RESUMEN
We present two new microfabricated cantilever-beam force transducers. The transducers were fabricated from thin silicon-nitride films, and were used respectively to measure forces generated by two small-muscle preparations: the single myofibril, and the single actin filament in contact with a myosin-coated surface. A simple resonance method was developed to characterize the transducers. Because of the high reproducibility of lever dimensions and the consistency of the modulus of elasticity, few calibration measurements sufficed to characterize the stiffness of all the levers on a single wafer.
Asunto(s)
Biología Celular/instrumentación , Transductores , Calibración , Elasticidad , Diseño de Equipo , Fluorescencia , Ensayo de Materiales , Microscopía de Contraste de Fase , Microscopía por Video , Miofibrillas , Reproducibilidad de los Resultados , Silicio , Propiedades de SuperficieRESUMEN
The modulation of microvascular blood flow by vasomotion in the individual vessels of a simple vascular network was simulated by means of a network thermodynamic model. The flow is driven under a pulsating pressure through two arcades of branching vasoactive arterioles into a passive resistance representing the capillary and venular beds. Each vessel was assumed to have the capability of decreasing rhythmically the local diameter over a short section by a specified fraction of the maximum value and to change the average diameter along its total length in response to alterations in intraluminal pressure. Blood was assumed to exhibit a simple linear viscous flow resistance. Alterations in flow rate and distribution through the network were determined as a function of the magnitude and frequency of vasomotion within the individual arterioles supplying blood to the microvascular bed. Specific cases are shown to illustrate how blood flow can be influenced by the patterns of vasomotion within the network.