Plasmodium falciparum maturation across the intra-erythrocytic cycle shifts the soft glassy viscoelastic properties of red blood cells from a liquid-like towards a solid-like behavior.

The mechanical properties of erythrocytes have been investigated by different techniques. However, there are few reports on how the viscoelasticity of these cells varies during malaria disease. Here, we quantitatively map the viscoelastic properties of Plasmodium falciparum-parasitized human erythrocytes. We apply new methodologies based on optical tweezers to measure the viscoelastic properties and defocusing microscopy to measure the erythrocyte height profile, the overall cell volume, and its form factor, a crucial parameter to convert the complex elastic constant into complex shear modulus. The storage and loss shear moduli are obtained for each stage of parasite maturation inside red blood cells, while the former increase, the latter decrease. Employing a soft glassy rheology model, we obtain the power-law exponent for the storage and loss shear moduli, characterizing the soft glassy features of red blood cells in each parasite maturation stage. Ring forms present a liquid-like behavior, with a slightly lower power-law exponent than healthy erythrocytes, whereas trophozoite and schizont stages exhibit increasingly solid-like behaviors. Finally, the surface elastic shear moduli, low-frequency surface viscosities, and shape recovery relaxation times all increase not only in a stage-dependent manner but also when compared to healthy red blood cells. Overall, the results call attention to the soft glassy characteristics of Plasmodium falciparum-parasitized erythrocyte membrane and may provide a basis for future studies to better understand malaria disease from a mechanobiological perspective.

Quantitative Analysis of Viscoelastic Properties of Red Blood Cells using Optical Tweezers and Defocusing Microscopy.

The viscoelastic properties of erythrocytes have been investigated by a range of techniques. However, the reported experimental data vary. This is not only attributed to the normal variability of cells, but also to the differences in methods and models of cell response. Here, an integrated protocol using optical tweezers and defocusing microscopy is employed to obtain the rheological features of red blood cells in the frequency range of 1 Hz to 35 Hz. While optical tweezers are utilized to measure the erythrocyte-complex elastic constant, defocusing microscopy is able to obtain the cell height profile, volume, and its form factor a parameter that allows conversion of complex elastic constant into complex shear modulus. Moreover, applying a soft glassy rheology model, the scaling exponent for both moduli can be obtained. The developed methodology allows to explore the mechanical behavior of red blood cells, characterizing their viscoelastic parameters, obtained under well-defined experimental conditions, for several physiological and pathological conditions.

Effect of cell geometry in the evaluation of erythrocyte viscoelastic properties.

The red blood cell membrane-cytoskeleton is a complex structure mainly responsible for giving the cell rigidity and shape. It also provides the erythrocyte with the ability to pass through narrow capillaries of the vertebrate blood circulatory system. Although the red blood cell viscoelastic properties have been extensively studied, reported experimental data differ by up to three orders of magnitude. This could be attributed to the natural cell variability, to the different techniques employed, and also to the models used for the cell response, which are highly dependent on cell geometry. Here, we use two methodologies based on optical tweezers to investigate the viscoelastic behavior of healthy human red blood cells, one applying small cell deformations (microrheology) and another imposing large deformations (tether extraction). We also establish a defocusing microscopy-based method to characterize the cell geometry and thus the erythrocyte form factor, an essential parameter that allows comparisons among the viscoelastic properties at different conditions. Moreover, for small deformations, a soft glassy rheology model is used to discuss the results, while for large deformations two surface shear moduli and one surface viscosity are determined, together with the surface tension and bending modulus of the erythrocyte membrane lipid component. We also show that F-actin is not detected in tethers, although the erythrocyte membrane has physical properties like those of other adherent cells, known to have tethers containing F-actin inside. Altogether, our results show good agreement with the reported literature and we argue that, to properly compare the viscoelastic properties of red blood cells in different situations, the task of cell geometry characterization must be accomplished. This may be especially important when the influence of agents, like the malaria parasite, induces changes in both the geometry and chemical constituents of the erythrocyte membrane. Together, the new methodologies and procedures used in this study would allow the erythrocyte community to better explore the mechanical behavior of red blood cells and may be useful to characterize erythrocyte viscoelasticity changes in several blood diseases.

The mechanical properties of microbial surfaces and biofilms.

Microbes can modify their surface structure as an adaptive mechanism for survival and dissemination in the environment or inside the host. Altering their ability to respond to mechanical stimuli is part of this adaptive process. Since the 1990s, powerful micromanipulation tools have been developed that allow mechanical studies of microbial cell surfaces, exploring little known aspects of their dynamic behavior. This review concentrates on the study of mechanical and rheological properties of bacteria and fungi, focusing on their cell surface dynamics and biofilm formation.