation of metal heating in nanosecond exploding wire and foil experiments.

A method of thermodynamical calculation of thin metal wire heating during its electrical explosion is discussed. The technique is based on a calculation of Joule energy deposition taking into account the current wave form and the temperature dependence of the resistivity and heat capacity of the metal. Comparing the calculation to a set of exploding tungsten wire experiments demonstrates good agreement up to the time of melting. Good agreement is also demonstrated with resistive magnetohydrodynamics simulation. A similar thermodynamical calculation for Mo, Ti, Ni, Fe, Al, and Cu shows good agreement with experimental data. The thermodynamical technique is useful for verification of the voltage measurements in exploding wire experiments. This technique also shows good agreement with an exploding W foil experiment.

Nanosecond electrical explosion of thin aluminum wires in a vacuum: experimental and computational investigations.

Experimental and computational investigations of nanosecond electrical explosion of a thin Al wire in vacuum are presented. We have demonstrated that increasing the current rate leads to increased energy deposited before voltage collapse. The experimental evidence for synchronization of the wire expansion and light emission with voltage collapse is presented. Hydrocarbons are indicated in optical spectra and their influence on breakdown physics is discussed. The radial velocity of low-density plasma reaches a value of approximately 100 km/s. The possibility of an over-critical phase transition due to high pressure is discussed. A one-dimensional magnetohydrodynamic (MHD) simulation shows good agreement with experimental data. The MHD simulation demonstrates separation of the exploding wire into a high-density cold core and a low-density hot corona as well as fast rejection of the current from the wire core to the corona during voltage collapse. Important features of the dynamics for the wire core and corona follow from the MHD simulation and are discussed.

Wire initiation critical for radiation symmetry in z-pinch-driven dynamic hohlraums.

Axial symmetry in x-ray radiation of wire-array z pinches is important for the creation of dynamic hohlraums used to compress inertial-confinement-fusion capsules. We present the first evidence that this symmetry is directly correlated with the magnitude of the negative radial electric field along the wire surface. This field (in turn) is inferred to control the initial energy deposition into the wire cores, as well as any current shorting to the return conductor.

Corona-free electrical explosion of polyimide-coated tungsten wire in vacuum.

We present experimental evidence of corona-free electrical explosion of dielectric-coated W wire in vacuum. A fast current rise of approximately 150 A/ns and a coating of 2 microm polyimide are both needed to achieve the corona-free regime of explosion. Breakdown is absent in corona-free explosion; the wire remains resistive, and this allows anomalously high energy deposition (approximately 20 times atomization enthalpy). MHD simulations reproduce the main differences between corona and corona-free explosions. A corona-free explosion of a wire can be useful for the generation of a hot plasma column by direct energy deposition.

Distinguishability of biological material by use of ultraviolet multispectral fluorescence.

Recent interest in the detection and analysis of biological samples by spectroscopic methods has led to questions concerning the degree of distinguishability and biological variability of the UV fluorescent spectra from such complex samples. We show that the degree of distinguishability of such spectra is readily determined numerically. As a practical example of this technique, we show its application to the analysis of UV fluorescence spectra taken of E. coli, S. aureus, and S. typhimurium. The use of this analysis to determine the degree of biological variability and also to verify that measurements are being made in a linear regime in which analytic methods such as multivariate analysis are valid is discussed.