RESUMEN
We study the structural and electronic properties of beryllium (Be) and magnesium (Mg) clusters for sizes 2-20 using a two-step approach. In the first step, a global search of the stable and low-lying metastable isomer structures is carried out on the basis of first-principles potential energy surfaces at the level of the generalized gradient approximation (GGA) of density functional theory (DFT). In the second step, vertical ionization potentials (VIPs) and energy gaps between the highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) are determined using the G0W0 methods for up to the fourth-lowest-energy isomers. Novel globally lowest-energy isomer structures are identified for Be14, Mg14, and Mg16 clusters. The van der Waals interactions are found to have a stronger influence on Mg clusters than on Be clusters. A second-difference analysis for both the binding energies and HOMO-LUMO gaps reveals a close relationship between the structural stability and chemical hardness for both types of clusters.
RESUMEN
The optoelectronic and structural characteristics of the Zn1-xCrxSe (0 ≤ x ≤ 1) semiconductor are reported by employing density functional theory (DFT) within the mBJ potential. The findings revealed that the lattice constant decreases with increasing Cr concentration, although the bulk modulus exhibits the opposite trend. ZnSe is a direct bandgap material; however, a change from direct to indirect electronic bandgap has been seen with Cr presence. This transition is caused by structural alterations by Cr and defects forming, which results in novel optical features, including electronic transitions. The electronic bandgap decreases from 2.769 to 0.216 eV, allowing phonons to participate and improving optical absorption. A higher concentration of Cr boosts infrared absorption and these Cr-based ZnSe (ZnCrSe) semiconductors also cover a wider spectrum in the visible range from red to blue light. Important optical parameters such as reflectance, optical conductivity, optical bandgap, extinction coefficient, refractive index, magnetization factor, and energy loss function are discussed, providing a theoretical understanding of the diverse applications of ZnCrSe semiconductors in photonic and optoelectronic devices.
RESUMEN
The structural and electronic properties of zinc clusters (Znn) for a size range of n = 2-15 are studied using density functional theory. The particle swarm optimization algorithm is employed to search the structure and to determine the ground-state structure of the neutral Zn clusters. The structural motifs are optimized using the density functional theory approach to ensure that the structures are fully relaxed. Results are compared with the literature to validate the accuracy of the prediction method. The binding energy per cluster is obtained and compared with the reported literature to study the stability of these structures. We further assess the electronic properties, including the ionization potential, using the all-electron FHI-aims code employing G0W0 calculations, and the G0W0Ð0(1) correction for a few smaller clusters, which provides a better estimation of the ionization potential compared to other methods.
RESUMEN
The change in composition and pressure, both of which lead to new desired properties by altering the structure, is particularly important for improving device performance. Given this, we focused here on the mechanical, elastic, and optoelectronic characteristics of the Cd0.75Zn0.25Se alloy using density functional theory at various pressures from 0 GPa to 20 GPa. It is found that the bulk modulus of the material rises with increasing pressure and exhibits mechanical stability as well as cubic symmetry. In addition, the increased pressure leads to a rise in the direct bandgap energy of the material from 2.03 eV to 2.48 eV. The absorption coefficient of the alloy also increases as the pressure increases, where the effective range of absorption covers the broad spectrum of light in the visible range from orange to cyan. This is due to the electronic transitions caused by the altered pressure. The optical parameters, including optical conductivity, extinction coefficient, reflection, and refractive index, are also analyzed under the influence of pressure. Based on this research, effective applications of the Cd substituted Zn-chalcogenides (CdZnSe) alloys in the fields of optoelectronics and photovoltaics are outlined, especially concerning fabricating solar cells, photonic devices, and pressure sensors for space technology.
RESUMEN
Electronic and structural properties of calcium clusters with a varying size range of 2-20 atoms are studied using a two-step scheme within the GW and density functional theory (DFT) with generalized gradient approximation (GGA). The GGA overestimates the binding energies, optimized geometries, electron affinities, and ionization potentials reported in the benchmark. The ground-state structure geometry and binding energy were obtained from the DFT for the ground-state structure of each cluster. The binding energy of the neutral clusters of the calcium series follows an increasing trend, except for a few stable even and odd clusters. The electronic properties of the calcium cluster were studied with an all-electron FHI-aims code. In the G 0 W 0 calculation, the magic cluster Ca10 has relatively high ionization potential and low electron affinity. The obtained ionization potentials from the G 0 W 0 @PBE calculation showed that the larger cluster has less variation, whereas the electron affinities of the series have an increasing trend. The ionization potentials from the G 0 W 0 benchmark for the calcium cluster series have not yet been described in the literature.
RESUMEN
This study explores the nuclear magnetic shielding, chemical shifts, and the optoelectronic properties of the BiMnVO5 compound using the full-potential linearized augmented plane wave method within the generalized gradient approximation by employing the Hubbard model (GGA + U). The 209Bi and 51V chemical shifts and bandgap values of the BiMnVO5 compound in a triclinic crystal structure are found to be directly related to Hubbard potential. The relationship between the isotropic nuclear magnetic shielding σiso and chemical shift δiso is obtained with a slope of 1.0231 and - 0.00188 for 209Bi and 51V atoms, respectively. It is also observed that the bandgap, isotropic nuclear magnetic shielding, and chemical shifts increase with the change in Hubbard potentials (U) of 3, 4, 5, 6, and 7.
RESUMEN
A change in the composition and dopant content of selective atoms in a material leads to their new desired properties by altering the structure, which can significantly improve the performance of relevant devices. By acknowledging this, we focused on characterizing the optoelectronic and structural properties of cadmium-substituted zinc selenide (Zn1-xCdxSe; 0 ≤ X ≤ 1) semiconductors using density functional theory (DFT) within the generalized gradient approximation (GGA), EV-GGA, and mBJ approximations. The results proved the cubic symmetry of the investigated materials at all Cd concentrations (0, 0.25, 0.50, 0.75, and 1). Although a linear surge in the lattice constant is observed with the change in Cd content, the bulk modulus exhibits a reverse trend. These materials are observed to be direct bandgap semiconductors at all Cd concentrations, with a decrease in electronic bandgap from 2.76 eV to 1.87 eV, and have isotropic optical properties, showing their potential applicability as a blue-to-red display. The fundamental optical properties of the materials, such as optical conductivity, reflectance, refractive index, absorption, and extinction coefficient, are also discussed. These outcomes provide a computational understanding of the diverse applications of Zn1-xCdxSe semiconductors in optoelectronic, photonic, and photovoltaic devices, particularly for a visible-range display.
RESUMEN
This study reports light energy harvesting characteristics of bismuth ferrite (BiFeO3) and BiFO3 doped with rare-earth metals such as neodymium (Nd), praseodymium (Pr), and gadolinium (Gd) dye solutions that were prepared by using the co-precipitation method. The structural, morphological, and optical properties of synthesized materials were studied, confirming that 5-50 nm sized synthesized particles have a well-developed and non-uniform grain size due to their amorphous nature. Moreover, the peaks of photoelectron emission for bare and doped BiFeO3 were observed in the visible region at around 490 nm, while the emission intensity of bare BiFeO3 was noticed to be lower than that of doped materials. Photoanodes were prepared with the paste of the synthesized sample and then assembled to make a solar cell. The natural and synthetic dye solutions of Mentha, Actinidia deliciosa, and green malachite, respectively, were prepared in which the photoanodes were immersed to analyze the photoconversion efficiency of the assembled dye-synthesized solar cells. The power conversion efficiency of fabricated DSSCs, which was confirmed from the I-V curve, is in the range from 0.84 to 2.15%. This study confirms that mint (Mentha) dye and Nd-doped BiFeO3 materials were found to be the most efficient sensitizer and photoanode materials among all the sensitizers and photoanodes tested.