Internal Cylinder Identification Based on Different Transmission of Longitudinal and Shear Ultrasonic Waves.

We have built a Fizeau fiber interferometer to investigate the internal cylindrical defects in an aluminum plate based on laser ultrasonic techniques. The ultrasound is excited in the plate by a Q-switched Nd:YAG laser. When the ultrasonic waves interact with the internal defects, the transmitted amplitudes of longitudinal and shear waves are different. The experimental results show that the difference in transmission amplitudes can be attributed to the high frequency damping of internal cylinders. When the scanning point is close to the internal defect, the longitudinal waves attenuate significantly in the whole defect area, and their amplitude is always smaller than that of shear waves. By comparing the transmitted amplitudes of longitudinal and shear waves at different scanning points, we can achieve a C scan image of the sample to realize the visual inspection of internal defects. Our system exhibits outstanding performance in detecting internal cylinders, which could be used not only in evaluating structure cracks but also in exploring ultrasonic transmission characteristics.

High Sensitivity Refractometer Based on a Tapered-Single Mode-No Core-Single Mode Fiber Structure.

We have proposed a novel tapered-single mode-no core-single mode (TSNS) fiber refractometer based on multimode interference. The TSNS structure exhibits a high contrast ratio (＞15 dB) and a uniform interference fringe. The influence of different lengths and diameters of the TSNS on the refractive index unit (RIU) sensitivity was investigated. The experimental investigations indicated a maximum sensitivity of 1517.28 nm/RIU for a refractive index of 1.417 and low-temperature sensitivity (＜10 pm/ºC). The experimental and simulation results are also in good agreement.

An in-fiber integrated optofluidic device based on an optical fiber with an inner core.

A new kind of optofluidic in-fiber integrated device based on a specially designed hollow optical fiber with an inner core is designed. The inlets and outlets are built by etching the surface of the optical fiber without damaging the inner core. A reaction region between the end of the fiber and a solid point obtained after melting is constructed. By injecting samples into the fiber, the liquids can form steady microflows and react in the region. Simultaneously, the emission from the chemiluminescence reaction can be detected from the remote end of the optical fiber through evanescent field coupling. The concentration of ascorbic acid (AA or vitamin C, Vc) is determined by the emission intensity of the reaction of Vc, H2O2, luminol, and K3Fe(CN)6 in the optical fiber. A linear sensing range of 0.1-3.0 mmol L(-1) for Vc is obtained. The emission intensity can be determined within 2 s at a total flow rate of 150 µL min(-1). Significantly, this work presents information for the in-fiber integrated optofluidic devices without spatial optical coupling.

[Fat particle injection auto-transplantation a 10-year review].

OBJECTIVE: To summarize clinical experiences in fat particle injection auto-transplantation during the past ten years. METHODS: Retrospective analysis of 334 cases of fat particle injection auto-transplantation was done, and we suggested the correct method of liposuction and fat injection. RESULTS: In this series, one patient (0.29%) had a complication, thirty one patients (9.38%) had lower survival of autogenous fat-transplantation. CONCLUSION: In order to improve the results of fat-grafting, we must adopt the correct method of liposuction and follow the right rules.