RESUMEN
In the present work, the performance of ultra-high molecular weight polyethylene (UHMWPE) barrier nets in marine environments is investigated by Fourier transform infrared spectroscopy, thermogravimetry, scanning electron microscopy, and tensile experiments. The chemical, morphological, thermal stability, and strength changes after aging in salt spray, hygrothermal, and ultraviolet (UV) environments are characterized. An environmental spectrum is designed to simulate a real service environment and predict the service life of UHMWPE. The results show that UV energy can activate UHMWPE molecules and lead to chain breaking, which lowers the breaking strength more efficiently than salt spray. In a hygrothermal environment, the UHMPE fibers bond into clumps, which causes a slight increase in breaking strength after the initial rapid decrease with aging time. The acceleration ratio of the environmental spectrum increases with increasing aging time, which may be caused by the cross-linking and degradation of macromolecular chains in the material. The environmental spectrum given by this work can be used to evaluate performance and predict the service life of UHMWPE barrier nets in marine environments.
RESUMEN
Electrochemical H charging, hydrogen permeation, and hydrogen-induced cracking (HIC) behavior of 690 MPa grade steel substrate and different heat-treatment states (annealed, quenched, normalized, tempered) are investigated by cyclic voltammetry (CV), hydrogen permeation, electrochemical H charging, and slow strain rate tensile test (SSRT). The results show that hydrogen diffuses through the steel with the highest rate in base metal and the lowest rate in annealed steel. The hydrogen-induced cracks in base metal show obvious step shape with tiny cracks near the main crack. The cracks of annealed steel are mainly distributed along pearlite. The crack propagation of quenched steel is mainly transgranular, while the hydrogen-induced crack propagation of tempered steel is along the prior austenite grain boundary. HIC sensitivity of base metal is the lowest due to its fine homogeneous grain structure, small hydrogen diffusion coefficient, and small hydrogen diffusion rate. There are many hydrogen traps in annealed steel, such as the two-phase interface which provides accommodation sites for H atoms and increases the HIC susceptibility.
RESUMEN
N enriched microporous active carbons (CACs) were successfully obtained with coffee grounds as precursor and KOH as activator, which were used for the capture and conversion of CO2 from post-combustion. The influence of preparation parameters, such as the temperature of activation and KOH/carbon ratio on textural properties of CACs were studied. N2 adsorption-desorption, XRD, Raman, SEM and XPS were used for characterization of the CACs. The adsorption capacities of CO2 CACs-2-800 are 6.22 mmol·g-1 (1 bar) and 2.37 mmol·g-1 (0.15 bar) at 273 K. CACs-2-800 also have high selectivity of CO2/N2 (SCO2/N2 = 33) and good adsorption-desorption recycle stability. Furthermore, the CACs-2-800 showed high catalytic activity for the cycloaddition of CO2 to epichlorohydrin. The good CO2 adsorption capacity, selectivity and catalytic performance indicated that CACs-2-800 could be used for the capture and conversion of CO2 from post-combustion.
Asunto(s)
Dióxido de Carbono , Carbón Orgánico , Adsorción , Café , TemperaturaRESUMEN
The influence of rare earth element (RE) Y on the microstructure and corrosion behavior of extruded AZ91 Mg alloy was surveyed via morphology characterization and corrosion performance measurements. The results indicate the corrosion resistance of the transversal section of AZ91 Mg alloy containing Y was improved compared with AZ91 Mg alloy without Y. The corrosion resistance of the longitudinal section of AZ91 Mg alloy with Y was lower than that of AZ91 Mg alloy without Y. The change of corrosion resistance can be attributed to the dispersion and volume fraction of the second phase, the effect of cathodic reduction rate, and the refined second phase.
RESUMEN
Influence of alternating current (AC) on pitting corrosion and stress corrosion cracking (SCC) behavior of X70 pipeline steel in the near-neutral pH environment under cathodic protection (CP) was investigated. Both corrosion and SCC are inhibited by -0.775 VSCE CP without AC interference. With the superimposition of AC current (1-10 mA/cm²), the direct current (DC) potential shifts negatively under the CP of -0.775 VSCE and the cathodic DC current decreases and shifts to the anodic direction. Under the CP potential of -0.95 VSCE and -1.2 VSCE, the applied AC current promotes the cathodic reaction and leads to the positive shift of DC potential and increase of cathodic current. Local anodic dissolution occurs attributing to the generated anodic current transients in the positive half-cycle of the AC current, resulting in the initiation of corrosion pits (0.6-2 µm in diameter). AC enhances the SCC susceptibility of X70 steel under -0.775 VSCE CP, attributing to the promotion of anodic dissolution and hydrogen evolution. Even an AC current as low as 1 mA/cm² can enhance the SCC susceptibility.