RESUMEN
Mesenchymal adipose stromal cells (ASCs) are considered the most promising and accessible material for translational medicine. ASCs can be used independently or within the structure of scaffold-based constructs, as these not only ensure mechanical support, but can also optimize conditions for cell activity, as specific features of the scaffold structure have an impact on the vital activity of the cells. This manuscript presents a study of the secretion and accumulation that occur in a conditioned medium during the cultivation of human ASCs within the structure of such a partial skin-equivalent that is in contact with it. It is demonstrated that the ASCs retain their functional activity during cultivation both within this partial skin-equivalent structure and, separately, on plastic substrates: they proliferate and secrete various proteins that can then accumulate in the conditioned media. Our comparative study of changes in the conditioned media during cultivation of ASCs on plastic and within the partial skin-equivalent structure reveals the different dynamics of the release and accumulation of such secretory factors in the media under a variety of conditions of cell functioning. It is also demonstrated that the optimal markers for assessment of the ASCs' secretory functions in the studied partial skin-equivalent structure are the trophic factors VEGF-A, HGF, MCP, SDF-1α, IL-6 and IL-8. The results will help with the development of an algorithm for preclinical studies of this skin-equivalent in vitro and may be useful in studying various other complex constructs that include ASCs.
Asunto(s)
Quimiocina CXCL12 , Interleucina-6 , Interleucina-8 , Células Madre Mesenquimatosas , Factor A de Crecimiento Endotelial Vascular , Humanos , Quimiocina CXCL12/metabolismo , Células Madre Mesenquimatosas/metabolismo , Células Madre Mesenquimatosas/citología , Medios de Cultivo Condicionados , Factor A de Crecimiento Endotelial Vascular/metabolismo , Interleucina-6/metabolismo , Interleucina-8/metabolismo , Factor de Crecimiento de Hepatocito/metabolismo , Células Cultivadas , Piel/metabolismo , Piel/citología , Proliferación Celular , Quimiocina CCL2/metabolismo , Tejido Adiposo/citología , Tejido Adiposo/metabolismoRESUMEN
The demand for regenerative medicine products is growing rapidly in clinical practice. Unfortunately, their use has certain limitations. One of these, which significantly constrains the widespread distribution and commercialization of such materials, is their short life span. For products containing suspensions of cells, this issue can be solved by using cryopreservation. However, this approach is rarely used for multicomponent tissue-engineered products due to the complexity of selecting appropriate cryopreservation protocols and the lack of established criteria for assessing the quality of such products once defrosted. Our research is aimed at developing a cryopreservation protocol for an original hydrogel scaffold with encapsulated MSCs and developing a set of criteria for assessing the quality of their functional activity in vitro. The scaffolds were frozen using two alternative types of cryocontainers and stored at either -40 °C or -80 °C. After cryopreservation, the external state of the scaffolds was evaluated in addition to recording the cell viability, visible changes during subsequent cultivation, and any alterations in proliferative and secretory activity. These observations were compared to those of scaffolds cultivated without cryopreservation. It was shown that cryopreservation at -80 °C in an appropriate type of cryocontainer was optimal for the hydrogels/adipose-derived stem cells (ASCs) tested if it provided a smooth temperature decrease during freezing over a period of at least three hours until the target values of the cryopreservation temperature regimen were reached. It was shown that evaluating a set of indicators, including the viability, the morphology, and the proliferative and secretory activity of the cells, enables the characterization of the quality of a tissue-engineered construct after its withdrawal from cryopreservation, as well as indicating the effectiveness of the cryopreservation protocol.
RESUMEN
This article provides the results of a study of the interaction of placental growth factor with adipose-derived stem cells (ASCs) of various origins, as well as the possibility of generating osteoplastic material based on xenogeneic matrix functionalization with human placental growth factor (PLGF). It is demonstrated that the greatest release of this factor from the functionalized material into the medium occurs during the first 3 h of contact with the model medium, but then the levels of the factor being released fall sharply, although release did continue throughout the 7 days of observation. The modified material was not cytotoxic, and its surface provided good cell adhesion. During 3 days of cultivation, the ASCs proliferated and migrated more actively on the surfaces of the modified material than on the surfaces of the control material. This study can serve as the basis for the development of original methods to functionalize such osteoplastic material by increasing PLGF immobilization by creating stronger bonds in order to regulate both factor dosage and the dynamics of the factor release into the environment. Further studies in experimental animals should facilitate assessment of the effectiveness of the functionalized materials. Such studies will be useful in the development of osteoplastic materials with new properties resulting from the inclusion of growth factors and in research on their biological activity.
RESUMEN
Hybrid porous polymers based on poly-EGDMA and polylactide containing vancomycin, the concentration of which in the polymer varied by two orders of magnitude, were synthesized. The processes of polymer biodegradation and vancomycin release were studied in the following model media: phosphate-buffered saline (PBS), trypsin-Versene solution, and trypsin-PBS solution. The maximum antibiotic release was recorded during the first 3 h of extraction. The duration of antibiotic escape from the polymer samples in trypsin-containing media varied from 3 to 22 days, depending on the antibiotic content of the polymer. Keeping samples of the hybrid polymer in trypsin-containing model media resulted in acidification of the solutions-after 45 days, up to a pH of 1.84 in the trypsin-Versene solution and up to pH 1.65 in the trypsin-PBS solution. Here, the time dependences of the vancomycin release from the polymer into the medium and the decrease in pH of the medium correlated. These data are also consistent with the results of a study of the dynamics of sample weight loss during extraction in the examined model media. However, while the polymer porosity increased from ~53 to ~60% the pore size changed insignificantly, over only 10 µm. The polymer samples were characterized by their antibacterial activity against Staphylococcus aureus, and this activity persisted for up to 21 days during biodegradation of the material, regardless of the medium type used in model. Surface-dependent human cells (dermal fibroblasts) adhere well, spread out, and maintain high viability on samples of the functionalized hybrid polymer, thus demonstrating its biocompatibility in vitro.
RESUMEN
Cell therapy is actively used to treat skin defects, particularly burn lesions. The effectiveness of its application may depend on the appropriate choice of wound dressings used together with any cellular material. The aim of the study was to investigate the interaction of 4 hydrogel dressings used in clinical practice with human cells in an in vitro model to determine if their use in combination with cell therapy is possible. The effect of the dressings on the growth medium was assessed by considering the changes caused in the medium's acid-base equilibrium (pH) and viscosity. Cytotoxicity was determined by applying an MTT-assay and by direct contact methods. Cell adhesion and viability on the dressing surfaces were analyzed using fluorescence microscopy. Proliferative and secretory cell activity were determined concurrently. Characterized human dermal fibroblast cultures were used as the test cultures. Results: The tested dressings interacted differently with the growth medium and the test cultures. 1-day extracts of all dressings had almost no effect on the acid-base balance, but, after 7 days, the pH of the dressing Type 2 extract had sharply acidified. The viscosity of the media under the influence of dressings of Types 2 and 3 had also markedly increased. MTT-assays showed nontoxicity of all the 1-day-incubated dressing extracts, while incubation for 7-days resulted in extracts with evident cytotoxicity, which was reduced upon dilution. Cell adhesion to the surfaces of the dressings differed, being observed occurring on dressings 2 and 3, and to a limited extent on dressing 4. Cells under dressing 1 showed evident proliferative and secretory activity whereas the other dressings impaired either proliferation or secretion processes. These effects indicate that, in general, comprehensive studies including a variety of methodological approaches at the in vitro stage are needed to allow the selection of appropriate dressings if they are to be used in combination with cell therapy to act as cell carriers. Of those investigated, the Type 1 dressing can be recommended as a protective dressing for use after transplantation of cells into a wound defect area by some other method.
RESUMEN
A study is presented on four polymers of the polyurethane family, obtained using a two-stage process. The first composition is the basic polymer; the others differ from it by the presence of a variety of fillers, introduced to provide radiopacity. The fillers used were 15% bismuth oxide (Composition 2), 15% tantalum pentoxide (Composition 3), or 15% zirconium oxide (Composition 4). Using a test culture of human fibroblasts enabled the level of cytotoxicity of the compositions to be determined by MTT (3-[4,5-dimethylthiazol-2-yl]-2,5 diphenyl tetrazolium bromide) assay, along with variations in the characteristics of the cells resulting from their culture directly on the specimens. The condition of cells on the surfaces of the specimens was assessed using fluorescence microscopy. It was shown that introducing 15% bismuth, tantalum, or zinc compounds as fillers produced a range of effects on the biological characteristics of the compositions. With the different fillers, the levels of toxicity differed and the cells' proliferative activity or adhesion was affected. However, in general, all the studied compositions may be considered cytocompatible in respect of their biological characteristics and are promising for further development as bases for bone-substituting materials. The results obtained also open up prospects for further investigations of polyurethane compounds.
RESUMEN
Polymerization of methyl methacrylate (MMA) in aqueous collagen (Col) dispersion was studied in the presence of tributylborane (TBB) and p-quinone: 2,5-di-tert-butyl-p-benzoquinone (2,5-DTBQ), p-benzoquinone (BQ), duroquinone (DQ), and p-naphthoquinone (NQ). It was found that this system leads to the formation of a grafted cross-linked copolymer. The inhibitory effect of p-quinone determines the amount of unreacted monomer, homopolymer, and percentage of grafted poly(methyl methacrylate) (PMMA). The synthesis combines two approaches to form a grafted copolymer with a cross-linked structure-"grafting to" and "grafting from". The resulting products exhibit biodegradation under the action of enzymes, do not have toxicity, and demonstrate a stimulating effect on cell growth. At the same time, the denaturation of collagen occurring at elevated temperatures does not impair the characteristics of copolymers. These results allow us to present the research as a scaffold chemical model. Comparison of the properties of the obtained copolymers helps to determine the optimal method for the synthesis of scaffold precursors-synthesis of a collagen and poly(methyl methacrylate) copolymer at 60 °C in a 1% acetic acid dispersion of fish collagen with a mass ratio of the components collagen:MMA:TBB:2,5-DTBQ equal to 1:1:0.015:0.25.
RESUMEN
Collagen is a suitable material for regenerative medicine because it is characterized by its good biocompatibility. However, due to its fibrillar structure, it cannot organize itself into three-dimensional porous structures without additional modification. The introduction of synthetic monomer elements into the collagen macromolecules is a technique used to form three-dimensional, collagen-based, branched, and crosslinked structures. New types of graft copolymers made from cod collagen with a butyl acrylate and vinyl butyl ether copolymer in aqueous dispersion were obtained in the presence of triethylborane by a radical mechanism. The process of graft copolymer formation proceeded as usual by radical initiation, through radicals formed during triethylborane oxidation by oxygen residues, collagen borination, and reversible inhibition with the participation of a boroxyl radical. The characteristics of the graft copolymers were determined using methods of physical and chemical analysis (GPC, SEM, IR spectroscopy, etc.), while the cytotoxicity was assessed using the MTT assay method. It is shown that the grafting of alternating blocks of butyl acrylate and vinyl butyl ether to the protein macromolecules results in changes in the morphological pattern of the graft co-polymer in comparison with native collagen. This is manifested in the development of consolidations around the collagen fibers of the structural matrices, with the co-polymer cellular structure consisting of interpenetrating pores of unequal size. Additionally, it is important that the graft co-polymer solutions are not toxic at a certain concentration. The above properties confirm the promising nature of the technique's application as the basis for producing new materials for regenerative medicine.
RESUMEN
One of the key and actively developing areas of regenerative medicine is tissue-engineering. There is no doubt that the use of tissue-engineering products can have a significant impact on the efficiency of repair of damaged tissues and organs. However, before being used in clinical practice, tissue-engineering products require thorough preclinical studies to confirm their safety and efficacy, both with in vitro models and in experimental animals. This paper presents preclinical studies of a tissue-engineered construct, based on a hydrogel biopolymer scaffold carrier (consisting of blood plasma cryoprecipitate and collagen) with encapsulated mesenchymal stem cells, to evaluate its biocompatibility in vivo. The results were analyzed using histomorphology and transmission electron microscopy. It was shown that when implanted into animal (rat) tissues, the implants were completely replaced by connective tissue components. We also confirmed that no acute inflammation occurred in response to the scaffold implantation. The observed processes of cell recruitment to the scaffold from the surrounding tissues, the active formation of collagen fibers and the absence of acute inflammation testified that the regeneration process was ongoing in the implantation area. Thus, the presented tissue-engineered construct shows promise for becoming an effective tool for regenerative medicine in the future and may be used, in particular, to repair soft tissues.
RESUMEN
Graft copolymers of collagen and polyacrylamide (PAA) were synthesized in a suspension of acetic acid dispersion of fish collagen and acrylamide (AA) in the presence of tributylborane (TBB). The characteristics of the copolymers were determined using infrared spectroscopy and gel permeation chromatography (GPC). Differences in synthesis temperature between 25 and 60 °C had no significant effect on either proportion of graft polyacrylamide generated or its molecular weight. However, photomicrographs taken with the aid of a scanning electron microscope showed a breakdown of the fibrillar structure of the collagen within the copolymer at synthesis temperatures greater than 25 °C. The mechanical properties of the films and the cytotoxicity of the obtained copolymer samples were studied. The sample of a hybrid copolymer of collagen and PAA obtained at 60 °C has stronger mechanical properties compared to other tested samples. Its low cytotoxicity, when the monomer is removed, makes materials based on it promising in scaffold technologies.